Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jared Suchan has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Spatial Variability during Shrinkage Testing of Expansive Clays

    by Rajeevkaran Paranthaman, Jared Suchan, Shahid Azam

    Civil infrastructure constructed with, buried in, or underlain by expansive clays is affected by high volumetric changes, especially because large-scale facilities are spatially distributed. This research focused on determining spatial variability during the shrinkage testing of expansive clays. An initially saturated sample (600 mm in diameter) of a high-plasticity clay was exposed to desiccation and thoroughly monitored over five months. The results indicated an expansive clay (30% smectite and 14% illite) in alkaline-pore water (695 mg/L Na+ and 1150 mg/L SO42−) for developing a dispersive soil fabric. The vertical shrinkage in the intact-soil portion was unchanged (remaining at 114 × 106 mm3) in the first 10 days, sharply decreased the initial volume by 30% (up to 280 mm or 80 × 106 mm3) in 68 days, and slowly decreased the initial volume by 40% (up to 240 mm or 68 × 106 mm3) in 145 days. Furthermore, the soil temperature was found to be 10% lower than the air temperature, whereas the relative humidity within the cell was found to be 30% higher than that outside the cell. The soil showed an initial prominent central ridge with a few cracks that gradually evolved into a distinct crack pattern with equal-sized and irregular soil chunks. The average soil surface showed no volume reduction up to 18 days and a subsequent linear reduction, reaching 25% of the initial soil volume by the end of the test.


  • Open Access

    Determination of Soil Behavior during Evaporation Using Geotechnical Datasets

    by Jared Suchan, Shahid Azam

    Evaporation from soils is critical for agricultural water management. This requires a clear understanding of the water retention and soil shrinkage behavior of soils during water escape and due to fertilizers usage. Based on laboratory testing, this paper provides a comprehensive dataset generated for the determination of the geotechnical properties of inert silty sand and active lean clay using distilled water and saline pore fluid under ambient conditions. The tests include fluid-independent general soil properties, fluid-dependent specific soil properties, low-demand evaporation as a baseline, and high-demand evaporation to capture summer.


  • Open Access

    Influence of Saline Pore Fluid on Soil Behavior during Evaporation

    by Jared Suchan, Shahid Azam

    Saline conditions govern soil behavior during evaporation, thereby affecting the water budget in semi-arid regions. This research examined the effects of saline pore fluid on soil behavior during evaporation. The results indicated volumetric reductions of about 5% for silty sand and about 15% for lean clay. The evaporative flux for silty sand decreased from 26 mg/m2∙s to 22 mg/m2∙s in StageII, remained at a constant flux in StageIII, and decreased to 13 mg/m2∙s in StageIV. The air entry and residual suction values were found to be 5 kPa and 100 kPa, respectively, and the total suction of about 5000 kPa merged with matric suction near the Stage II/Stage III boundary. The swell–shrink curve (SSC) was J-shaped with the only void ratio decrease in Stage II. In contrast, the evaporative flux for lean clay decreased from 30 mg/m2∙s to 15 mg/m2∙s in StageII, to 10 mg/m2∙s in StageIII, and then to 5 mg/m2∙s in StageIV. The air entry and residual suction values were 5 kPa and 2000 kPa, respectively, and the total suction during Stage II and Stage III ranged from 1000 kPa to 6000 kPa, with an average value of 3500 kPa. The SSC showed a major void ratio decrease in Stage II, marginal decrease in Stage III, and no decrease in Stage IV. Under high demand, the evaporative flux for silty sand was constant at 180 mg/m2∙s in StageIII and decreased to 50 mg/m2∙s in Stage IV, whereas it decreased for the lean clay from 230 mg/m2∙s to 145 mg/m2∙s in StageII, to 95 mg/m2∙s in StageIII, and then to 25 mg/m2∙s in StageIV. For both soils, the total water loss was found to be six times higher than that under low demand.


  • Open Access

    Influence of Desaturation and Shrinkage on Evaporative Flux from Soils

    by Jared Suchan, Shahid Azam

    An assessment of evaporation losses from soils is critical for sustainable agriculture in semi-arid regions. The purpose of this research was to determine the effect of desaturation and shrinkage on evaporative flux from representative soils. Results indicated that the surface area did not change for silty sand (6% volume reduction) and substantially increased for lean clay (17% volume reduction). The evaporative flux for silty sand decreased from 31 to 25 mg/m2∙s in Stage II, remained constant during Stage III, and decreased to 11 mg/m2∙s in Stage IV. In contrast, the lean clay showed a longer Stage II (34 to 14 mg/m2∙s), a near constant Stage III, albeit a similar Stage IV (13 to 3 mg/m2∙s). The air entry and residual suction values were 1 kPa and 100 kPa for silty sand and 5 kPa and 1400 kPa for lean clay. In both soils, the total suction merged with the matric suction at Stage II–Stage III boundary. Furthermore, the shrinkage curve was J-shaped for silty sand with the only void ratio decrease in Stage II, whereas that for the lean clay showed a significant void ratio decrease in Stage II, marginal decrease in Stage III, and no decrease in Stage IV. Under high demand, the silty sand exhibited Stage III and Stage IV evaporation, whereas the lean clay also showed significant flux during Stage II. For the investigated range of water content, the total water loss under high demand was found to be 7 times that under low demand.


  • Open Access

    Datasets for the Determination of Evaporative Flux from Distilled Water and Saturated Brine Using Bench-Scale Atmospheric Simulators

    by Jared Suchan, Shahid Azam

    Evaporation from fresh water and saline water is critical for the estimation of water budget in the Canadian Prairies. Predictive models using empirical field-based data are subject to significant errors and uncertainty. Therefore, highly controlled test conditions and accurately measured experimental data are required to understand the relationship between atmospheric variables at water surfaces. This paper provides a comprehensive dataset generated for the determination of evaporative flux from distilled water and saturated brine using the bench-scale atmospheric simulator (BAS) and the subsequently improved design (BAS2). Analyses of the weather scenarios from atmospheric parameters and evaporative flux from the experimental data are provided.


  • Open Access

    Effect of Salinity on Evaporation from Water Surface in Bench-Scale Testing

    by Jared Suchan, Shahid Azam

    Freshwater and hypersaline lakes in arid and semi-arid environments are crucial from agricultural, industrial, and ecological perspectives. The purpose of this paper was to investigate the effect of salinity on evaporation from water surfaces. The main achievement of this research is the successful capture of simulated climate–surface interactions prevalent in the Canadian Prairies using a custom-built bench-scale atmospheric simulator. Test results indicated that the evaporative flux has a large variation during spring (water/brine: 1452/764 10−4 g·s−1·m−2 and 613/230 × 10−4 g·s−1·m−2 night) and summer (1856/1187 × 10−4 g·s−1·m−2 day and 1059/394 × 10−4g·s−1·m−2 night), and small variation in the fall (1591/915 × 10−4 g·s−1·m−2 and 1790/1048 × 10−4 g·s−1·m−2 night). The primary theoretical contribution of this research is that the evaporation rate from distilled water is twice that of saturated brine. The measured data for water correlated well with mathematical estimates; data scatter was evenly distributed and within one standard deviation of the equality line, whereas the brine data mostly plotted above the equality line. The newly developed 2:1 water–brine correlation for evaporation was found to follow the combination equations with the Monteith model best matching the measurements.


  • Open Access

    Development of BAS2 for determination of evaporative fluxes

    by Jared Suchan, Shahid Azam


  • Open Access

    Determination of Evaporative Fluxes Using a Bench-Scale Atmosphere Simulator

    by Jared Suchan, Shahid Azam

    An accurate determination of evaporative fluxes is critical for efficient water management in semi-arid climates such as in the Canadian Prairies. The main achievements of this research are the design and operation of a bench-scale atmosphere simulator, performance evaluation using selected weather scenarios pertaining to regional atmospheric conditions, validation using established empirical correlations, and estimation of evaporation rates and the amount for a typical local water body. Results indicate that the measured data achieved the target values for the various parameters and the data were found to be stable during the 3-h test duration. The vapour flux was found to have large variation during summer (0.120 g∙s−1∙m−2 during the day and 0.047 g∙s−1∙m−2 at night), low variation during spring (0.116 g∙s−1∙m−2 during the day and 0.062 g∙s−1∙m−2 at night), and negligible change during fall (0.100 g∙s−1∙m−2 during the day and 0.076 g∙s−1∙m−2 at night). The measured vapour flux was generally within one standard deviation of the equality line when compared with that predicted by both the mass-transfer equations and the combination equations. The average evaporation ranged from 4 mm∙d−1 to 8 mm∙d−1 during the day and decreased to 1 mm∙d−1 to 3 mm∙d−1 at night. The 24-h evaporation was found to be 8 ± 1 mm∙d−1 from late April through late October. Likewise, the cumulative annual evaporation was found to be 1781 mm, of which 82% occurs during the day and 18% at night.