LFLorenzo Fratino

Lorenzo Fratino

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lorenzo Fratino has a total of 74 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Disorder-driven stochastic dynamics in Mott resistive-switching systems

    by David J. Alspaugh, Lorenzo Fratino, Nareg Ghazikhanian, Ivan K. Schuller, Marcelo Rozenberg

    Controlled disorder in correlated materials provides a new route to emergent stochastic dynamics in neuromorphic hardware. Here we show that focused ion beam irradiation in ${\text{VO}}_{2}$- and ${\mathrm{V}}_{2}{\mathrm{O}}_{3}$-based resistive-switching oscillators induces a transition from regular periodic oscillations to strongly irregular stochastic firing, while simultaneously reducing the required switching energy by orders of magnitude. Under an applied electric field, these materials undergo a volatile insulator-to-metal transition characterized by the formation of percolating metallic filaments within an insulating bulk. Using numerical simulations based on the Mott resistor network, we demonstrate that defect-induced modifications to filament nucleation and stability drive these devices into stochastic oscillatory regimes. These results are validated by experimental measurements on irradiated ${\text{VO}}_{2}$ and ${\mathrm{V}}_{2}{\mathrm{O}}_{3}$ devices.


  • Open Access

    Enhanced Stochasticity in Irradiated Vanadium Oxide Oscillators

    by Nareg Ghazikhanian, David J. Alspaugh, Pavel Salev, Lorenzo Fratino, Marcelo Rozenberg, Ivan K. Schuller

    Insulator‐to‐metal transition (IMT) materials are highly sensitive to even minute deviations of stoichiometry, lattice defects, and disorder, which provides opportunities to engineer their electrical switching characteristics. Using vanadium oxide as a prototypical IMT resistive switching material, we demonstrate that focused ion beam irradiation induces stochastic oscillatory dynamics in simple two‐terminal switching devices. After irradiation, we observed an unusual dynamic regime where the voltage‐induced metallic state momentarily collapses into an insulating state, which results in rapid current flickering that is qualitatively different from the conventional current spiking in a Pearson‐Anson‐type oscillatory circuit implemented using the pristine material. Furthermore, the current flickering timing in the irradiated devices becomes progressively more random and sparser with increasing input voltage, resulting in nonlinear and nondeterministic oscillatory behavior. The irradiation also leads to a dramatic reduction in switching power required to induce the oscillations. These results are elucidated through random resistor network simulations, which indicate that a small number of local sites can control the electrical IMT switching properties in large devices with high defect concentration. Our results show that selective focused ion beam irradiation provides exciting prospects for engineering novel stochastic behaviors in emergent technologies that rely on intrinsic randomness of physical processes.


  • Laser-induced quenching of metastability at the Mott insulator to metal transition

    by Theodor Luibrand, Lorenzo Fratino, Farnaz Tahouni-Bonab, Amihai Kronman, Yoav Kalcheim, Ivan K. Schuller, Marcelo Rozenberg, Reinhold Kleiner, Dieter Koelle, Stefan Guénon


  • Magnetoresistance anomaly during the electrical triggering of a metal-insulator transition

    by Pavel Salev, Lorenzo Fratino, Dayne Sasaki, Soumen Bag, Yayoi Takamura, Marcelo Rozenberg, Ivan K. Schuller

    Phase separation naturally occurs in a variety of magnetic materials and it often has a major impact on both electric and magnetotransport properties. In resistive switching systems, phase separation can be created on demand by inducing local switching, which provides an opportunity to tune the electronic and magnetic state of the device by applying voltage. Here we explore the magnetotransport properties in the ferromagnetic oxide La0.7Sr0.3MnO3 (LSMO) during the electrical triggering of an intrinsic metal-insulator transition (MIT), which produces volatile resistive switching. This switching occurs in a characteristic spatial pattern, i.e., the formation of a high-resistance barrier perpendicular to the current flow, enabling an electrically actuated ferromagnetic-paramagnetic-ferromagnetic phase separation. At the threshold voltage of the MIT triggering, both anisotropic and colossal magnetoresistances exhibit anomalies including a large increase in magnitude and a sign flip. Computational analysis revealed that these anomalies originate from the coupling between the switching-induced phase separation state and the intrinsic magnetoresistance of LSMO. This work demonstrates that driving the MIT material into an out-of-equilibrium resistive switching state provides the means for electrical control of the magnetotransport phenomena.


  • Light-Induced Decoupling of Electronic and Magnetic Properties in Manganites

    by H. Navarro, Ali C. Basaran, F. Ajejas, L. Fratino, S. Bag, T.D. Wang, E. Qiu, V. Rouco, I. Tenreiro, F. Torres, et al.

    The strongly correlated material La0.7Sr0.3MnO3 (LSMO) exhibits metal-to-insulator and magnetic transition near room temperature. Although the physical properties of LSMO can be manipulated by strain, chemical doping, temperature, or magnetic field, they often require large external stimuli. To include additional flexibility and tunability, we developed a hybrid optoelectronic heterostructure that uses photocarrier injection from cadmium sulfide (CdS) to an LSMO layer to change its electrical conductivity. LSMO exhibits no significant optical response; however, the CdS/LSMO heterostructures show an enhanced conductivity, with a resistance drop of about 37%, at the transition temperature under light stimuli. This enhanced conductivity in response to light is comparable to the effect of a 9 T magnetic field in pure LSMO. Surprisingly, the optical and magnetic responses of CdS/LSMO heterostructures are decoupled and exhibit different effects when both stimuli are applied. This unexpected behavior shows that heterostructuring strongly correlated oxides may require a new understanding of the coupling of physical properties across the transitions and provide the means to implement new functionalities.


  • Open Access

    Stochasticity in the synchronization of strongly coupled spiking oscillators

    by Erbin Qiu, Pavel Salev, Lorenzo Fratino, Rodolfo Rocco, Henry Navarro, Coline Adda, Junjie Li, Min-Han Lee, Yoav Kalcheim, Marcelo Rozenberg, et al.

    Synchronization of electrical oscillators is a crucial step toward practical implementation of oscillator-based and bio-inspired computing. Here, we report the emergence of an unusual stochastic pattern in coupled spiking Mott nanodevices. Although a moderate capacitive coupling results in a deterministic alternating spiking, increasing the coupling strength leads counterintuitively to stochastic disruptions of the alternating spiking sequence. The disruptions of the deterministic spiking sequence are a direct consequence of the small intrinsic stochasticity in electrical triggering of the insulator–metal transition. Although the stochasticity is subtle in individual nanodevices, it becomes dramatically enhanced just in a single pair of coupled oscillators and, thus, dominates the synchronization. This is different from the stochasticity and multimodal coupling, appearing due to collective effects in large oscillator networks. The stochastic spiking pattern in Mott nanodevices results in a discrete inter-spike interval distribution resembling those in biological neurons. Our results advance the understanding of the emergent synchronization properties in spiking oscillators and provide a platform for hardware-level implementation of probabilistic computing and biologically plausible electronic devices.


  • Open Access

    Characteristic length scales of the electrically induced insulator-to-metal transition

    by Theodor Luibrand, Adrien Bercher, Rodolfo Rocco, Farnaz Tahouni-Bonab, Lucia Varbaro, Carl Willem Rischau, Claribel Domínguez, Yixi Zhou, Weiwei Luo, Soumen Bag, et al.

    Some correlated materials display an insulator-to-metal transition as the temperature is increased. In most cases, this transition can also be induced electrically, resulting in volatile resistive switching due to the formation of a conducting filament. While this phenomenon has attracted much attention due to potential applications, many fundamental questions remain unaddressed. One of them is its characteristic lengths: What sets the size of these filaments, and how does this impact resistive switching properties? Here, we use a combination of wide-field and scattering-type scanning near-field optical microscopies to characterize filament formation in NdNiO3 and SmNiO3 thin films. We find a clear trend: Smaller filaments increase the current density, yielding sharper switching and a larger resistive drop. With the aid of numerical simulations, we discuss the parameters controlling the filament width and, hence, the switching properties.


  • Doping-driven resistive collapse of the Mott insulator in a minimal model for VO2

    by L. Fratino, S. Bag, A. Camjayi, M. Civelli, M. Rozenberg

    We study the resistive collapse of the Mott insulator state in the dimer Hubbard model. This minimal model has been used to describe the physics of VO2, and should be relevant to other strongly correlated materials. It incorporates the physics of correlated dimers and the explicit competition between on-site Coulomb repulsion and magnetic exchange interactions. Our results unveil that between the Mott insulator at half filling and the Fermi liquid metal at high doping there is an intermediate bad metallic phase with exotic features such as a pseudogap, orbital selectivity, and a first-order metal-metal transition. The model is solved within dynamical mean field theory by means of quantum Monte Carlo, which provides the numerically exact solution of the model in the limit of large lattice dimensionality. This model can be considered as a minimal one that captures exotic phenomena associated to the physics of a doped Mott insulator, shading light on their basic physical mechanism.


  • Open Access

    Transverse barrier formation by electrical triggering of a metal-to-insulator transition

    by Pavel Salev, Lorenzo Fratino, Dayne Sasaki, Rani Berkoun, Javier del Valle, Yoav Kalcheim, Yayoi Takamura, Marcelo Rozenberg, Ivan K. Schuller

    Application of an electric stimulus to a material with a metal-insulator transition can trigger a large resistance change. Resistive switching from an insulating into a metallic phase, which typically occurs by the formation of a conducting filament parallel to the current flow, is a highly active research topic. Using the magneto-optical Kerr imaging, we found that the opposite type of resistive switching, from a metal into an insulator, occurs in a reciprocal characteristic spatial pattern: the formation of an insulating barrier perpendicular to the driving current. This barrier formation leads to an unusual N-type negative differential resistance in the current-voltage characteristics. We further demonstrate that electrically inducing a transverse barrier enables a unique approach to voltage-controlled magnetism. By triggering the metal-to-insulator resistive switching in a magnetic material, local on/off control of ferromagnetism is achieved using a global voltage bias applied to the whole device.