EGElangovan Govindarajalu

Elangovan Govindarajalu

*This is an algorithmically generated author record based on publicly available information.

Elangovan Govindarajalu has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Reuse of ceramic waste in concrete production for a sustainable ecosystem

    by Elangovan Govindarajalu, Ganesh Prabhu Ganapathy

    The rapid development of ceramic production has resulted in greater ceramic waste and environmental problems. The current study investigates the use of ceramic waste (CW) as fine aggregate in concrete, taking advantage its high silicon dioxide concentration. Energy Dispersive X-ray Analysis (EDAX) and SEM were used to investigate the elemental composition and microstructure of CW. CW was replaced for up to 30% of fine aggregate in concrete, with 5% increases. The study assessed the influence on concrete using fresh and mechanical strength measurements, and SEM analysis was performed at 7 and 90 days to explore the pozzolanic response of CW. The increased porosity and angular roughness of crushed ceramic waste (CW) aggregate deteriorated the fresh properties of concrete and lowered its bulk density. Initially, incorporating CW resulted in a loss in compressive strength during the early curing period (7 days). Microstructural research demonstrated that CW’s pozzolanic activity was restricted in the early stages but improved over time, enabling enhanced crystalline formation and a denser concrete matrix by lowering macropores. The replacement of 15% of river sand with CW in concrete reduces production costs by 9% but also demonstrated potential environmental benefits.


  • Open Access

    A Study on Self‐Consolidate Concrete in Experimental Reinforced‐Concrete Beam Column Structures with Alccofine and Steel Fiber

    by G. Vimal Arokiaraj, G. Elangovan

    This paper discusses the concept of self‐consolidating concrete mix with Alccofine‐1203, superplasticizer, viscosity modification agent, crimped steel fiber on the RC beam column joint. Totally, eight reinforced‐concrete (RC) column joints with M25 grade concrete were considered in this study. Out of eight RC beam column joints, two beam column joints served as Alccofine, two beam column joint specimens served as Alccofine 5%, two beam column joint specimens served as Alccofine‐10%, and two beam column joint specimens served as Alccofine‐15%. All the RC beam column joint specimens were tested under the compression until failure in the loading frame of 2000 kN capacity. The test results of Alccofine‐10% showed the higher loading capacity than that of Alccofine‐5% and Alccofine‐15% in self‐consolidating concrete RC beam column joints. The percentage of superplasticizer, viscosity modification agent, and crimped steel fiber is maintained. Nonlinear finite element analysis (FEA) to analyse the beam column joint through nonlinear finite element modelling (NLFEM) and the modelling results were compared from the experimental results. The results obtained through ANSYS modelling show good agreement with the experimented results. The deflection ductility of experimental results shows 1.57, and the predicted deflection ductility shows 1.59 in beam column joint with Alccofine‐10%. ANSYS software is validated as appropriate software to predict the study parameters of self‐consolidation concrete in beam column joints.