An Hoang-Thuy Nguyen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
An Hoang-Thuy Nguyen has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Manh-Cuong Nguyen
Inha University
7 shared publications - Rino Choi
Inha University
7 shared publications - Geon Park
Department of Materials Science and Engineering, The University of Texas at Dallas 3 , 800 West Campbell Road, Richardson, Texas 75080
3 shared publications - Kyungsoo Hwang
Department of Materials Science and Engineering, Inha University, Incheon, South Korea
3 shared publications - Gyeongyeol Lee
Inha University
2 shared publications - Hoyeon Sin
D Convergence Center, Inha University, Incheon, South Korea
2 shared publications
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 47 (11) , 2175-2178
Enhanced Capacitive Memory Window in Hf x Zr 1-x O 2 Bilayer Capacitor via Zr-Composition Engineering
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 47 (11) , 2175-2178
Enhanced Capacitive Memory Window in Hf x Zr 1-x O 2 Bilayer Capacitor via Zr-Composition Engineering
- 22 August 2026
- Published by Elsevier in Thin Solid Films
- Vol. 850
Enhanced polarization in Hf1-xZrxO2 films through rapid thermal annealing followed by rapid cooling
- 22 August 2026
- Published by Elsevier in Thin Solid Films
- Vol. 850
Enhanced polarization in Hf1-xZrxO2 films through rapid thermal annealing followed by rapid cooling
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (11) , 6647-6651
Metal Interlayer Insertion for Grain Engineering in Ferroelectric Hf₀.₅Zr₀.₅O₂
Since its discovery in the previous decade, ferroelectricity (FE) in zirconium-doped hafnium oxide (HZO) has been studied intensively. With HZO being incorporated in multiple applications, grain size reduction has become essential to enhance the ferroelectric performance and scalability. A common method is implementing a dielectric interlayer (IL) in the middle of HZO films while sacrificing operating power caused by voltage drop across the additional material. This research implemented W and Mo metal ILs in the middle of the HZO stack to prevent grain growth. The effects of the ILs on ferroelectric performance were studied using metal-ferroelectric–insulator-silicon structure. Transmission electron microscopy (TEM) and grazing-incidence X-ray diffraction were used to examine the grain formation in HZO. The results show that metal ILs have successfully improved the ferroelectric performance by suppressing the nonferroelectric monoclinic phase while promoting the formation of the orthorhombic phase. The sample with W IL acting as electrodes for both upper and under HZO thin films was more resilient to fatigue than that with the Mo IL. Hence, W metal ILs can enable HZO implementation in a wider range of application.
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (11) , 6647-6651
Metal Interlayer Insertion for Grain Engineering in Ferroelectric Hf₀.₅Zr₀.₅O₂
Since its discovery in the previous decade, ferroelectricity (FE) in zirconium-doped hafnium oxide (HZO) has been studied intensively. With HZO being incorporated in multiple applications, grain size reduction has become essential to enhance the ferroelectric performance and scalability. A common method is implementing a dielectric interlayer (IL) in the middle of HZO films while sacrificing operating power caused by voltage drop across the additional material. This research implemented W and Mo metal ILs in the middle of the HZO stack to prevent grain growth. The effects of the ILs on ferroelectric performance were studied using metal-ferroelectric–insulator-silicon structure. Transmission electron microscopy (TEM) and grazing-incidence X-ray diffraction were used to examine the grain formation in HZO. The results show that metal ILs have successfully improved the ferroelectric performance by suppressing the nonferroelectric monoclinic phase while promoting the formation of the orthorhombic phase. The sample with W IL acting as electrodes for both upper and under HZO thin films was more resilient to fatigue than that with the Mo IL. Hence, W metal ILs can enable HZO implementation in a wider range of application.
- 20 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (10) , 1997-2000
Tailoring of Ferroelectric Coercive Field and Polarization With Ferroelectric and Antiferroelectric HfxZr1–xO2 Bilayer Structure
In this letter, the advantages of an antiferroelectric (AFE) and ferroelectric (FE) bilayer stack made of Hf x Zr 1-x O 2 (HZO) with different compositions were reported. Compared to the monolayer ferroelectric control sample, Mo/FE/Mo, the Mo/FE/AFE/Mo, and Mo/AFE/FE/Mo stacks exhibited a significant decrease in the coercive field (E c ). A higher dielectric constant of AFE increased the voltage distribution across the FE layer in the bilayer HZO structure, leading to a decrease in E c . Furthermore, the capacitor with Mo/AFE/FE/Mo exhibited 28% higher polarization, P r (2P r = 45.9 μC/cm 2 ), than the control sample, while this significant increase of Pr was not observed in the capacitor with Mo/FE/AFE/Mo. Electrical measurements of the capacitors with FE and AFE having various thicknesses showed that the dielectric constants and phase composition depend on the deposition sequence. A higher orthogonal phase ratio was achieved in the Mo/AFE/FE/Mo stack compared to the Mo/FE/AFE/Mo stack, resulting in higher polarization. Furthermore, bilayer capacitors with Mo/AFE/FE/Mo showed more robust long time reliability, such as endurance and retention.
- 20 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (10) , 1997-2000
Tailoring of Ferroelectric Coercive Field and Polarization With Ferroelectric and Antiferroelectric HfxZr1–xO2 Bilayer Structure
In this letter, the advantages of an antiferroelectric (AFE) and ferroelectric (FE) bilayer stack made of Hf x Zr 1-x O 2 (HZO) with different compositions were reported. Compared to the monolayer ferroelectric control sample, Mo/FE/Mo, the Mo/FE/AFE/Mo, and Mo/AFE/FE/Mo stacks exhibited a significant decrease in the coercive field (E c ). A higher dielectric constant of AFE increased the voltage distribution across the FE layer in the bilayer HZO structure, leading to a decrease in E c . Furthermore, the capacitor with Mo/AFE/FE/Mo exhibited 28% higher polarization, P r (2P r = 45.9 μC/cm 2 ), than the control sample, while this significant increase of Pr was not observed in the capacitor with Mo/FE/AFE/Mo. Electrical measurements of the capacitors with FE and AFE having various thicknesses showed that the dielectric constants and phase composition depend on the deposition sequence. A higher orthogonal phase ratio was achieved in the Mo/AFE/FE/Mo stack compared to the Mo/FE/AFE/Mo stack, resulting in higher polarization. Furthermore, bilayer capacitors with Mo/AFE/FE/Mo showed more robust long time reliability, such as endurance and retention.
- 9 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 70 (3) , 1085-1088
The Effect of High-Pressure Hydrogen or Deuterium Annealing on Electrical Performance of Indium Gallium Zinc Oxide Thin-Film Transistors
This study examined the effects of hydrogen ( $\text{H}_{{2}}$ ) or deuterium ( $\text{D}_{{2}}$ ) annealing on indium gallium zinc oxide (IGZO) channels for the staggered bottom-gate thin-film transistor (TFT). High-pressure annealing (HPA) at 10 bar was used to diffuse and control the amount of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ atoms in IGZO thin films. $\text{H}_{{2}}$ and $\text{D}_{{2}}$ doping samples were compared with Ar annealed samples to exclude the thermal effects. The performance of both $\text{H}_{{2}}$ and $\text{D}_{{2}}$ annealed devices was superior to that of the Ar annealed device. The reliability of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ doping devices under positive bias stress was improved due to the defect passivation of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ . Larger degradation of the $\text{H}_{{2}}$ -annealed sample under negative illumination bias stress (NIBS) was observed compared to the Ar-annealed sample, which was explained by the release of positive $\text{H}_{{2}}$ ions from O–H bonding by the light radiation. With $\text{D}_{{2}}$ doping, the stability under the NIBS and field-effect mobility was improved significantly compared to the $\text{H}_{{2}}$ and Ar annealed TFTs (11.2 and 10.6 cm $^{{2}}\text{V}^{-1}\text{s}^{-1}$ ). The large $\text{D}_{{2}}$ isotope for slow diffusive ability significantly improves the performance and stability of IGZO TFTs.
- 9 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 70 (3) , 1085-1088
The Effect of High-Pressure Hydrogen or Deuterium Annealing on Electrical Performance of Indium Gallium Zinc Oxide Thin-Film Transistors
This study examined the effects of hydrogen ( $\text{H}_{{2}}$ ) or deuterium ( $\text{D}_{{2}}$ ) annealing on indium gallium zinc oxide (IGZO) channels for the staggered bottom-gate thin-film transistor (TFT). High-pressure annealing (HPA) at 10 bar was used to diffuse and control the amount of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ atoms in IGZO thin films. $\text{H}_{{2}}$ and $\text{D}_{{2}}$ doping samples were compared with Ar annealed samples to exclude the thermal effects. The performance of both $\text{H}_{{2}}$ and $\text{D}_{{2}}$ annealed devices was superior to that of the Ar annealed device. The reliability of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ doping devices under positive bias stress was improved due to the defect passivation of $\text{H}_{{2}}$ and $\text{D}_{{2}}$ . Larger degradation of the $\text{H}_{{2}}$ -annealed sample under negative illumination bias stress (NIBS) was observed compared to the Ar-annealed sample, which was explained by the release of positive $\text{H}_{{2}}$ ions from O–H bonding by the light radiation. With $\text{D}_{{2}}$ doping, the stability under the NIBS and field-effect mobility was improved significantly compared to the $\text{H}_{{2}}$ and Ar annealed TFTs (11.2 and 10.6 cm $^{{2}}\text{V}^{-1}\text{s}^{-1}$ ). The large $\text{D}_{{2}}$ isotope for slow diffusive ability significantly improves the performance and stability of IGZO TFTs.
- 21 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 42 (6) , 784-787
Low-Temperature Deep Ultraviolet Laser Polycrystallization of Amorphous Silicon for Monolithic 3-Dimension Integration
Monolithic 3-dimensional integration (M3D) requires heat treatment techniques that should not degrade the device performance of the lower layers when applied to device fabrication in the upper layers. Deep ultraviolet (DUV) laser annealing was implemented in the crystallization of amorphous silicon and source/drain junction activation to fabricate polycrystalline silicon (poly-Si) metal-oxide-semiconductor field-effect-transistors (MOSFETs) for upper-layer devices. The poly-Si MOSFET devices were fabricated successfully on top of the bottom electronic circuit layer (isolated by a thick silicon dioxide layer). Devices on the upper and lower layers were connected through interlayer vias to form a current-starved ring oscillator. The current-to-frequency converter on the bottom layer showed a reasonable increase in frequency as the current of the poly-Si MOSFET on the upper layer increased with increasing silicon grain size, confirming that DUV laser annealing did not degrade the performance of the bottom layer devices. This opens more opportunities for using DUV laser annealing in the M3D integration.
- 21 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 42 (6) , 784-787
Low-Temperature Deep Ultraviolet Laser Polycrystallization of Amorphous Silicon for Monolithic 3-Dimension Integration
Monolithic 3-dimensional integration (M3D) requires heat treatment techniques that should not degrade the device performance of the lower layers when applied to device fabrication in the upper layers. Deep ultraviolet (DUV) laser annealing was implemented in the crystallization of amorphous silicon and source/drain junction activation to fabricate polycrystalline silicon (poly-Si) metal-oxide-semiconductor field-effect-transistors (MOSFETs) for upper-layer devices. The poly-Si MOSFET devices were fabricated successfully on top of the bottom electronic circuit layer (isolated by a thick silicon dioxide layer). Devices on the upper and lower layers were connected through interlayer vias to form a current-starved ring oscillator. The current-to-frequency converter on the bottom layer showed a reasonable increase in frequency as the current of the poly-Si MOSFET on the upper layer increased with increasing silicon grain size, confirming that DUV laser annealing did not degrade the performance of the bottom layer devices. This opens more opportunities for using DUV laser annealing in the M3D integration.