VNVan Duc Nguyen

Van Duc Nguyen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Van Duc Nguyen has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Direct numerical simulation of 45° oblique flow past surface-mounted square cylinder

    by Dung Viet Duong, Luc Van Nguyen, Duc Van Nguyen, Truong Cong Dinh, Lavi Rizki Zuhal, Long Ich Ngo

    Comprehensive coherent structures around a surface-mounted low aspect ratio square cylinder in uniform flow with an oblique angle of $45^{\circ }$ were investigated for cylinder-width-based Reynolds numbers of 3000 and 10 000 by direct numerical simulation based on a topology-confined mesh refinement framework. High-resolution simulations and the critical-point concept were scrutinized to reveal for the first time the reasonable and compatible topologies of flow separation and complete near-wall structures, due to their extensive impact on various engineering applications. Large-scale horseshoe vortices are observed at two notable foci in the viscous sublayer. Within this layer, a wall-parallel jet is formed by downflow intruding into the bottom surface at the half-saddle point, then deflecting in the upstream direction and finally penetrating the bottom surface until the half-saddle point. A pair of conical vortices on the cylinder's top surface switch themselves on two sides of the square cylinder, where the switching frequency is identical with that of the sway of the side shear layer. The undulation of the Kelvin–Helmholtz instability is identified in the instantaneous development of a conical vortex and side shear layer, where the scaling of the ratio of the Kelvin–Helmholtz and von Kármán frequencies follows the power-law relation obtained by Lander et al. (J. Fluid Mech., vol. 849, 2018, pp. 1096–1119). Large-scale arch-shaped vortex is often detected in the intermediate wake region of a square cylinder, involving two interconnected portions, such as the leg portion separated from leeward surfaces and head portion rolled up from the top surface. The leg portion of the arch-shaped vortex was rooted by two foci near the bottom-surface plane.


  • Open Access

    Low order modeling of dynamic stall using vortex particle method and dynamic mode decomposition

    by Van Duc Nguyen, Viet Dung Duong, Minh Hoang Trinh, Hoang Quan Nguyen, Dang Thai Son Nguyen

    Low order modelings are performed in this paper, including iterative Brinkman penalized vortex method (IBVM) and data-driven dynamic mode decomposition (DMD) for dynamic stall study of symmetric airfoil. The data are extracted from IBVM as input for flow field reconstruction using combinations of DMD dominant modes, representing extracted flow features. The primary mode together with its harmonics, and the mean mode are termed to be dominant for the airfoil wake duplication at fixed angles of attack ([ ]) ranging from [ ] to [ ]. For the dynamic stall duplication, at small and large pitching amplitudes, the nearfield and farfield vorticty contours from the DMD generally agree well with those from the IBVM. In addition, the lift coefficient from the DMD collapses well with that from the IBVM and the experiment.


  • Low-Reynolds-number wake of three tandem elliptic cylinders

    by Viet Dung Duong, Van Duc Nguyen, Van Tien Nguyen, Ich Long Ngo

    The flow around three elliptic cylinders with equal spacing and aspect ratio in tandem arrangements was numerically investigated through direct numerical simulation. The spacing ratio (L/D, where D and L are the major axis and the center-to-center distance of two adjacent elliptic cylinders, respectively) ranging from 1.5 to 10 and the Reynolds numbers of Re=65−160 (based on D) are examined. The analysis aims at the effects of L/D and Re on wake structures, hydrodynamic forces, and Strouhal numbers and correlates them with the underlying flow physics. The flow is highly changeable to Re and L/D, classifying into five distinct regimes, namely, meandering, overshoot, reattachment, quasi-coshedding, and coshedding. Two vortex shedding frequencies for middle and downstream cylinders are observed in the latter two regimes, indicating the significant wake interference, where three vortex shedding modes are spatially observed including primary, two-layered, and secondary. The transition between two adjacent modes forms two boundaries. At the first boundary, vortices divert from the cylinder centerline and follow two layers, while vortices converge the cylinder centerline at the second boundary. The first boundary location is not stationary at Re=65–100 , while it is stationary at Re = 160. Otherwise, the second boundary location moves upstream with an increase in L/D, while the range of movement decreases with an increase in Re. The increase in Re advances the disturbance level and urges the transition between vortex shedding modes. The time-mean lift and drag coefficients for three cylinders are highly sensitive with an increase in L/D.


  • Open Access

    Measurement of the Curvature-Dependent Surface Tension in Nucleating Colloidal Liquids

    by V. D. Nguyen, F. C. Schoemaker, E. M. Blokhuis, P. Schall

    The curvature dependence of the surface tension is central to the nucleation of liquids, but remains difficult to access experimentally and predict theoretically. This curvature dependence arises from the curvature-dependent molecular structure, which, for small nuclei, can deviate significantly from that of the planar liquid interface. Simulations and density functional theory have been used to predict this curvature dependence, however with contradicting results. Here, we provide the first direct measurement of the curvature-dependent surface tension in nucleating colloidal liquids. We employ critical Casimir forces to finely adjust colloidal particle interactions and induce liquid nucleation, and image individual nuclei at the particle scale to measure their curvature-dependent surface tension directly from thermally excited surface distortions. Using continuum models, we elucidate the interplay between nucleus structure, particle pair potential, and surface tension. Our results reveal a 20% lower surface tension for nuclei of critical size compared to bulk liquids, leading to 3 orders of magnitude higher nucleation rates, thus highlighting the importance of surface tension curvature corrections for accurate prediction of nucleation rates.


  • Open Access

    Multi-step control over self-assembled hydrogels of peptide-derived building blocks and a polymeric cross-linker

    by Van Duc Nguyen, Asish Pal, Frank Snijkers, Mathieu Colomb-Delsuc, Giulia Leonetti, Sijbren Otto, Jasper van der Gucht

    We present a detailed study of self-assembled hydrogels of bundled and cross-linked networks consisting of positively charged amyloid-like nanofibers and a triblock copolymer with negatively charged end blocks as a cross-linker.