Jingang Liu
Jingang Liu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Jinghuan Chen
China National Pulp and Paper Research Institute Co., Ltd, Beijing, China
3 shared publications Kaiji Yang
CNOOC (Tianjin) Oilfield Chemical Co., Ltd., Tianjin, China
2 shared publicationsTao Zhao
China National Pulp and Paper Research Institute Co., Ltd., Beijing, China
2 shared publicationsXinqi Li
China National Pulp and Paper Research Institute Co., Ltd.,Beijing,CHINA. National Engineering Lab for Pulp and Paper,Beijing,CHINA
2 shared publicationsJiaqian Luo
National Engineering Laboratory for Pulp and Paper, Beijing, China
1 shared publicationJinghuan Chen
National Engineering Laboratory for Pulp and Paper, Beijing, China
1 shared publication
Latest Publications
- 23 January 2024
- Published by Springer Nature in Cellulose
- Vol. 31 (4) , 2031-2046
Preparation of carbodiimide-mediated octadecylamine modified carboxyethyl cellulose microfibrils and their reinforcement of poly(butylene adipate-co-terephthalate)
- 23 January 2024
- Published by Springer Nature in Cellulose
- Vol. 31 (4) , 2031-2046
Preparation of carbodiimide-mediated octadecylamine modified carboxyethyl cellulose microfibrils and their reinforcement of poly(butylene adipate-co-terephthalate)
- Open Access
- 1 October 2023
- Published by Tsinghua University Press in Paper and Biomaterials
- Vol. 8 (4) , 1-8
Comparison of Nanofibrillated Cellulose and Hydroxyethyl Cellulose in Improving the Storage Stability of Waterborne Coatings
Waterborne coatings often delaminate and settle during long-term storage, requiring the addition of thickeners. The effects of nanofibrillated cellulose (NFC) and the commonly used thickener, hydroxyethyl cellulose (HEC), on the storage stability of waterborne coatings were compared in this study. The morphology of NFC was characterized using infrared spectroscopy (FT-IR) and scanning electron microscopy (SEM). The rotational viscosity and rheological properties of the waterborne coatings with NFC and HEC were tested. Stationary settling experiments were also conducted at different temperatures to compare the difference of NFC and HEC on improving the storage stability of the waterborne coatings. The results showed that the waterborne coating with NFC exhibited pseudoplastic fluid characteristics; a small addition of NFC can achieve the same improvement effect on the storage stability of waterborne coatings as HEC. Further, the improvement effect of NFC was not affected by temperature. The waterborne coating with NFC still exhibited good storage stability at high temperatures, which was significantly superior to that of HEC. Therefore, NFC is a feasible agent for improving the prolonged storage stability and warming-induced delamination of waterborne coatings.
- 1 October 2023
- Published by Tsinghua University Press in Paper and Biomaterials
- Vol. 8 (4) , 1-8
Open AccessComparison of Nanofibrillated Cellulose and Hydroxyethyl Cellulose in Improving the Storage Stability of Waterborne Coatings
Waterborne coatings often delaminate and settle during long-term storage, requiring the addition of thickeners. The effects of nanofibrillated cellulose (NFC) and the commonly used thickener, hydroxyethyl cellulose (HEC), on the storage stability of waterborne coatings were compared in this study. The morphology of NFC was characterized using infrared spectroscopy (FT-IR) and scanning electron microscopy (SEM). The rotational viscosity and rheological properties of the waterborne coatings with NFC and HEC were tested. Stationary settling experiments were also conducted at different temperatures to compare the difference of NFC and HEC on improving the storage stability of the waterborne coatings. The results showed that the waterborne coating with NFC exhibited pseudoplastic fluid characteristics; a small addition of NFC can achieve the same improvement effect on the storage stability of waterborne coatings as HEC. Further, the improvement effect of NFC was not affected by temperature. The waterborne coating with NFC still exhibited good storage stability at high temperatures, which was significantly superior to that of HEC. Therefore, NFC is a feasible agent for improving the prolonged storage stability and warming-induced delamination of waterborne coatings.
- Open Access
- 1 January 2023
- Published by Tsinghua University Press in Paper and Biomaterials
- Vol. 8 (1) , 26-34
Preparation and Characterization of Cellulose Nanofibril-Waterborne Polyurethane Composite Films
To improve the performance of polyurethane films, small amounts of cellulose nanofibrils (CNF) were physically blended with a waterborne polyurethane (WPU) emulsion, and then CNF/WPU composite films were prepared by cast-coating and drying. The particle size of the emulsions and the chemical structure, micromorphology, thermal stability, mechanical properties, and water resistance of the composite films were characterized using a Malvern laser particle size analyzer, Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), thermogravimetric analysis (TGA), an electronic strength machine, water contact angle analysis (WCA), and water absorption tests, respectively. The results showed that at a low CNF content of 0.3 wt%, the particle size of the WPU emulsion and chemical structure of the film did not change significantly. In addition, the tensile strength of the composite film increased by up to 108% compared to the neat WPU film, and the thermal stability and water resistance were slightly improved. The addition of CNF greatly enhanced the tensile strength while maintaining the other original properties of the WPU film, which may greatly improve the service life and tear resistance of commercial coatings in the future.
- 1 January 2023
- Published by Tsinghua University Press in Paper and Biomaterials
- Vol. 8 (1) , 26-34
Open AccessPreparation and Characterization of Cellulose Nanofibril-Waterborne Polyurethane Composite Films
To improve the performance of polyurethane films, small amounts of cellulose nanofibrils (CNF) were physically blended with a waterborne polyurethane (WPU) emulsion, and then CNF/WPU composite films were prepared by cast-coating and drying. The particle size of the emulsions and the chemical structure, micromorphology, thermal stability, mechanical properties, and water resistance of the composite films were characterized using a Malvern laser particle size analyzer, Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), thermogravimetric analysis (TGA), an electronic strength machine, water contact angle analysis (WCA), and water absorption tests, respectively. The results showed that at a low CNF content of 0.3 wt%, the particle size of the WPU emulsion and chemical structure of the film did not change significantly. In addition, the tensile strength of the composite film increased by up to 108% compared to the neat WPU film, and the thermal stability and water resistance were slightly improved. The addition of CNF greatly enhanced the tensile strength while maintaining the other original properties of the WPU film, which may greatly improve the service life and tear resistance of commercial coatings in the future.
- 2 April 2021
- Published by Springer Nature in Cellulose
- Vol. 28 (8) , 4671-4684
Pretreatment of lignin-containing cellulose micro/nano-fibrils (LCMNF) from corncob residues
- 2 April 2021
- Published by Springer Nature in Cellulose
- Vol. 28 (8) , 4671-4684
Pretreatment of lignin-containing cellulose micro/nano-fibrils (LCMNF) from corncob residues
- 1 February 2018
- Published by BioResources in BioResources
- Vol. 13 (2) , 3386-3394-3394
Effect of Silica Gel in Causticized Calcium Carbonate from Nonwood Pulping on the AKD Sizing Efficiency of Paper
Effect of Silica Gel in Causticized Calcium Carbonate from Nonwood Pulping on the AKD Sizing Efficiency of Paper
- 1 February 2018
- Published by BioResources in BioResources
- Vol. 13 (2) , 3386-3394-3394
Effect of Silica Gel in Causticized Calcium Carbonate from Nonwood Pulping on the AKD Sizing Efficiency of Paper
Effect of Silica Gel in Causticized Calcium Carbonate from Nonwood Pulping on the AKD Sizing Efficiency of Paper
- 31 January 2017
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 134 (22)
Comparison of cellulose and chitin nanocrystals for reinforcing regenerated cellulose fibers
In this study, regenerated cellulose fibers reinforced by cellulose nanocrystals (CENC) and chitin nanocrystals (CHNC) were prepared by blending the nanocrystals suspensions with the cellulose solution in NaOH/urea/water solvent at room temperature. The effect of nanocrystals' addition on the properties of spinning dopes and regenerated fibers were investigated and compared. Results showed that the obtained CENC and CHNC had different dimensions, and both of them increased the viscosity and decreased the transparency of the spinning dopes. However, the dissolution state of cellulose was not changed. CHNC had a greater influence on the properties of spinning dopes, while CENC had more obvious effect on the performance of regenerated fibers. The CENC reinforced fibers showed a higher crystallinity index as compared to the CHNC reinforced fibers. The tensile strength of the regenerated fibers was evidently improved when 3 wt % CENC or 2 wt % CHNC were added, while the elongation at break of the fibers was slightly decreased with the increase of nanocrystals content. The morphology and thermal stability of the regenerated fibers was not affected by the addition of nanocrystals. This study suggested that the dimension, group and content of nanocrystals were important factors for the reinforcement of regenerated cellulose fibers. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44880.
- 31 January 2017
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 134 (22)
Comparison of cellulose and chitin nanocrystals for reinforcing regenerated cellulose fibers
In this study, regenerated cellulose fibers reinforced by cellulose nanocrystals (CENC) and chitin nanocrystals (CHNC) were prepared by blending the nanocrystals suspensions with the cellulose solution in NaOH/urea/water solvent at room temperature. The effect of nanocrystals' addition on the properties of spinning dopes and regenerated fibers were investigated and compared. Results showed that the obtained CENC and CHNC had different dimensions, and both of them increased the viscosity and decreased the transparency of the spinning dopes. However, the dissolution state of cellulose was not changed. CHNC had a greater influence on the properties of spinning dopes, while CENC had more obvious effect on the performance of regenerated fibers. The CENC reinforced fibers showed a higher crystallinity index as compared to the CHNC reinforced fibers. The tensile strength of the regenerated fibers was evidently improved when 3 wt % CENC or 2 wt % CHNC were added, while the elongation at break of the fibers was slightly decreased with the increase of nanocrystals content. The morphology and thermal stability of the regenerated fibers was not affected by the addition of nanocrystals. This study suggested that the dimension, group and content of nanocrystals were important factors for the reinforcement of regenerated cellulose fibers. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44880.