Jia-Sheng Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jia-Sheng Huang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Chia-Hung Chen
Department of Electronics and Electrical Engineering, National Yang Ming Chiao Tung University (NYCU), R.O.C, Hsinchu, Taiwan
3 shared publications - Shih-Che Kuo
Department of Electronics and Electrical Engineering, National Yang Ming Chiao Tung University (NYCU), R.O.C, Hsinchu, Taiwan
2 shared publications - Basil Amuzu-Sefordzi
Hohai University, Nanjing, China
1 shared publication - Che-Wei Hsu
Department of Electronics and Electrical Engineering, NYCU, Hsinchu, Taiwan
1 shared publication Che‐Wei Hsu
Department of Electrical and Computer Engineering National Yang Ming Chiao Tung University Hsinchu 300 Taiwan
1 shared publicationChia-Wei Kao
Electrical and Computer Engineering, National Chiao Tung University, Hsinchu, Taiwan R.O.C
1 shared publication
Latest Publications
- 3 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (10) , 2733-2744
A Multistep Multistage Fifth-Order Incremental Delta Sigma Analog-to-Digital Converter for Sensor Interfaces
Incremental analog-to-digital converters (IADCs), by adding a simultaneous reset in analog modulators and digital filters, are Nyquist-rate ADCs which use noise-shaping to convert a finite number of analog samples into a single digital word. They retain most advantages of the delta sigma ( $\Delta \Sigma )$ ADCs, and are much easier to be multiplexed with shorter latency and simpler digital filters. Integrated sensor fusion system-on-chips (SoCs) require a high-accuracy low-latency analog-to-digital converter (ADC) to interface a wide input range signal and multiplex among multiple sensor channels. To fulfill these demands at the same time, a multistage multistep incremental ADC is proposed. A third-order multistage IADC, implemented by cascading a second-order IADC (IADC2) and a first-order IADC (IADC1), performs the coarse quantization in the first step. When the coarse quantization is finished, the residue is also accumulated at the last integrator’s output and is ready for fine quantization. The circuit is reused and reconfigured as a second IADC in the second step. Prototyped in 180 nm technology and power supplied at 1.8 V, the proposed work can achieve 20 kHz signal bandwidth with 358.4 $\mu $ W power dissipation. The measured performance of the prototype is 91 dB dynamic range (DR), 89.1 dB signal-to-noise-and-distortion (SNDR), and 107.5 dB spurious-free DR (SFDR). The measured SNDR/DR achieves Schreier figure-of-merit (FoM) of 166.6/168.5 dB.
- 3 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (10) , 2733-2744
A Multistep Multistage Fifth-Order Incremental Delta Sigma Analog-to-Digital Converter for Sensor Interfaces
Incremental analog-to-digital converters (IADCs), by adding a simultaneous reset in analog modulators and digital filters, are Nyquist-rate ADCs which use noise-shaping to convert a finite number of analog samples into a single digital word. They retain most advantages of the delta sigma ( $\Delta \Sigma )$ ADCs, and are much easier to be multiplexed with shorter latency and simpler digital filters. Integrated sensor fusion system-on-chips (SoCs) require a high-accuracy low-latency analog-to-digital converter (ADC) to interface a wide input range signal and multiplex among multiple sensor channels. To fulfill these demands at the same time, a multistage multistep incremental ADC is proposed. A third-order multistage IADC, implemented by cascading a second-order IADC (IADC2) and a first-order IADC (IADC1), performs the coarse quantization in the first step. When the coarse quantization is finished, the residue is also accumulated at the last integrator’s output and is ready for fine quantization. The circuit is reused and reconfigured as a second IADC in the second step. Prototyped in 180 nm technology and power supplied at 1.8 V, the proposed work can achieve 20 kHz signal bandwidth with 358.4 $\mu $ W power dissipation. The measured performance of the prototype is 91 dB dynamic range (DR), 89.1 dB signal-to-noise-and-distortion (SNDR), and 107.5 dB spurious-free DR (SFDR). The measured SNDR/DR achieves Schreier figure-of-merit (FoM) of 166.6/168.5 dB.
- Open Access
- 6 May 2021
- Published by Institution of Engineering and Technology (IET) in The Journal of Engineering
- Vol. 2021 (7) , 394-398
A fourth‐order incremental ADC in three‐step
This letter presents a second‐order incremental ADC (IADC) operated in three steps, which extends the performance of a second‐order IADC close to that of a fourth‐order IADC with only two amplifiers. It performs a second‐order noise‐shaping quantization in the first step operation. Reusing the same hardware, the circuit is reconfigured to perform fine quantization as a first‐order IADC in the second and third step. Within a conversion time of 60 clock periods (oversampling ratio OSR = 60), 35 dB signal‐to‐quantization‐noise ratio is boosted. The proposed topology is very suitable for low‐bandwidth high‐resolution data conversion.
- 6 May 2021
- Published by Institution of Engineering and Technology (IET) in The Journal of Engineering
- Vol. 2021 (7) , 394-398
Open AccessA fourth‐order incremental ADC in three‐step
This letter presents a second‐order incremental ADC (IADC) operated in three steps, which extends the performance of a second‐order IADC close to that of a fourth‐order IADC with only two amplifiers. It performs a second‐order noise‐shaping quantization in the first step operation. Reusing the same hardware, the circuit is reconfigured to perform fine quantization as a first‐order IADC in the second and third step. Within a conversion time of 60 clock periods (oversampling ratio OSR = 60), 35 dB signal‐to‐quantization‐noise ratio is boosted. The proposed topology is very suitable for low‐bandwidth high‐resolution data conversion.
- 19 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
A 677-μW 90-dB DR 16-kHz BW Incremental ΔΣ ADC for Sensor Interfaces
Incremental ADCs (IADC) have more advantages and are now popular in high-resolution sensor interface circuits. In this paper, we proposed and demonstrate a power- and area-optimized IADC, using second-order feedforward one-bit modulator. With very simple coefficients scaling, the dynamic range is very wide and it can achieve 90-dB dynamic range and peak SNDR 86.2 dB with 2.6 Vpp, and its occupied area 0.025 mm 2 . It can achieve 16 kHz bandwidth with power consumption 677 μW, which results in a Schreier FoM 162 dB. It is very suitable for integration on sensor system-on-chip.
- 19 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
A 677-μW 90-dB DR 16-kHz BW Incremental ΔΣ ADC for Sensor Interfaces
Incremental ADCs (IADC) have more advantages and are now popular in high-resolution sensor interface circuits. In this paper, we proposed and demonstrate a power- and area-optimized IADC, using second-order feedforward one-bit modulator. With very simple coefficients scaling, the dynamic range is very wide and it can achieve 90-dB dynamic range and peak SNDR 86.2 dB with 2.6 Vpp, and its occupied area 0.025 mm 2 . It can achieve 16 kHz bandwidth with power consumption 677 μW, which results in a Schreier FoM 162 dB. It is very suitable for integration on sensor system-on-chip.
- Open Access
- 23 April 2014
- Published by WITPRESS LTD.
Hydrogen production by supercritical water gasification of food waste using nickel and alkali catalysts
Supercritical water gasification (SCWG) of food waste was carried out with nickel and alkali catalysts (NaOH, KOH, Ca(OH)2, Na2CO3, NaHCO3...
- 23 April 2014
- Published by WITPRESS LTD.
Open AccessHydrogen production by supercritical water gasification of food waste using nickel and alkali catalysts
Supercritical water gasification (SCWG) of food waste was carried out with nickel and alkali catalysts (NaOH, KOH, Ca(OH)2, Na2CO3, NaHCO3...