Santiago Elvira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Santiago Elvira has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Angel de Castro
Electronics and Communications Technology Department, Autonomous University of Madrid, Madrid, Spain
5 shared publications - Javier Garrido
Escuela Politécnica Superior, Universidad Autónoma de Madrid, 28049 Madrid, Spain
4 shared publications - Guillermo Glez-De-Rivera
Escuela Politécnica Superior, Universidad Autónoma de Madrid, 28049 Madrid, Spain
3 shared publications - Alberto Sanchez
HCTLab Research Group, Universidad Autonoma de Madrid, Madrid, Spain
2 shared publications Javier Garrido
Human Computer Technology Laboratory (HCTLab), Univ. Autonoma de Madrid, Madrid, Spain
1 shared publicationRicardo Ribalda
HCTLab, Univ. Autonoma de Madrid. Francisco Tomas y Valiente 11, Madrid, Spain
1 shared publication
Latest Publications
- 11 October 2015
- Published by Springer Nature in Journal of Intelligent & Robotic Systems
- Vol. 82 (3-4) , 595-607
HALO4: Horizontal Angle Localization and Orientation System with 4 Receivers and Based on Ultrasounds
- 11 October 2015
- Published by Springer Nature in Journal of Intelligent & Robotic Systems
- Vol. 82 (3-4) , 595-607
HALO4: Horizontal Angle Localization and Orientation System with 4 Receivers and Based on Ultrasounds
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Angle localization and orientation system with 4 receivers and based on audible sound signals
This paper presents a 2D indoor localization and orientation system based on a TDOA (Time Difference of Arrival) technique. It uses an array of receivers to implement low computational effort DOA (Direction of Arrival) algorithms. The system is implemented in the audible bandwidth (reference signal frequency is 11 kHz) with low cost microphones and speakers and its performance is compared to the same system but implemented with ultrasonic devices.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Angle localization and orientation system with 4 receivers and based on audible sound signals
This paper presents a 2D indoor localization and orientation system based on a TDOA (Time Difference of Arrival) technique. It uses an array of receivers to implement low computational effort DOA (Direction of Arrival) algorithms. The system is implemented in the audible bandwidth (reference signal frequency is 11 kHz) with low cost microphones and speakers and its performance is compared to the same system but implemented with ultrasonic devices.
- Open Access
- 1 January 2014
- Published by SAGE Publications in International Journal of Advanced Robotic Systems
- Vol. 11 (9)
ALO4: Angle Localization and Orientation System with Four Receivers
This paper presents a 2D indoor localization and orientation system based on a TDOA (Time Difference of Arrival) technique. It uses an array of receivers (four low-cost ultrasonic resonant devices in a square distribution) to implement low-computational-effort DOA (Direction of Arrival) algorithms, based on assumed plane-wave reception. The system only demands two transmitters at well-known positions on the ceiling of the room for obtaining the node position and orientation when it is deployed on the floor of the room. This system has been tested using a Xilinx Spartan-3A FPGA that implements a 52 MHz MicroBlaze. The experimental results include a total of 1,440 points, obtaining a mean localization error of 5.17 cm and a mean orientation error of 3.34°. For this system, the localization and orientation processes are executed in less than 50 us.
- 1 January 2014
- Published by SAGE Publications in International Journal of Advanced Robotic Systems
- Vol. 11 (9)
Open AccessALO4: Angle Localization and Orientation System with Four Receivers
This paper presents a 2D indoor localization and orientation system based on a TDOA (Time Difference of Arrival) technique. It uses an array of receivers (four low-cost ultrasonic resonant devices in a square distribution) to implement low-computational-effort DOA (Direction of Arrival) algorithms, based on assumed plane-wave reception. The system only demands two transmitters at well-known positions on the ceiling of the room for obtaining the node position and orientation when it is deployed on the floor of the room. This system has been tested using a Xilinx Spartan-3A FPGA that implements a 52 MHz MicroBlaze. The experimental results include a total of 1,440 points, obtaining a mean localization error of 5.17 cm and a mean orientation error of 3.34°. For this system, the localization and orientation processes are executed in less than 50 us.
- Open Access
- 1 April 2012
- Published by Elsevier in Measurement
- Vol. 45 (3) , 276-283
Autonomous indoor ultrasonic positioning system based on a low-cost conditioning circuit
- 1 April 2012
- Published by Elsevier in Measurement
- Vol. 45 (3) , 276-283
Open AccessAutonomous indoor ultrasonic positioning system based on a low-cost conditioning circuit
- Open Access
- 1 November 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 2709-2714
Low cost indoor ultrasonic positioning implemented in FPGA
This paper presents a low cost indoor ultrasonic-based positioning system. This system allows the mobile nodes of a Wireless Sensor Network to know their location using radiofrequency and ultrasonics. To achieve this goal, a matrix of transmitting anchor points is installed whereas the mobile nodes receive these transmitted signals and estimate the time-of-flight of the ultrasonic signals. Using two time-of-flight measurements and trilateration equations, the location of the mobile nodes can be inferred in a 2-D space.
- 1 November 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 2709-2714
Open AccessLow cost indoor ultrasonic positioning implemented in FPGA
This paper presents a low cost indoor ultrasonic-based positioning system. This system allows the mobile nodes of a Wireless Sensor Network to know their location using radiofrequency and ultrasonics. To achieve this goal, a matrix of transmitting anchor points is installed whereas the mobile nodes receive these transmitted signals and estimate the time-of-flight of the ultrasonic signals. Using two time-of-flight measurements and trilateration equations, the location of the mobile nodes can be inferred in a 2-D space.