Matheus Philippe Martins da Cruz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Matheus Philippe Martins da Cruz has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Elhadji Cheikh Talibouya Ba
Graduate Program in Mechanical Engineering, Universidade Federal de Uberlândia, Uberlândia, Brazil
1 shared publication - Marcello Rosa Dumont
Department of Materials Engineering Federal Center for Technological Education of Minas Gerais Belo Horizonte MG Brazil
1 shared publication - Paulo Sérgio Martins
Pontifícia Universidade Católica de Minas Gerais, Brasil
1 shared publication Ramon Martins Drumond
Centro Federal de Educação Tecnológica de Minas Gerais, Brasil
1 shared publication- Vitor Ferreira Vieira
Programa de Pós-Graduação Em Engenharia Mecânica, Federal Center for Technological Education of Minas Gerais, Belo Horizonte, Brazil
1 shared publication
Latest Publications
- Open Access
- 1 January 2021
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 24 (2)
Investigation of the effects of skewness Rsk and kurtosis Rku on tribological behavior in a pin-on-disc test of surfaces machined by conventional milling and turning processes
Friction and wear are influenced by the surface conditions of the material, since there is deformation, segregation, generation of oxide films, among others. Roughness is an important characteristic in tribological studies, where the parameters of skewness and kurtosis have greater influence than the conventional parameters Ra and Rq. This study is aimed to investigate the influence of the parameters of skewness Rsk and Rku kurtosis on the surface of the USI AR 360 steel machining by the milling and turning processes in the pin-on-disc sliding wear test. Results showed that surfaces with the same Ra and Rq could be distinguished by the skewness parameter. Different behaviors were observed in the analysis of friction curves, where the skewness effect showed a tendency to reduce the friction coefficient. It was also observed that the feed marks orientation in relation to the sliding direction can influence the tribological behavior of the surfaces.
- 1 January 2021
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 24 (2)
Open AccessInvestigation of the effects of skewness Rsk and kurtosis Rku on tribological behavior in a pin-on-disc test of surfaces machined by conventional milling and turning processes
Friction and wear are influenced by the surface conditions of the material, since there is deformation, segregation, generation of oxide films, among others. Roughness is an important characteristic in tribological studies, where the parameters of skewness and kurtosis have greater influence than the conventional parameters Ra and Rq. This study is aimed to investigate the influence of the parameters of skewness Rsk and Rku kurtosis on the surface of the USI AR 360 steel machining by the milling and turning processes in the pin-on-disc sliding wear test. Results showed that surfaces with the same Ra and Rq could be distinguished by the skewness parameter. Different behaviors were observed in the analysis of friction curves, where the skewness effect showed a tendency to reduce the friction coefficient. It was also observed that the feed marks orientation in relation to the sliding direction can influence the tribological behavior of the surfaces.