XHXin Hong

Xin Hong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xin Hong has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Dalius Mažeika

    Department of Information Systems, Vilnius Gediminas Technical University, Sauletekio al. 11, LT-10223 Vilnius, Lithuania

    1 shared publication
  • Jianmin Qiu

    Precision Driving Laboratory, Nanjing University of Aeronautics and Astronautics, 29 YuDao street, Nanjing, China, Nanjing, 210016, CHINA

    1 shared publication
  • Piotr Vasiljev

    State Key Laboratory of Mechanics and Control of Mechanical Structures, College of Aerospace Engineering, Nanjing University of Aeronautics and Astronautics, 29 Yudao Street, Nanjing 210016, China

    1 shared publication
  • Sergejus Borodinas

    Department of Applied Mechanics, Vilnius Gediminas Technical University, Saulėtekis Avenue 11, 10223 Vilnius, Lithuania

    1 shared publication
  • Ying Yang

    State Key Laboratory of Mechanics and Control for Aerospace Structures, College of Aerospace Engineering, Nanjing University of Aeronautics and Astronautics, Yudao 29, Nanjing 210016, PR China

    1 shared publication

Latest Publications

  • Open Access

    A Disc-Type High Speed Rotary Ultrasonic Motor with Internal Contact Teeth

    by Jianmin Qiu, Ying Yang, Xin Hong, Piotr Vasiljev, Dalius Mazeika, Sergejus Borodinas

    This paper presents a disc-type ultrasonic piezoelectric motor, which is designed for micro flying vehicles. It provides a high output rotation speed under low operating voltage, compared with common piezoelectric devices, by employing a “contact teeth” wave transmission structure. The ultrasonic motor (USM) consists of a trimorph disc stator, with triple internal contact teeth, a shaft and two hemispheric hard-wearing rotors. The operating principle of the USM is based on the superposition of the in-plane B03 vibration mode of the trimorph disc, and the first longitudinal vibration of the contact teeth. An optimization method of the stator structure parameters was proposed and validated by numerical modeling. The diameter and thickness of the stator are 20 mm and 1 mm, respectively. A prototype with the weight of 2 g was made for this experimental test. The optimal frequency of the excitation signal and the preload force are 98.5 kHz and 0.5 N, respectively. The minimum operating voltage was tested under 7.5 V and reached the speed of 225 rpm, and the maximum unloaded rotational speed of the USM reached 5172 rpm when 30 V driving voltage was applied. The maximum lifting force generated by this USM was measured as 46.1 mN, which is 2.35 times bigger than its weight.