Seok-Ho Hong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Seok-Ho Hong has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Jae-Sang Lee
Chung-Ang Univ. (Korea, Republic of)
3 shared publications - Su-Jin Jeon
Chung-Ang Univ. (Korea, Republic of)
3 shared publications - Young-Wan Choi
Chung-Ang Univ. (Korea, Republic of)
3 shared publications - Yong-Jin Kim
Department of Electrical and Electronics Engineering, Chung-Ang University, Dongjak-gu, Seoul, Republic of Korea
2 shared publications - Byung-Hee Son
Honam Research Center, Electronics and Telecommunications Research Institute, Gwangju, South Korea
1 shared publication - Do-Hyun Kim
Department of Electrical and Electronics Engineering, Chung-Ang University, 221 Heuksuk-Dong, Dongjak-ku, Seoul 156-756, Korea
1 shared publication
Latest Publications
- 15 June 2023
- Published by Korean Association for Spatial Structures in Journal of the Korean Association for Spatial Structures
- Vol. 23 (2) , 19-28
Unstable Behavior and Critical Buckling Load of a Single-Layer Dome using the Timber Elements
- 15 June 2023
- Published by Korean Association for Spatial Structures in Journal of the Korean Association for Spatial Structures
- Vol. 23 (2) , 19-28
Unstable Behavior and Critical Buckling Load of a Single-Layer Dome using the Timber Elements
- Open Access
- 13 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (1) , 1-6
Thermal Reflow Effect in Multi-Mode Waveguide of S-Bend Resonator With Mode Discrimination
Polymer-based S-bend optical resonator consisting of multi-mode waveguide has been used as refractive index sensing devices due to their cost-effectiveness and ease of fabrication. However, during fabrication, the thermal reflow that occurs during the baking process and overdevelopment induces an inclination in the sidewalls of the waveguide. The construction of the angled sidewalls can influence the propagation mode properties of the waveguide, such as the evanescent field and loss. Hence, in this study, we designed and analyzed S-bend resonators to investigate the influence of the sidewall slope on the optical modes of the waveguide and the sensing performance of the resonator with respect to the variation of slope angles. The simulation results revealed that, as the sidewall slope deviated from the right angle (90°–65°), the sensitivity of the device increased by a factor of 1.8 due to the field leakage, whereas, the extinction ratio and Q-factor decreased by 54% and 37%, respectively. The results indicated that the sidewall slope induces a trade-off between the resolution and the sensitivity of the S-bend resonator. The findings of this study can be used as a reference for further research on MMW-based optical sensors using polymer materials.
- 13 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (1) , 1-6
Open AccessThermal Reflow Effect in Multi-Mode Waveguide of S-Bend Resonator With Mode Discrimination
Polymer-based S-bend optical resonator consisting of multi-mode waveguide has been used as refractive index sensing devices due to their cost-effectiveness and ease of fabrication. However, during fabrication, the thermal reflow that occurs during the baking process and overdevelopment induces an inclination in the sidewalls of the waveguide. The construction of the angled sidewalls can influence the propagation mode properties of the waveguide, such as the evanescent field and loss. Hence, in this study, we designed and analyzed S-bend resonators to investigate the influence of the sidewall slope on the optical modes of the waveguide and the sensing performance of the resonator with respect to the variation of slope angles. The simulation results revealed that, as the sidewall slope deviated from the right angle (90°–65°), the sensitivity of the device increased by a factor of 1.8 due to the field leakage, whereas, the extinction ratio and Q-factor decreased by 54% and 37%, respectively. The results indicated that the sidewall slope induces a trade-off between the resolution and the sensitivity of the S-bend resonator. The findings of this study can be used as a reference for further research on MMW-based optical sensors using polymer materials.
- 28 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 33 (11) , 569-572
Wideband Predistortion Technique With Dual-Parallel Schottky Diodes for Low Power RoF Systems
Radio-over-fiber (RoF)-based front haul architecture has attracted considerable attention for fifth-generation (5G) cellular systems because of its cost effectiveness, however, it is susceptible to harmonic frequency distortion and intermodulation products (IMs) arising from the nonlinearity of the laser diode. To overcome this limitation, an asymmetric electrical predistortion method, using a single Schottky diode with nonlinear characteristics similar to those of a laser diode, was previously proposed. However, its asymmetric structure causes a phase mismatch, which limits the system bandwidth. In this study, we propose an enhanced electrical predistortion technique using dual-parallel Schottky diode blocks. The proposed technique was validated by experiments involving an IM3 drop of approximately 27 dB, and by using identical dual Schottky diode blocks, the phase mismatch in the previously proposed method is completely eliminated. Thus, the applicable bandwidth is extended to 1.8 GHz. This technique can be used to improve the linearity and increase the bandwidth of RoF systems. Additionally, the simple structure is attractive for low-power applications.
- 28 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 33 (11) , 569-572
Wideband Predistortion Technique With Dual-Parallel Schottky Diodes for Low Power RoF Systems
Radio-over-fiber (RoF)-based front haul architecture has attracted considerable attention for fifth-generation (5G) cellular systems because of its cost effectiveness, however, it is susceptible to harmonic frequency distortion and intermodulation products (IMs) arising from the nonlinearity of the laser diode. To overcome this limitation, an asymmetric electrical predistortion method, using a single Schottky diode with nonlinear characteristics similar to those of a laser diode, was previously proposed. However, its asymmetric structure causes a phase mismatch, which limits the system bandwidth. In this study, we propose an enhanced electrical predistortion technique using dual-parallel Schottky diode blocks. The proposed technique was validated by experiments involving an IM3 drop of approximately 27 dB, and by using identical dual Schottky diode blocks, the phase mismatch in the previously proposed method is completely eliminated. Thus, the applicable bandwidth is extended to 1.8 GHz. This technique can be used to improve the linearity and increase the bandwidth of RoF systems. Additionally, the simple structure is attractive for low-power applications.
- Open Access
Novel S-Bend Resonator Based on a Multi-Mode Waveguide with Mode Discrimination for a Refractive Index Sensor
In this paper, a multi-mode waveguide-based optical resonator is proposed for an integrated optical refractive index sensor. Conventional optical resonators have been studied for single-mode waveguide-based resonators to enhance the performance, but mass production is limited owing to the high fabrication costs of nano-scale structures. To overcome this problem, we designed an S-bend resonator based on a micro-scale multi-mode waveguide. In general, multi-mode waveguides cannot be utilized as optical resonators, because of a performance degradation resulting from modal dispersion and an output transmission with multi-peaks. Therefore, we exploited the mode discrimination phenomenon using the bending loss, and the resulting S-bend resonator yielded an output transmission without multi-peaks. This phenomenon is utilized to remove higher-order modes efficiently using the difference in the effective refractive index between the higher-order and fundamental modes. As a result, the resonator achieved a Q-factor and sensitivity of 2.3 103 and 52 nm/RIU, respectively, using the variational finite-difference time-domain method. These results show that the multi-mode waveguide-based S-bend resonator with a wide line width can be utilized as a refractive index sensor.Open AccessNovel S-Bend Resonator Based on a Multi-Mode Waveguide with Mode Discrimination for a Refractive Index Sensor
In this paper, a multi-mode waveguide-based optical resonator is proposed for an integrated optical refractive index sensor. Conventional optical resonators have been studied for single-mode waveguide-based resonators to enhance the performance, but mass production is limited owing to the high fabrication costs of nano-scale structures. To overcome this problem, we designed an S-bend resonator based on a micro-scale multi-mode waveguide. In general, multi-mode waveguides cannot be utilized as optical resonators, because of a performance degradation resulting from modal dispersion and an output transmission with multi-peaks. Therefore, we exploited the mode discrimination phenomenon using the bending loss, and the resulting S-bend resonator yielded an output transmission without multi-peaks. This phenomenon is utilized to remove higher-order modes efficiently using the difference in the effective refractive index between the higher-order and fundamental modes. As a result, the resonator achieved a Q-factor and sensitivity of 2.3 103 and 52 nm/RIU, respectively, using the variational finite-difference time-domain method. These results show that the multi-mode waveguide-based S-bend resonator with a wide line width can be utilized as a refractive index sensor.