XYXiaowei Yang

Xiaowei Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiaowei Yang has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • Li Zhang

    Southern Marine Science and Engineering Guangdong Laboratory (Zhanjiang)

    3 shared publications
  • Yanjun Liu

    Key Laboratory of High-Efficiency and Clean Mechanical Manufacture of Ministry of Education, National Demonstration Center for Experimental Mechanical Engineering Education, School of Mechanical Engineering, Shandong University, Jinan 250061, China

    3 shared publications
  • Yun Chen

    Institute of Marine Science and Technology, Shandong University, Qingdao 266237, China

    3 shared publications

Latest Publications

  • Open Access

    Optimization Design of the Organic Rankine Cycle for an Ocean Thermal Energy Conversion System

    by Xiaowei Yang, Yanjun Liu, Yun Chen, Li Zhang

    This study selects five parameters as decision variables for the optimization design of an ocean thermal energy conversion system, including the evaporating temperature, the condensing temperature, the pinch-point temperature difference between the evaporator and condenser, and the working fluid flow rate. The optimization goal is to maximize the net output power per unit area and the exergy efficiency. The final scheme is comprehensively screened out from the Pareto solution set through some evaluation indexes. Finally, this study also analyzes the effects of four decision variables on the optimization objectives and the evaluation indexes. This study finds that evaporating temperature and condensing temperature have similar effects on the two objective functions. However, the pinch-point temperature difference has different effects on them. The back work ratio is obviously affected by the condensing temperature. A small pinch-point temperature difference is beneficial and improves the performance of an ocean thermal energy conversion system. The effects of evaporating temperature and condensing temperature on the investment cost per unit net output power are roughly similar to those on the net output power per unit heat exchange area. However, the effects of the pinch-point temperature difference on the two performance aspects are inconsistent.


  • Open Access

    Operation Control and Performance Analysis of an Ocean Thermal Energy Conversion System Based on the Organic Rankine Cycle

    by Xiaowei Yang, Yanjun Liu, Yun Chen, Li Zhang

    The development and utilization of marine renewable energy is an important measure for achieving energy conservation, emissions reduction and carbon neutrality. Ocean thermal energy is the most stable energy among all the types of marine renewable energy. This paper built a simulation model of an ocean thermal energy conversion system based on actual device specifications by Aspen and MATLAB and put forward a corresponding control strategy. The opening control signal of the control valve at the turbine inlet was the condenser inlet pressure in this paper, and the frequency control of the working fluid pump depended on the evaporating pressure and flow rate of the working fluid. This paper analyzed the key operating parameter changes of the system under different working conditions. According to the analysis results, the turbogenerator in this system was able to generate 50 kW power for about 8 months per year. The highest net output power of the Organic Rankine Cycle was 47.3 kW; the highest cycle thermal efficiency was 3.2%.


  • Open Access

    Three-Dimensional Performance Analysis of a Radial-Inflow Turbine for Ocean Thermal Energy Conversion System

    by Yun Chen, Yanjun Liu, Li Zhang, Xiaowei Yang

    Turbine is one of the key components of the ocean thermal energy conversion system (OTEC), and its aerodynamic performance and geometric dimension affect the performance of the system directly. This paper proposes a design method for the radial inflow turbine suitable for the ocean thermal energy conversion based on the parameter optimization of the ocean thermal energy conversion system. Aiming at the application characteristics of marine thermal energy conversion in a small temperature difference environment and the special thermophysical properties of the organic working fluid in this environment, one-dimensional design and three-dimensional CFD analysis of the turbine is separately done, of which the results were compared. At the same time, the performance of the turbine was verified by changing the inlet and outlet conditions of the radial turbine under the design conditions. The conclusion is that the three-dimensional CFD results of the turbine are in good agreement with the one-dimensional design, and the internal flow field of the turbine is stable, without obvious backflow and eddy current, which meets the application requirements of the ocean thermal energy conversion.