PAPalli V. Alfiya

Palli V. Alfiya

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Palli V. Alfiya has a total of 43 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Advances in hybrid solar–infrared drying for food processing: Comparative design, energy performance, and quality evaluation

    by S. Murali, D.S. Aniesrani Delfiya, K.C. Neethu, P.V. Alfiya, G. Jeevarathinam, Bogala Madhu, Zhongli Pan

    1. Drying is one of the most widely applied unit operations in food and agricultural processing, enabling shelf-life extension through moisture removal and suppression of microbial, enzymatic, and ...

  • Early detection of aflatoxin in chilli using hyperspectral imaging with a Dual Attention Network

    by Shyam Chand G., Shihabudheen K.V., Sudhish N. George, Sony George, C. Sarathambal, Anees K., E. Jayashree, P.V. Alfiya

  • Optimization and Characterization of Turmeric Oleoresin Impregnated Biodegradable Packaging Film

    by P. V. Alfiya, E. Jayashree, K. Anees, P. Shahala, S. Avanthika

    Biodegradable packaging has evolved as a sustainable solution to mitigate plastic waste concerns. This study aimed to develop arrowroot starch based biodegradable film by impregnating turmeric oleoresin to develop a biodegradable and readily soluble food packaging. Optimization was done by RSM‐FCCCD approach based on concentrations of arrowroot starch (0.75%, 1% and 1.25%) and turmeric oleoresin (0.25%, 0.5% and 0.75%). Arrowroot starch concentration of 0.89% and turmeric oleoresin concentration of 0.25% resulted in films with minimum WVP (5.22 gmm/m 2 day kPa) and maximum solubility (61.53%) with a desirability of 0.991. The characteristics of the prepared films, including weight, thickness, moisture content, swelling index, solubility, water vapour permeability, colour value, free fatty acid value, peroxide value, heat sealability and total plate count, were analysed. Moisture content, swelling degree, solubility and water vapour permeability of the films varied from 4.98–7.54, 19.33–23.5, 58%–63% and 5.24–7.86 g·mm·m −2 ·day −1 ·k.Pa −1 , respectively. SEM pictograph showed a smooth, uniform and continuous structure with pores varying in the range of 0.37–0.69 μm. The simulated results demonstrated that the turmeric oleoresin‐impregnated biodegradable packaging film rapidly releases curcumin in boiling water, achieving near‐complete release within 10 min. The film is better suited for dry or low‐moisture foods with low water activity ( a w < 0.6).

  • Drying characteristics, color kinetics and quality evaluation of black pepper ( Piper nigrum ) under conventional and novel drying methods

    by P. V. Alfiya, E. Jayashree, K. Anees, A. Ann Mary

    This study investigated the drying characteristics and quality attributes of black pepper (var. IISR‐Thevam) under four methods: vacuum tray drying (VTD), infrared drying (IRD) and hot‐air drying (HAD) at 45, 50, 55, and 60°C, and sun drying (SD). Drying rate, effective moisture diffusivity, drying efficiency, color parameters (L*, a*, b*, hue angle, chroma, ΔE), and chemical constituents (essential oil, oleoresin, piperine) were analyzed. Infrared drying exhibited superior dry recovery (38.3% at 50°C) and drying efficiency (36.8% at 60°C), while vacuum drying at 60°C better preserved essential oil (2.9%), and color attributes. Essential oil contents of vacuum, infrared, hot air and sun‐dried black pepper were determined to be 2.9%, 2.9%, 2.6%, and 2.3%, respectively. Vacuum drying at 60°C and infrared and hot‐air drying at 55°C exhibited the maximum value for essential oil. Vacuum, infrared, hot‐air, and sun‐dried samples reported oleoresin and piperine contents of 7.55%, 7.55%, 7.5%, and 7.61% and 23.08, 21.08, 20.78, and 13.70 mg/mL, respectively. The highest value of oleoresin was observed at a temperature of 50°C for all three drying methods. Sun drying, despite being cost‐effective, resulted in the lowest retention of active compounds. Infrared drying balanced speed and quality, whereas hot‐air drying incurred greater color and nutrient losses. These findings highlighted the advantages of vacuum and infrared drying in enhancing the quality and marketability of black pepper, offering valuable insights for spice processors aiming to optimize quality, energy efficiency, and compliance with international trade standards.

  • Drying Kinetics and Quality Evaluation of Mace Under Solar, Vacuum, and Hot‐Air Drying Methods

    by P. V. Alfiya, E. Jayashree, K. Anees, K. Sunisha

    This study explored the impact of different drying methods namely solar‐biomass, vacuum, and hot‐air drying, on the drying characteristics, essential oil, oleoresin, and lycopene contents of mace. The research highlighted the importance of optimizing drying techniques to preserve the quality and bioactive compounds of mace, a valuable spice derived from nutmeg. Work compared drying efficiency and quality retention across the three drying methods. Experimental setup utilized a solar‐biomass hybrid dryer with supplementary heating, alongside vacuum and hot‐air dryers at temperatures of 45°C, 50°C, 55°C, and 60°C. The methodology involved measuring moisture reduction from an initial 55%–60% to a final 7%–8%, with vacuum drying achieving this in 4 h, hot‐air drying in 6 h, and solar‐biomass drying requiring 18 h. The drying process exhibited a falling rate period, with vacuum and hot‐air drying reaching a maximum drying rate of 1.06 g/g dry mass·h, compared to 0.97 g/g dry mass·h for solar‐biomass drying. Results revealed that vacuum‐dried mace at 60°C yielded the highest essential oil (7.92%) and oleoresin (19.55%) contents, while hot‐air‐dried mace at 55°C had the lowest essential oil (7.63%) and oleoresin (18.44%). Solar‐biomass‐dried mace showed intermediate values (7.82% essential oil, 19.06% oleoresin). Lycopene content was highest in vacuum‐dried mace (153.47 μg/mL), followed by hot‐air (145.71 μg/mL) and solar‐biomass (144.54 μg/mL) dried samples, indicating the superiority of vacuum drying in preserving bioactive compounds.


  • Experimental Evaluation of Hot Air‐Assisted Continuous Microwave Drying of Oyster Mushroom (Pleurotus ostreatus)

    by P. V. Alfiya, G. K. Rajesh, S. Murali, D.S. Aniesrani Delfiya, Manoj P. Samuel, M. V. Prince, K. P. Sudheer, Lilia Baby

    This study evaluated the efficiency of hot air−assisted continuous microwave (HACM) drying for oyster mushrooms (Pleurotus ostreatus), focusing on drying kinetics, quality attributes, and economic feasibility. Response surface methodology was used to optimize drying parameters viz., microwave power (600–1000 W), air temperature (40°C–60°C), and airflow rate (0.5–1.5 m/s), to minimize drying time and water activity while maximizing rehydration ratio. Optimal conditions obtained were air temperature, microwave power, and air flow rate of 55.05°C, 1000 W, 0.81 m/s, respectively, with a drying time of 5 h, water activity of 0.532, and rehydration ratio of 2.49. The dried mushrooms showed 29.63% shrinkage, a total color change of 28.51, pore sizes of 2.06–15.70 µm, and a sensory acceptability score of 8.1. Proximate analysis indicated enhanced protein (33.21%) and carbohydrate (47.34%) contents. The HACM system achieved energy efficiency and specific energy consumption of 23.12% and 2.71 kWh/kg, respectively. The benefit‐cost ratio of 1.55 and a payback period of 2.56 years confirmed the economic viability of the system and its potential for scalable and high‐quality mushroom preservation.


  • Techno‐economic, environmental impact and exergy analysis of microwave assisted drying of nutmeg mace

    by P. V. Alfiya, E. Jayashree, K. Anees

    This study aimed to reduce the drying time of mace under microwave pre‐treatment and to analyze the energy, exergy, and techno‐economic feasibility of the process. Effect of microwave pretreatments were studied under three microwave power levels of 160, 320, and 480 W for an exposure time of 60 s. Drying time during convective drying without microwave pretreatment was 5.5 h, which was decreased by 18.2%, 27.3%, and 36.4% at microwave powers of 160, 320, and 480 W respectively. Moisture content of mace decreased from 45.66 ± 1.14% to 6%. under various drying conditions. The two‐term exponential model fitted the drying data under optimized conditions. The drying efficiency and exergy efficiency of the microwave assisted drying of mace was observed to be 29.53% and 26.74%, respectively. The values of economic attributes indicated the benefit cost ratio of 1.9 and payback period of 2.1 years. The sustainability index and environment destruction coefficient of the system was determined to be 1.10 and 2.41, respectively. Waste energy ratio, environmental impact factor and improvement potential of the developed drying process was 0.72, 1.52, and 0.46, respectively. The study concluded that microwave at optimal power of 320 W can be utilized for commercial production of mace with better retention of essential oil, oleoresin and color.


  • Process optimization for drying of Shrimp (Metapenaeus dobsoni) under hot air‐assisted microwave drying technology using response surface methodology

    by P. V. Alfiya, G. K. Rajesh, S. Murali, D. S. Aniesrani Delfiya, Manoj P. Samuel, M. V. Prince, K. P. Sudheer

    The study was carried out to optimize the drying conditions of shrimp in the hot air‐assisted microwave drying system using response surface methodology. The drying experiments were performed using a Box–Behnken design with air temperature (50–70°C), air velocity (.5–1.5 m/s), and microwave power level (600–1000 W) as independent variables and drying time, water activity, and rehydration ratio as independent variables. The obtained response variables were fitted into the various regression equations to predict a suitable model. The methodology of desired function was applied to indicate 61.74°C air temperature, 922.61 W microwave power, and 1.0 m/s air velocity which offered a reduced drying time of 2.8 h, the water activity of .424 and improved rehydration ratio of 2.51, respectively with a desirability value of .949. The moisture content, drying efficiency, shrinkage, and total color change were determined for the samples obtained under optimized conditions and were observed as 16.5% (w.b), 35.71%, 14.14%, and 16.95 ± 2.14, respectively. Scanning electron microscopy analysis of dried shrimp showed the formation of pores of diameters ranging from 3.17 to 10.6 μm. The process parameters optimized under the study for hot air‐assisted microwave drying can be used for the production of good‐quality dried shrimps.Practical applications: Generally, fish and fish products are dried in the open sun or solar dryers in most developing countries. The traditional methods offer the least process controls with maximum energy and manpower demand to meet the ever‐growing industry requirements with increased awareness of the safety and quality of the dried products. The hot air‐assisted microwave (HAMW) drying system developed under the study could have complete control over the process parameters without compromising the quality of the dried product. The study suggests the HAMW drying system as a potential means of drying technique for large‐scale commercial production of dried shrimps.