Aishwarya Baranikumar
Aishwarya Baranikumar has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Zachary Grasley
Director of Center for Infrastructure Renewal (CIR), Texas A&M Engineering, Bryan, TX 77807, USA
4 shared publications - Christa E. Torrence
Department of Materials Science and Engineering, Texas A&M University, College Station, USA
3 shared publications - Raja Shekharan
Virginia Department of Transportation, Maintenance Division, Richmond, VA
2 shared publications Douglas Frith
Quality Engineering Solutions, Inc., Reno, NV
1 shared publicationKalyan Asam
Virginia Department of Transportation, Maintenance Division, Richmond, VA
1 shared publication- Xijun Shi
Texas State Univ
1 shared publication
Latest Publications
- 25 April 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2678 (11) , 393-404
Investigation of the Data Variability of Network-Level Pavement Condition Data
For pavement management purposes it is essential to have quality data for a pavement network. Here the data collected at the network level are investigated for quality using additional statistical approaches. As a part of the quality assurance, randomly sampled pavement sections are evaluated using an independent verification and validation process, and are compared with the network-level data collected by the data collection vendor on the same pavement sections. If the established criteria are met, with composite condition indices, the vendor data are considered acceptable. These criteria are developed based on engineering judgment and experience. The accepted data are further investigated to determine whether any statistical differences exist in individual distress type, severity, or extent. Investigation reveals no statistical differences based on composite condition indices, distress type, or extent. There is no misclassification of any distress type with any other distress type. However, a few distress types have statistical differences in severity levels. Steps are identified to minimize these differences.
- 25 April 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2678 (11) , 393-404
Investigation of the Data Variability of Network-Level Pavement Condition Data
For pavement management purposes it is essential to have quality data for a pavement network. Here the data collected at the network level are investigated for quality using additional statistical approaches. As a part of the quality assurance, randomly sampled pavement sections are evaluated using an independent verification and validation process, and are compared with the network-level data collected by the data collection vendor on the same pavement sections. If the established criteria are met, with composite condition indices, the vendor data are considered acceptable. These criteria are developed based on engineering judgment and experience. The accepted data are further investigated to determine whether any statistical differences exist in individual distress type, severity, or extent. Investigation reveals no statistical differences based on composite condition indices, distress type, or extent. There is no misclassification of any distress type with any other distress type. However, a few distress types have statistical differences in severity levels. Steps are identified to minimize these differences.
- 4 May 2023
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2677 (11) , 83-95
Methodology to Predict Federal Performance Measures From State Performance Measures of Pavement Networks
Pavement management data used in measuring the performance of a pavement network contribute to managing maintenance and rehabilitation needs and determining the required funding levels. A network’s performance can be measured in several ways. The method adopted by the Virginia Department of Transportation has been in use for more than 15 years. With the introduction of Transportation Performance Management by the Federal Highway Administration (FHWA), a set of performance measures required by FHWA are to be reported. A few methods from earlier efforts by others in predicting one or more pavement performance parameters are briefly discussed. The main challenges in the determination of federal performance measures are the lack of prediction models for those measures; the reporting on 1/10th-mi sections that are not directly used in analysis and maintenance planning; and the determination of funding levels based on 1/10th-mi sections. In this paper, a new method to predict the federal performance measures of pavement networks from the state performance measures is provided, along with the mathematical models developed.
- 4 May 2023
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2677 (11) , 83-95
Methodology to Predict Federal Performance Measures From State Performance Measures of Pavement Networks
Pavement management data used in measuring the performance of a pavement network contribute to managing maintenance and rehabilitation needs and determining the required funding levels. A network’s performance can be measured in several ways. The method adopted by the Virginia Department of Transportation has been in use for more than 15 years. With the introduction of Transportation Performance Management by the Federal Highway Administration (FHWA), a set of performance measures required by FHWA are to be reported. A few methods from earlier efforts by others in predicting one or more pavement performance parameters are briefly discussed. The main challenges in the determination of federal performance measures are the lack of prediction models for those measures; the reporting on 1/10th-mi sections that are not directly used in analysis and maintenance planning; and the determination of funding levels based on 1/10th-mi sections. In this paper, a new method to predict the federal performance measures of pavement networks from the state performance measures is provided, along with the mathematical models developed.
- Open Access
- 23 February 2022
- Published by Springer Nature in Materials and Structures
- Vol. 55 (2) , 1
Correction to: Temperature dependence of viscoelastic Poisson’s ratio of cement mortar
- 23 February 2022
- Published by Springer Nature in Materials and Structures
- Vol. 55 (2) , 1
Open AccessCorrection to: Temperature dependence of viscoelastic Poisson’s ratio of cement mortar
- 1 September 2021
- Published by Elsevier in Cement and Concrete Research
- Vol. 147, 106522
Estimating viscoelastic compliance of desiccating cementitious materials using drying prism tests
- 1 September 2021
- Published by Elsevier in Cement and Concrete Research
- Vol. 147, 106522
Estimating viscoelastic compliance of desiccating cementitious materials using drying prism tests
- Open Access
- 19 April 2021
- Published by Springer Nature in Materials and Structures
- Vol. 54 (3) , 1-13
Temperature dependence of viscoelastic Poisson’s ratio of cement mortar
Concrete creep research has focused primarily on uniaxial response. However, biaxially prestressed concrete structures are common, resulting in a multiaxial stress state that can complicate the behavior of a viscoelastic material like concrete. Significant creep strains may be induced in directions transverse to each principle stress due to Poisson’s effect. Past research is unclear regarding the viscoelastic or viscoplastic properties of concrete outside of uniaxial response. It has been reported in separate studies that concrete viscoelastic/viscoplastic Poisson’s ratio (VPR) is an increasing, decreasing and constant function with time, with all reported measurements performed at room temperature. In this paper, the 3D basic creep response of mature cement mortar is examined using a confined compression experiment that allows direct determination of the full stress and infinitesimal strain tensors in a single test, which enables the determination of VPR under a multiaxial stress state. For this purpose, a unique, miniature version of the standardized concrete creep frame is designed that is amenable to placing in climate chambers and temperature ovens. The experimental results indicate that the VPR of sealed, mature cement mortar is nearly constant and equal to the elastic at room temperature, while the VPR gradually increases with time when measured at 60 °C.
- 19 April 2021
- Published by Springer Nature in Materials and Structures
- Vol. 54 (3) , 1-13
Open AccessTemperature dependence of viscoelastic Poisson’s ratio of cement mortar
Concrete creep research has focused primarily on uniaxial response. However, biaxially prestressed concrete structures are common, resulting in a multiaxial stress state that can complicate the behavior of a viscoelastic material like concrete. Significant creep strains may be induced in directions transverse to each principle stress due to Poisson’s effect. Past research is unclear regarding the viscoelastic or viscoplastic properties of concrete outside of uniaxial response. It has been reported in separate studies that concrete viscoelastic/viscoplastic Poisson’s ratio (VPR) is an increasing, decreasing and constant function with time, with all reported measurements performed at room temperature. In this paper, the 3D basic creep response of mature cement mortar is examined using a confined compression experiment that allows direct determination of the full stress and infinitesimal strain tensors in a single test, which enables the determination of VPR under a multiaxial stress state. For this purpose, a unique, miniature version of the standardized concrete creep frame is designed that is amenable to placing in climate chambers and temperature ovens. The experimental results indicate that the VPR of sealed, mature cement mortar is nearly constant and equal to the elastic at room temperature, while the VPR gradually increases with time when measured at 60 °C.
- 8 March 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (2) , 289-307
Thermorheological approach to predict long-term creep of cement mortar from short-term tests
- 8 March 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (2) , 289-307
Thermorheological approach to predict long-term creep of cement mortar from short-term tests