JBJulien Bonvalet

Julien Bonvalet

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Julien Bonvalet has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Top Cited Papers
    Open Access

    In-Target Proton–Boron Nuclear Fusion Using a PW-Class Laser

    by Daniele Margarone, Julien Bonvalet, Lorenzo Giuffrida, Alessio Morace, Vasiliki Kantarelou, Marco Tosca, Didier Raffestin, Philippe Nicolai, Antonino Picciotto, Yuki Abe, et al.

    Nuclear reactions between protons and boron-11 nuclei (p–B fusion) that were used to yield energetic α-particles were initiated in a plasma that was generated by the interaction between a PW-class laser operating at relativistic intensities (~3 × 1019 W/cm2) and a 0.2-mm thick boron nitride (BN) target. A high p–B fusion reaction rate and hence, a large α-particle flux was generated and measured, thanks to a proton stream accelerated at the target’s front surface. This was the first proof of principle experiment to demonstrate the efficient generation of α-particles (~1010/sr) through p–B fusion reactions using a PW-class laser in the “in-target” geometry.


  • Laser-driven collisionless shock acceleration of protons from gas jets tailored by one or two nanosecond beams

    by J. Bonvalet, P. Loiseau, J.-R. Marquès, E. Atukpor, E. D'HUmières, J. Domange, P. Forestier-Colleoni, F. Hannachi, L. Lancia, D. Raffestin, et al.

    It was proposed recently that laser-ion acceleration in gas jets may be significantly improved if each side of a gas jet target is tailored by an auxiliary nanosecond laser pulse [Marquès et al., Phys. Plasmas 28, 023103 (2021)]. In the present study, the proton acceleration by electrostatic shock in these one- or two-side tailored plasmas is investigated using particle-in-cell simulations. It is demonstrated that the formation of a thin plasma layer with a steep density profile and a maximum density of the order of the critical density strongly improves the proton acceleration in the forward direction with a maximum ion energy of tens of MeV with mildly relativistic laser pulses. Proton acceleration up to tens of MeV is predicted using realistic plasma density profiles obtained from tailored gas jet targets compared to a few MeV reported in other publications.


  • Energetic α -particle sources produced through proton-boron reactions by high-energy high-intensity laser beams

    by J. Bonvalet, Ph. Nicolaï, D. Raffestin, E. D'Humieres, D. Batani, V. Tikhonchuk, V. Kantarelou, L. Giuffrida, M. Tosca, G. Korn, et al.

    In an experiment performed with a high-intensity and high-energy laser system, α-particle production in proton-boron reaction by using a laser-driven proton beam was measured. α particles were observed from the front and also from the rear side, even after a 2-mm-thick boron target. The data obtained in this experiment have been analyzed using a sequence of numerical simulations. The simulations clarify the mechanisms of α-particle production and transport through the boron targets. α-particle energies observed in the experiment and in the simulation reach 10–20 MeV through energy transfer from 20–30 MeV energy incident protons. Despite the lower cross sections for protons with energy above the sub-MeV resonances in the proton-boron reactions, 108–109α particles per steradian have been detected.


  • Open Access

    Over-critical sharp-gradient plasma slab produced by the collision of laser-induced blast-waves in a gas jet: Application to high-energy proton acceleration

    by J.-R. Marquès, P. Loiseau, J. Bonvalet, M. Tarisien, E. D'HUmières, J. Domange, F. Hannachi, L. Lancia, O. Larroche, P. Nicolaï, et al.

    Generating thin and high density plasma slabs at a high repetition rate is a key issue for ultra-high intensity laser applications, such as plasma photonics, electron acceleration by few laser-cycle pulses, or collisionless shock acceleration of protons to high energies. In this paper, we present a scheme to generate such plasma slabs. It is based on the propagation and collision in a gas jet of two counter-propagating blast waves (BWs). Each BW is launched by a sudden and local heating induced by a nanosecond laser beam that propagates along the side of the jet. The resulting cylindrical BW expands perpendicular to the beam. The shock front, which is bent by the gas jet density gradient, pushes and compresses the plasma toward the jet center. By using two parallel ns laser beams, one on each side of the gas jet, this scheme enables us to tailor independently two opposite sides of the jet, while avoiding the damage risks associated with counterpropagating laser beams. A parametric study is performed using two and three dimensional hydrodynamic (single fluid), as well as kinetic (Fokker–Planck), simulations. This study shows that the BW bending combined with the collision in a stagnation regime increases the density by more than ten times and generates a very thin (down to few micrometers), near to over-critical plasma slab with a high density contrast (>100) and a lifetime of a few hundred picoseconds. Two dimensional particle-in-cell simulations are, then, used to study the influence of the plasma tailoring on proton acceleration by a high-intensity sub-picosecond laser pulse. It is shown that tailoring the plasma, not only at the entrance but also at the exit side of the picosecond-pulse, enhances the proton beam collimation and increases significantly the number of high energy protons, and their maximum energy.