Rogério Esteves Salustiano
Research Subjects
Research Interests
Rogério Esteves Salustiano has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Dagoberto Yukio Okada
Universidade Estadual de Campinas (UNICAMP)
1 shared publication - Eduardo Paniguel Oliveira
Institute of Science and Technology, Federal University of Alfenas (UNIFAL-MG), Poços de Caldas, Brazil
1 shared publication Guilherme M. F. Ferraz
HVEX, Itajubá, Brazil
1 shared publication- Laerty J. S. Damiao
Department of Electrical Engineering, Federal University of Ouro Preto, João Monlevade, Brazil
1 shared publication - Leonardo Henrique Soares Damasceno
Centro de Estudos e Aplicação de Materiais Para Remediação Ambiental (CEMARA), Instituto de Ciência e Tecnologia (ICT), Campus Avançado de Poços de Caldas, Universidade Federal de Alfenas (UNIFAL-MG), Poços de Caldas, Brazil
1 shared publication - Rafael Brito de Moura
Poços de Caldas, Federal University of Alfenas, Poços de Caldas, Brazil
1 shared publication
Latest Publications
- 28 October 2024
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 100
Development and calibration of a low-cost LIDAR sensor for water level measurements
- 28 October 2024
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 100
Development and calibration of a low-cost LIDAR sensor for water level measurements
- 11 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Assessment of the Insulation Conditions of Power Transformers Through Online Monitoring of Partial Discharges
The assessment of the insulation condition of a transformer is of great importance for the operational efficiency of the power system. However, as insulation systems are complex, many challenges are seen in terms of methods of analysis and measurement of critical parameters. In this context, this paper presents the application of an online monitoring system specially developed for the detection of partial discharges (PDs), which are recognized as a phenomenon that carries relevant information regarding the health of a transformer. The results were explored to show how the PD pattern and its correlation with gases dissolved in oil can be analyzed in practical situations with the equipment in service.
- 11 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Assessment of the Insulation Conditions of Power Transformers Through Online Monitoring of Partial Discharges
The assessment of the insulation condition of a transformer is of great importance for the operational efficiency of the power system. However, as insulation systems are complex, many challenges are seen in terms of methods of analysis and measurement of critical parameters. In this context, this paper presents the application of an online monitoring system specially developed for the detection of partial discharges (PDs), which are recognized as a phenomenon that carries relevant information regarding the health of a transformer. The results were explored to show how the PD pattern and its correlation with gases dissolved in oil can be analyzed in practical situations with the equipment in service.
- 4 March 2021
- Published by Taylor & Francis in Environmental Technology
- Vol. 43 (16) , 2540-2552
Optimization of airflow and aeration cycles in a new structured bed reactor configuration for carbon and nitrogen removal
The Structured Bed Reactor with Recirculation and Intermittent Aeration (SBRRIA) is a reactor configuration that presents high efficiency of organic matter and nitrogen removal, besides low sludge production. However, operational parameters, as the recirculation rate, aeration time, and airflow, are not fully established. A bench-scale structured bed reactor with intermittent aeration was fed with synthetic effluent simulating the characteristics of sanitary sewage. The reactor was operated for 280 days with an operational hydraulic retention time (HRT) of 10 h. The reactor was operated without effluent recirculation for the first time since this approach was not yet reported, and was named Structured Bed Reactor with Intermittent Aeration (SBRIA). The COD removal was higher than 81% for all operational conditions, and the total nitrogen removal ranged from 10 to 80%. The highest efficiencies were obtained with an aeration time of 1 h 45 min (total cycle of 3 h) and an airflow rate of 4.5 L.min−1. Different nitrification and denitrification behaviours were observed, resulting in nitrification efficiencies over 90% when the reactor was submitted to higher aeration times and denitrification efficiencies above 90% when the reactor was submitted to low aeration times. The airflow ranges tested in this study affected the nitrification and the total nitrogen efficiencies. Even without effluent recirculation, the temporal profile showed that there were no peaks in the concentration of the nitrogen forms in the reactor effluent, saving electrical energy up to 75% due to pumping. GRAPHICAL ABSTRACT
- 4 March 2021
- Published by Taylor & Francis in Environmental Technology
- Vol. 43 (16) , 2540-2552
Optimization of airflow and aeration cycles in a new structured bed reactor configuration for carbon and nitrogen removal
The Structured Bed Reactor with Recirculation and Intermittent Aeration (SBRRIA) is a reactor configuration that presents high efficiency of organic matter and nitrogen removal, besides low sludge production. However, operational parameters, as the recirculation rate, aeration time, and airflow, are not fully established. A bench-scale structured bed reactor with intermittent aeration was fed with synthetic effluent simulating the characteristics of sanitary sewage. The reactor was operated for 280 days with an operational hydraulic retention time (HRT) of 10 h. The reactor was operated without effluent recirculation for the first time since this approach was not yet reported, and was named Structured Bed Reactor with Intermittent Aeration (SBRIA). The COD removal was higher than 81% for all operational conditions, and the total nitrogen removal ranged from 10 to 80%. The highest efficiencies were obtained with an aeration time of 1 h 45 min (total cycle of 3 h) and an airflow rate of 4.5 L.min−1. Different nitrification and denitrification behaviours were observed, resulting in nitrification efficiencies over 90% when the reactor was submitted to higher aeration times and denitrification efficiencies above 90% when the reactor was submitted to low aeration times. The airflow ranges tested in this study affected the nitrification and the total nitrogen efficiencies. Even without effluent recirculation, the temporal profile showed that there were no peaks in the concentration of the nitrogen forms in the reactor effluent, saving electrical energy up to 75% due to pumping. GRAPHICAL ABSTRACT