Ivan Malymon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ivan Malymon has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Yuriy Yudin
National Technical University “Kharkiv Polytechnic Institute
3 shared publications - Alexander Lapuzin
National Technical University “Kharkiv Polytechnic Institute
2 shared publications - Svetlana Naumenko
Національний технічний університет «Харківський політехнічний інститут
2 shared publications Valery Subotovich
National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine
2 shared publications- Valery Subotovich
Anatolii Pidhornyi Institute of Power Machines and Systems of the National Academy of Sciences of Ukraine
2 shared publications Yuriy Yudin
National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine
2 shared publications
Latest Publications
- Open Access
- 2 April 2024
- Published by Springer Nature in Advances in Aerodynamics
- Vol. 6 (1) , 1-22
Aerodynamic tunnel for tests of turbine annular cascades
Aerodynamic test rigs are necessary for experimental testing of turbomachines and investigation of possible ways to improve machine performance. Existing installations give higher losses and do not work efficiently at off-design operating modes. An operating part with an adjustable radial diffuser was designed in order to determine the characteristics of turbine annular cascades. Experimental studies and computational verifications showed satisfactory results at various operating modes. The regulated backwall of the radial diffuser ensured supersonic velocity values behind the cascade and overall stable operation in a wide range of Mach numbers up to 1.3 when using compressors of comparatively small capacity. The optimum positions of the regulated backwall were determined, which provided a deep vacuum behind the cascade, as well as 1.5 times Mach number increase compared to the turbine cascade without a diffuser. Changing the inlet channel geometry at supersonic modes leads to an increase in the diffuser efficiency. Additionally, it was determined that the use of the turbine vane cascade in the test rig flow path is not necessary during calculation studies, but instead an axisymmetric vaneless converging area can be applied and give satisfactory results as well as reduce the time spent on calculations. The computational model can be used to optimize the design of an aerodynamic tunnel outlet area.
- 2 April 2024
- Published by Springer Nature in Advances in Aerodynamics
- Vol. 6 (1) , 1-22
Open AccessAerodynamic tunnel for tests of turbine annular cascades
Aerodynamic test rigs are necessary for experimental testing of turbomachines and investigation of possible ways to improve machine performance. Existing installations give higher losses and do not work efficiently at off-design operating modes. An operating part with an adjustable radial diffuser was designed in order to determine the characteristics of turbine annular cascades. Experimental studies and computational verifications showed satisfactory results at various operating modes. The regulated backwall of the radial diffuser ensured supersonic velocity values behind the cascade and overall stable operation in a wide range of Mach numbers up to 1.3 when using compressors of comparatively small capacity. The optimum positions of the regulated backwall were determined, which provided a deep vacuum behind the cascade, as well as 1.5 times Mach number increase compared to the turbine cascade without a diffuser. Changing the inlet channel geometry at supersonic modes leads to an increase in the diffuser efficiency. Additionally, it was determined that the use of the turbine vane cascade in the test rig flow path is not necessary during calculation studies, but instead an axisymmetric vaneless converging area can be applied and give satisfactory results as well as reduce the time spent on calculations. The computational model can be used to optimize the design of an aerodynamic tunnel outlet area.
- 17 January 2024
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 15-20
Numerical Aerodynamic Investigation of an Outlet Part for Powerful Steam Turbine in a Wide Operating Modes Range
A series of computational studies of the aerodynamic characteristics for the model of a steam turbine LPC last stage with an exhaust hood has been performed. The studies were carried out in a wide range of operating modes of the last stage GV2. The stage model was built using AxSTREAM software package and calculated in 3D Solver software package. The exhaust hood model was axisymmetric and diffuserless. The distribution of parameters for calculations was taken from the experimental data, which were obtained at PD GRES (Pridneprovskaya thermal power station) with the participation of the Department of Turbine Engineering of NTU “KHPI”". The results of calculations were satisfactorily verified with experimental data at all operating modes investigated. The resulting flow data can be used to evaluate the aerodynamics of outlet turbine parts when designing exhaust hoods. The obtained calculation model can be applied in further calculation studies to find ways to optimise the output channels of turbomachines.
- 17 January 2024
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 15-20
Numerical Aerodynamic Investigation of an Outlet Part for Powerful Steam Turbine in a Wide Operating Modes Range
A series of computational studies of the aerodynamic characteristics for the model of a steam turbine LPC last stage with an exhaust hood has been performed. The studies were carried out in a wide range of operating modes of the last stage GV2. The stage model was built using AxSTREAM software package and calculated in 3D Solver software package. The exhaust hood model was axisymmetric and diffuserless. The distribution of parameters for calculations was taken from the experimental data, which were obtained at PD GRES (Pridneprovskaya thermal power station) with the participation of the Department of Turbine Engineering of NTU “KHPI”". The results of calculations were satisfactorily verified with experimental data at all operating modes investigated. The resulting flow data can be used to evaluate the aerodynamics of outlet turbine parts when designing exhaust hoods. The obtained calculation model can be applied in further calculation studies to find ways to optimise the output channels of turbomachines.
- Open Access
- 28 December 2022
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 1-2,p. 23-31
Studying the Effect of the Tangential Nonuniformity of Flow Parameters on Gas Dynamic Performances of the Nozzle Cascades of Turbine Machines
Aerodynamic efficiency of the nozzle cascades of steam and gas turbines is defined by many factors and one of them is the tangential and radial nonuniformity degree of the parameters of a spatial flow behind the cascades. The averaging of these parameters enables the determination of the integral parameters of the cascades, in particular two flow angles and the velocity angle or the kinetic energy loss coefficient. The angle that takes into account the level of the averaged radial component of the velocity defines the level of kinematic losses in the cascade. Even in the case of the cylindric boundaries of the cascade this angle differs from zero and kinematic losses decrease the cascade efficiency by 30 to 50 percent. This scientific paper gives the results of experimental investigations of the effect of the circumferential nonuniformity of the velocity and the angles of the spatial flow on kinematic losses at different radii of the nozzle cascade of the last stage of the steam turbine and the nozzle cascade of the first stage of the gas turbine. The kinetic energy loss coefficient and the coefficient of total losses were suggested as the integral characteristics of the cascades. In the case of cylindric boundaries of the stage the total loss-to-kinetic energy loss ratio is noticeably decreased during the transition from the average zone to the zone of end losses. However, in the peripheral zone of the nozzle cascade of the last stage of steam turbine total losses are three times higher than kinetic energy losses due to the fact that the radial component of the velocity behind the cascade is much higher than the flow rate component and the level of the losses of kinetic energy is not high.
- 28 December 2022
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 1-2,p. 23-31
Open AccessStudying the Effect of the Tangential Nonuniformity of Flow Parameters on Gas Dynamic Performances of the Nozzle Cascades of Turbine Machines
Aerodynamic efficiency of the nozzle cascades of steam and gas turbines is defined by many factors and one of them is the tangential and radial nonuniformity degree of the parameters of a spatial flow behind the cascades. The averaging of these parameters enables the determination of the integral parameters of the cascades, in particular two flow angles and the velocity angle or the kinetic energy loss coefficient. The angle that takes into account the level of the averaged radial component of the velocity defines the level of kinematic losses in the cascade. Even in the case of the cylindric boundaries of the cascade this angle differs from zero and kinematic losses decrease the cascade efficiency by 30 to 50 percent. This scientific paper gives the results of experimental investigations of the effect of the circumferential nonuniformity of the velocity and the angles of the spatial flow on kinematic losses at different radii of the nozzle cascade of the last stage of the steam turbine and the nozzle cascade of the first stage of the gas turbine. The kinetic energy loss coefficient and the coefficient of total losses were suggested as the integral characteristics of the cascades. In the case of cylindric boundaries of the stage the total loss-to-kinetic energy loss ratio is noticeably decreased during the transition from the average zone to the zone of end losses. However, in the peripheral zone of the nozzle cascade of the last stage of steam turbine total losses are three times higher than kinetic energy losses due to the fact that the radial component of the velocity behind the cascade is much higher than the flow rate component and the level of the losses of kinetic energy is not high.
- 30 December 2021
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 5-11
Flow Characteristics of the Nozzle Blade Cascade in the Mode of the Joint Operation with the Radial Diffuser
The obtained research data are given for the nozzle cascade used by a small-size gas turbine of an average fanning in combination with the radial diffuser. Aerodynamic characteristics of the nozzle blade cascade were determined in a wide range of a change in the Reynolds number varying from 4∙105 to 106 and the reduced velocity varying in the range of 0.4 to 1.13. The flow rate coefficient of the nozzle cascade was derived for all modes using the integral methods and the drainages behind the cascade. The kinetic energy loss coefficient and the flow angles were calculated using the measurement data of flow parameters in three control modes that were obtained due to the use of orientable pneumometric probes. When the expansion degree of the convergent –divergent annular duct behind the cascade is equal to 1.43 the flow in the narrow section of this duct is “enlocked” in the mode when the reduced velocity behind the cascade is equal to 1.127. At such velocity the Reynolds number 106 is self-similar for the flow rate coefficient. At lower values of Reynolds number, the decrease of it is accompanied by an intensive decrease in the flow rate coefficient for all the values of the reduced velocity. For the Reynolds number lower than 7∙105 an increase in the velocity results in a decreased flow rate coefficient. When this number exceeds 8∙105 an increase in the velocity results in an increase of the flow coefficient up to the moment when the flow is “enlocked” in the nozzle cascade.
- 30 December 2021
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 5-11
Flow Characteristics of the Nozzle Blade Cascade in the Mode of the Joint Operation with the Radial Diffuser
The obtained research data are given for the nozzle cascade used by a small-size gas turbine of an average fanning in combination with the radial diffuser. Aerodynamic characteristics of the nozzle blade cascade were determined in a wide range of a change in the Reynolds number varying from 4∙105 to 106 and the reduced velocity varying in the range of 0.4 to 1.13. The flow rate coefficient of the nozzle cascade was derived for all modes using the integral methods and the drainages behind the cascade. The kinetic energy loss coefficient and the flow angles were calculated using the measurement data of flow parameters in three control modes that were obtained due to the use of orientable pneumometric probes. When the expansion degree of the convergent –divergent annular duct behind the cascade is equal to 1.43 the flow in the narrow section of this duct is “enlocked” in the mode when the reduced velocity behind the cascade is equal to 1.127. At such velocity the Reynolds number 106 is self-similar for the flow rate coefficient. At lower values of Reynolds number, the decrease of it is accompanied by an intensive decrease in the flow rate coefficient for all the values of the reduced velocity. For the Reynolds number lower than 7∙105 an increase in the velocity results in a decreased flow rate coefficient. When this number exceeds 8∙105 an increase in the velocity results in an increase of the flow coefficient up to the moment when the flow is “enlocked” in the nozzle cascade.
- Open Access
- 28 December 2019
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 31-35
Aerodynamic Investigation of Axial-Radial Diffusers for Axial Compressor of Gas Turbine Plant
- 28 December 2019
- Published by National Technical University Kharkiv Polytechnic Institute in NTU "KhPI" Bulletin: Power and heat engineering processes and equipment
- No. 3,p. 31-35
Open AccessAerodynamic Investigation of Axial-Radial Diffusers for Axial Compressor of Gas Turbine Plant