Chao-Qiang Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Chao-Qiang Wang has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
Xu-Dong Mei
Chongqing Fuling Shale Gas Environmental Protection Research and Development and Technical Service Center, Chongqing, China
5 shared publications- Deming Xiong
School of Electronics and Internet of Things, Chongqing College of Electronic Engineering, Chongqing, China
4 shared publications Pei-Xin Wang
CSCEC Strait Construction and Development Co., Ltd, Fuzhou, China
4 shared publicationsQi-Cong Huang
Chongqing Institute of Modern Construction Industry Development, Chongqing, China
4 shared publicationsYan Ying
4 shared publicationsYan-Yan Liu
School of Materials Science and Engineering, Chongqing Jiaotong University, Chongqing, China
4 shared publications
Latest Publications
- 12 November 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
Speciation Distribution, Valence Transformation, and Immobilization Mechanism of Cr during Portland Cement Hydration
Chromium (Cr) immobilization pathways in Portland cement may vary with cement-matrix characteristics. In this study, representative 32.5- and 42.5-grade cements (C3-3 and C4-2) were compared using controlled Cr(III)/Cr(VI) addition and multiscale characterization. XPS showed partial reduction of Cr(VI) to Cr(III) during hydration, while XAFS and 29Si NMR indicated Cr(III) association/incorporation with C-(A)-S-H-related structures. In C3-3-Cr, TEM, and SEM-EDS further revealed localized CaCr2O4 nanocrystals, indicating a combined structural association/incorporation–precipitation pathway. In C4-2-Cr, Cr was more diffusely distributed, and no resolvable Cr-bearing nanocrystals were observed in the examined TEM regions, indicating predominantly structural association/incorporation. These differences were associated with the higher hydration reactivity and more homogeneous C-S-H-rich microstructure of C4-2. The results demonstrate that cement-matrix hydration characteristics regulate the relative contributions of established Cr immobilization pathways, providing a mechanistic basis for the selection of cementitious matrices for Cr stabilization.
- 12 November 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
Speciation Distribution, Valence Transformation, and Immobilization Mechanism of Cr during Portland Cement Hydration
Chromium (Cr) immobilization pathways in Portland cement may vary with cement-matrix characteristics. In this study, representative 32.5- and 42.5-grade cements (C3-3 and C4-2) were compared using controlled Cr(III)/Cr(VI) addition and multiscale characterization. XPS showed partial reduction of Cr(VI) to Cr(III) during hydration, while XAFS and 29Si NMR indicated Cr(III) association/incorporation with C-(A)-S-H-related structures. In C3-3-Cr, TEM, and SEM-EDS further revealed localized CaCr2O4 nanocrystals, indicating a combined structural association/incorporation–precipitation pathway. In C4-2-Cr, Cr was more diffusely distributed, and no resolvable Cr-bearing nanocrystals were observed in the examined TEM regions, indicating predominantly structural association/incorporation. These differences were associated with the higher hydration reactivity and more homogeneous C-S-H-rich microstructure of C4-2. The results demonstrate that cement-matrix hydration characteristics regulate the relative contributions of established Cr immobilization pathways, providing a mechanistic basis for the selection of cementitious matrices for Cr stabilization.
- 3 June 2026
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 54 (6)
Slag Testing and Analysis: Heavy Metal Risk Assessment, Pozzolanic Activity, and Shrinkage Model Construction
Taking representative domestic slag powder (SP) as the object, properties such as heavy metal risk, volcanic ash activity, and dry shrinkage model construction were studied. The SP samples are mainly composed of three chemical components: silicon dioxide, aluminum oxide, and calcium oxide. Collectively, these three oxides constitute 85 % of the total chemical composition of the samples. Heavy metal risk assessment show that SP poses no direct risk to the external environment. However, considering that the measured values of Cr, Ni, and Pb are the highest and there is an accumulation effect, it is necessary to establish a complete environmental safety control system for heavy metals. Meanwhile, using three pozzolanic activity testing methods, the activity index of SP is measured to be 99 %–114 %, among which Henan and Hebei are the highest. On this basis, combined with the free calcium oxide content in slag powder, the shrinkage laws of slag powder mortar specimens at the ages of 4 d, 7 d and 14 d were further investigated. Moreover, the quadratic polynomial regression model can more accurately fit the nonlinear evolution trend of the shrinkage, and its coefficient of determination (R2) is better than that of linear regression, with the highest reaching 0.969. This research can provide a good basic technical support and reference for the domestic building materials industry.
- 3 June 2026
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 54 (6)
Slag Testing and Analysis: Heavy Metal Risk Assessment, Pozzolanic Activity, and Shrinkage Model Construction
Taking representative domestic slag powder (SP) as the object, properties such as heavy metal risk, volcanic ash activity, and dry shrinkage model construction were studied. The SP samples are mainly composed of three chemical components: silicon dioxide, aluminum oxide, and calcium oxide. Collectively, these three oxides constitute 85 % of the total chemical composition of the samples. Heavy metal risk assessment show that SP poses no direct risk to the external environment. However, considering that the measured values of Cr, Ni, and Pb are the highest and there is an accumulation effect, it is necessary to establish a complete environmental safety control system for heavy metals. Meanwhile, using three pozzolanic activity testing methods, the activity index of SP is measured to be 99 %–114 %, among which Henan and Hebei are the highest. On this basis, combined with the free calcium oxide content in slag powder, the shrinkage laws of slag powder mortar specimens at the ages of 4 d, 7 d and 14 d were further investigated. Moreover, the quadratic polynomial regression model can more accurately fit the nonlinear evolution trend of the shrinkage, and its coefficient of determination (R2) is better than that of linear regression, with the highest reaching 0.969. This research can provide a good basic technical support and reference for the domestic building materials industry.
- 12 May 2026
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 26 (4)
Alkali-activated phosphogypsum-slag binders for non-fired brick: performance and microstructural insights
- 12 May 2026
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 26 (4)
Alkali-activated phosphogypsum-slag binders for non-fired brick: performance and microstructural insights
- 26 January 2026
- Published by Springer Nature in Carbon Letters
- Vol. 36 (1) , 511-532
Machine learning model prediction of CO2 production and resource utilization of commercial concrete: curing utilization mechanism, carbon emission assessment and visualisation analysis
- 26 January 2026
- Published by Springer Nature in Carbon Letters
- Vol. 36 (1) , 511-532
Machine learning model prediction of CO2 production and resource utilization of commercial concrete: curing utilization mechanism, carbon emission assessment and visualisation analysis
- 10 July 2025
- Published by Springer Nature in Carbon Letters
- Vol. 35 (6) , 2665-2688
Machine learning-based carbon emission prediction and influence factor analysis discussion in China cement industry
- 10 July 2025
- Published by Springer Nature in Carbon Letters
- Vol. 35 (6) , 2665-2688
Machine learning-based carbon emission prediction and influence factor analysis discussion in China cement industry
- 18 June 2025
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 25 (4) , 1-29
Phosphogypsum composite cement-based permeable bricks: optimization of mix design, performance evaluation, and environmental impact
- 18 June 2025
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 25 (4) , 1-29
Phosphogypsum composite cement-based permeable bricks: optimization of mix design, performance evaluation, and environmental impact
- Open Access
- 1 February 2025
- Published by Elsevier in Case Studies in Construction Materials
- Vol. 22
Pozzolanic reaction, basic properties, carbon reduction and visualisation of kerbstone prepared from recycled concrete
- 1 February 2025
- Published by Elsevier in Case Studies in Construction Materials
- Vol. 22
Open AccessPozzolanic reaction, basic properties, carbon reduction and visualisation of kerbstone prepared from recycled concrete
- 6 November 2024
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 25 (1) , 1-25
LC50 fly ash microbead lightweight high-strength concrete: mix ratio design, stress mechanism, and life cycle assessment
- 6 November 2024
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 25 (1) , 1-25
LC50 fly ash microbead lightweight high-strength concrete: mix ratio design, stress mechanism, and life cycle assessment