Aseem Dubey
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Aseem Dubey has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Akhilesh Arora
3 shared publications- Akhilesh Arora
Delhi Technological University
3 shared publications Abhishek Sharma
Department of Mechanical Engineering, GL Bajaj Institute of Technology and Management, Greater Noida, Uttar Pradesh, India
1 shared publication- Artūras Kilikevičius
Institute of Mechanical Science, Faculty of Mechanics, Vilnius Gediminas Technical University, LT-10105 Vilnius, Lithuania
1 shared publication Ashmit Dubey
1 shared publication- Dhinesh Balasubramanian
Department of Mechanical Engineering, Mepco Schlenk Engineering College, Sivakasi, India
1 shared publication
Latest Publications
- Top Cited Papers
- 10 January 2026
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 298
Machine learning based prognostic analysis of a hybrid solar still coupled with evacuated tube collector and stearic acid: A comprehensive 4-E assessment
- 10 January 2026
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 298
Top Cited PapersMachine learning based prognostic analysis of a hybrid solar still coupled with evacuated tube collector and stearic acid: A comprehensive 4-E assessment
- 31 May 2025
- Published by Springer Nature
- p. 337-347
Enviro-Economic Assessment of Some Designs of PCM Incorporated Solar Stills
- 31 May 2025
- Published by Springer Nature
- p. 337-347
Enviro-Economic Assessment of Some Designs of PCM Incorporated Solar Stills
- Top Cited Papers
- 1 September 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 373
Advancements in carbon capture technologies: A review
- 1 September 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 373
Top Cited PapersAdvancements in carbon capture technologies: A review
- 26 May 2021
- Published by Springer Nature
- p. 187-198
Solar-Driven Vapour Absorption (LiBr–H2O) Cooling Systems for Commercial Buildings: A Parametric Analysis
- 26 May 2021
- Published by Springer Nature
- p. 187-198
Solar-Driven Vapour Absorption (LiBr–H2O) Cooling Systems for Commercial Buildings: A Parametric Analysis
- Open Access
- 1 April 2021
- Published by Elsevier in Desalination and Water Treatment
- Vol. 218, 106-118
Production of clean water using ETC integrated solar stills: thermoenviro-economic assessment
- 1 April 2021
- Published by Elsevier in Desalination and Water Treatment
- Vol. 218, 106-118
Open AccessProduction of clean water using ETC integrated solar stills: thermoenviro-economic assessment
- 17 September 2020
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 13 (3) , 1-35
High-Temperature Distillation Using N-Parallel Evacuated Tube Collector Integrated With Double Slope Solar Still in Force Mode
In the present communication, a performance investigation of a double-slope solar still augmented with parallel evacuated tubes under forced mode is carried out for a modified geometry. A comprehensive mathematical model is used for the numerical simulation using the experimental data and incorporating the effect of variable flowrate, water depth, and the number of tubes. An optimum flowrate range ∼0.006–0.007 kg/s/tube is found irrespective of the number of tubes and basin water depth to extract optimal energy. The flowrate is validated with other experiments, carried out by various authors. At optimal flowrate with ten tubes and 0.005 m basin water depth, the system yields 6.644 kg, while overall energetic and exergetic efficiencies are observed as ∼33.8% and 4.9%, respectively. With an increase in the tubes as 20 and 30, the respective yields are found to be increased by ∼2.64% and ∼6.62% for nearly the same collector output temperature attainable (≈98.5°C), while the energy and exergy efficiencies decreased significantly by ∼24.6% and ∼38.6%, compared with ten tubes arrangement. Daily yield and overall exergy efficiency are increased by 13.3% and 19.3%, respectively, using a diffused reflector.
- 17 September 2020
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 13 (3) , 1-35
High-Temperature Distillation Using N-Parallel Evacuated Tube Collector Integrated With Double Slope Solar Still in Force Mode
In the present communication, a performance investigation of a double-slope solar still augmented with parallel evacuated tubes under forced mode is carried out for a modified geometry. A comprehensive mathematical model is used for the numerical simulation using the experimental data and incorporating the effect of variable flowrate, water depth, and the number of tubes. An optimum flowrate range ∼0.006–0.007 kg/s/tube is found irrespective of the number of tubes and basin water depth to extract optimal energy. The flowrate is validated with other experiments, carried out by various authors. At optimal flowrate with ten tubes and 0.005 m basin water depth, the system yields 6.644 kg, while overall energetic and exergetic efficiencies are observed as ∼33.8% and 4.9%, respectively. With an increase in the tubes as 20 and 30, the respective yields are found to be increased by ∼2.64% and ∼6.62% for nearly the same collector output temperature attainable (≈98.5°C), while the energy and exergy efficiencies decreased significantly by ∼24.6% and ∼38.6%, compared with ten tubes arrangement. Daily yield and overall exergy efficiency are increased by 13.3% and 19.3%, respectively, using a diffused reflector.
- Open Access
- 1 November 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 691 (1) , 012028
A Review on Performance and Emission of CI Engine using Exhaust gas recirculation (EGR)
The diesel engine has the advantage over gasoline engine due to its low fuel consumption, higher combustion efficiency, durability and low hydrocarbons (HC), particulate, carbon dioxide (CO2), carbon monoxide (CO) and NOXemission as a major source. Due to abovesaid problems, diesel is now blended with Biofuels and play a significant role to meet its energy and environmental challenges. Exhaust gas recirculation (EGR) is an eco-friendly alternativeto lower NOX and particulates emission. The use of EGR in compression ignition engines, lowers the concentration of oxygen mixture and flame temperature. However, it has been observed that advantages of EGR is fuel specific. In present paper a performance review of compression ignitionengine using EGR with blended fuelshas been carried out. The effect on break power, break specific fuel consumption, thermal efficiency has been reported. Further aspects of response surface methodology on optimization of NOx emission, smoke opacity and BSFChasbeen carriedout using blended fuel, EGR rate, injection timing etc.
- 1 November 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 691 (1) , 012028
Open AccessA Review on Performance and Emission of CI Engine using Exhaust gas recirculation (EGR)
The diesel engine has the advantage over gasoline engine due to its low fuel consumption, higher combustion efficiency, durability and low hydrocarbons (HC), particulate, carbon dioxide (CO2), carbon monoxide (CO) and NOXemission as a major source. Due to abovesaid problems, diesel is now blended with Biofuels and play a significant role to meet its energy and environmental challenges. Exhaust gas recirculation (EGR) is an eco-friendly alternativeto lower NOX and particulates emission. The use of EGR in compression ignition engines, lowers the concentration of oxygen mixture and flame temperature. However, it has been observed that advantages of EGR is fuel specific. In present paper a performance review of compression ignitionengine using EGR with blended fuelshas been carried out. The effect on break power, break specific fuel consumption, thermal efficiency has been reported. Further aspects of response surface methodology on optimization of NOx emission, smoke opacity and BSFChasbeen carriedout using blended fuel, EGR rate, injection timing etc.
- 1 January 1994
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 15 (1) , 37-50
Thermodynamic modelling of single/dual organic fluid Rankine cycle cooling systems: A comparative study
This paper presents thermodynamic modelling and a comparative study of single/dual fluid Rankine cycle cooling systems with regenerative heat exchangers in the Rankine Engine (RE)-cycle and the vapour Compression (VC)-cycle subsystems. Both single and dual fluid combinations for the RE-cycle and VC-cycle have been considered and their influence on the RE-cycle efficiency, COP of the VC-cycle and overall system performance have been studied as a function of various component temperatures and the isentropic component efficiencies. In particular, the numerical results for single fluids like R12, R22, R113 and R114 and dual fluids like R113 + R12, R113 + R22, R114 + R12, R114 + R22, R114 + R113 and R113 + R114 are presented and compared with each other. It is found that in general dual fluid systems give better overall system performance as compared to the single fluid systems. Amongst single fluids, R114 and amongst dual fluids R114 + R113 give the best system performance. The presence of RHE in the VC-cycle is more pronounced as compared to that in the RE-cycle in improving the system performance marginally.
- 1 January 1994
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 15 (1) , 37-50
Thermodynamic modelling of single/dual organic fluid Rankine cycle cooling systems: A comparative study
This paper presents thermodynamic modelling and a comparative study of single/dual fluid Rankine cycle cooling systems with regenerative heat exchangers in the Rankine Engine (RE)-cycle and the vapour Compression (VC)-cycle subsystems. Both single and dual fluid combinations for the RE-cycle and VC-cycle have been considered and their influence on the RE-cycle efficiency, COP of the VC-cycle and overall system performance have been studied as a function of various component temperatures and the isentropic component efficiencies. In particular, the numerical results for single fluids like R12, R22, R113 and R114 and dual fluids like R113 + R12, R113 + R22, R114 + R12, R114 + R22, R114 + R113 and R113 + R114 are presented and compared with each other. It is found that in general dual fluid systems give better overall system performance as compared to the single fluid systems. Amongst single fluids, R114 and amongst dual fluids R114 + R113 give the best system performance. The presence of RHE in the VC-cycle is more pronounced as compared to that in the RE-cycle in improving the system performance marginally.