MSManfred Schrödl

Manfred Schrödl

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Manfred Schrödl has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Stabilization of Active Magnetic Bearing Systems in the Case of Defective Sensors

    by Markus Hutterer, Manfred Schroedl

    Many control methods for stabilizing magnetically levitated rotors are proposed in literature. However, most of these systems have in common that the degrees of freedom of the rigid rotor can directly be calculated from the sensor values. This assumption is fulfilled for most active magnetic bearing (AMB) systems if all sensors are working. This article deals with the question if it is possible to stabilize an AMB system if one or more sensors are defective. In this case, a direct calculation of the degrees of freedom from the sensor values is not possible. This article proofs that the defective system is observable for a wide operating range. However, for some parameter constellations the system becomes not observable for specific rotor speeds. The possibility of an observability loss is only present for isotropic magnetic bearings. If anisotropic bearings are modeled the loss of observability is not present anymore. It can be shown that the magnetic bearing system, which is used for the experimental verification, is observable in the predefined operating range without the requirement of an anisotropy. In this article, the cases with one and with two defective radial sensors are investigated. At standstill the x–z plane and the y–z plane are decoupled. Hence, both cases have equal behavior in the plane with the defective sensor. However, for the rotating system both planes are coupled and the properties of both systems are different. To stabilize the levitating system, a controller is developed using the $H_{\infty }$ method. To limit the computational effort of the digital signal processor the control structure is predefined as eighth-order state space system. Finally, the stabilization of the system with two defective sensors is experimentally validated on a turbomolecular pump with a magnetically levitated rotor.


  • Open Access

    On the Historical Development and Future Prospects of Various Types of Electric Mobility

    by Amela Ajanovic, Reinhard Haas, Manfred Schrödl

    Environmental problems such as air pollution and greenhouse gas emissions are caused by almost all transport modes. A potential solution to these problems could be electric mobility. Currently, efforts to increase the use of various types of electric vehicles are under way virtually worldwide. While in recent years a major focus was put on the electrification of passenger cars, electricity has already, for more than hundred years, been successfully used in some public transport modes such as tramways and metros. The core objective of this paper is to analyze the historical developments and the prospects of electric mobility in different transport modes and their potential contribution to the solution of the current environmental problems. With respect to the latter, we analyze the effect of the electricity generation mix on the environmental performance of electric vehicles. In addition, we document major policies implemented to promote various types of e-mobility. Our major conclusions are: (i) The policies implemented will have a major impact on the future development of electric mobility; (ii) The environmental benignity of electric vehicles depends to a large extent on the electricity generation mix.


  • Design Space Analysis Including Experimental Verification for an Electrical Machine Based on a Parametric and Functional IPMSM Model

    by Helmut C. Schmid, Manfred Schrodl, Marcus van Heyden

    In this article, based on the recommendations of systems engineering, a procedure for generating a parametric and functional interior permanent magnet synchronous motor model is proposed. The developed and applied current-adaptive procedure allows to transform the functional relationships of the motor topologies into an advanced model with higher prediction accuracy over a considerably extended definition range. Compared to the state of the art, the proposed approach allows a more general and flexible analysis of electrical machines. A study demonstrates through multicriteria optimization that the design space has a major influence on efficiency and must be taken into account when defining architectures. Existing approaches are typically limited by model constraints to local investigations, the proposed method has advantages over these procedures. In addition to the analysis and optimization of systems, it is shown that the proposed procedure supports decision-making processes due to the integrated system focus. Potentials are identified and discussed in terms of efficiency-enhancing opportunities. A prototype was built and measured to verify the results.


  • Stabilization of a Magnetically Levitated Rotor in the Case of a Defective Radial Actuator

    by Markus Hutterer, Dominik Wimmer, Manfred Schröedl

    This paper describes an operation mode for the stabilization of a five degree of freedom active magnetic bearing system in the case of a damaged radial actuator. The proposed method has the task to stabilize the under-actuated rotor to ensure a safe deceleration. The resulting under-actuated system is not reachable for the admissible angular velocity range. Thus, the rotor could be destabilized for some operating points. However, for a real system with a non ideal isotropic magnetic behavior, the system is reachable for all angular velocities. For the stabilization of the under-actuated system PID controllers are used. The parameters of the PID controllers are calculated using the LQR method. This simple realization of the controllers implies a short computing time. To show the stability and the robustness of the designed controllers different root loci are visualized. The proposed operating mode is able to prevent the safety bearings from wear and damage in the case of a defective magnetic actuator. Finally, the under-actuated operation mode is experimentally validated on a turbomolecular pump, where the center of gravity is not located between the magnetic actuators.


  • Open Access

    Optimierung einer sensorlos betriebenen Synchron-Reluktanz-Maschine hinsichtlich des Wirkungsgrades

    by Mario Nikowitz, Matthias Hofer, Manfred Schrödl

    Zusammenfassung: In dieser Arbeit wird der sensorlose Betrieb einer Synchron-Reluktanz-Maschine bezüglich einer effizienten Betriebsweise optimiert. Der sensorlose Betrieb des Motors wird je nach Drehzahl in einen unteren und in einen oberen Drehzahl-Bereich aufgeteilt. Für niedrige Drehzahlen kommt das INFORM-Verfahren zum Einsatz, dessen Grundidee auf Ausnutzung der magnetischen Anisotropie des Rotors beruht. Durch eine sinnvolle Wahl der Rotorgeometrie kann erheblich Einfluss auf die sensorlosen Eigenschaften und somit auf den bestmöglich erzielbaren Wirkungsgrad genommen werden. Für die höheren Drehzahlen wird der Einsatz des „elektromotorische Kraft“-Modells (kurz EMK-Modells) dem Betrieb mit dem Kurzschluss-Modell gegenübergestellt. Auch hier kann durch die Wahl des geeigneten sensorlosen Verfahrens der Wirkungsgrad des Antriebs erheblich verbessert werden. Schlussendlich werden die in dieser Arbeit erörterten optimalen Betriebsweisen messtechnisch verifiziert.

  • Open Access

    Space Vector Modulation Strategies for Self-Sensing Three-Phase Radial Active Magnetic Bearings

    by Dominik Wimmer, Markus Hutterer, Matthias Hofer, Manfred Schrödl

    The focus of this study lies on the investigation of the space vector modulation of a self-sensing three-phase radial active magnetic bearing. The determination of the rotor position information is performed by a current slope-based inductance measurement of the actuator coils. Therefore, a special pulse width modulation sequence is applied to the actuator coils by a conventional three-phase inverter. The choice of the modulation type is not unique and provides degrees of freedom for different modulation patterns, which are described in this work. For a self-sensing operation of the bearing, certain constraints of the space vector modulation must be considered. The approach of a variable space vector modulation is investigated to ensure sufficient dynamic in the current control as well as the suitability for a self-sensing operation with an accurate rotor position acquisition. Therefore, different space vector modulation strategies are considered in theory as well as proven in experiments on a radial magnetic bearing prototype. Finally, the performance of the self-sensing space vector modulation method is verified by an external position measurement system.


  • Open Access

    Control of Active Magnetic Bearings in Turbomolecular Pumps for Rotors with Low Resonance Frequencies of the Blade Wheel

    by Markus Hutterer, Manfred Schrödl

    Rotors with high gyroscopic effects and low resonance frequencies caused by the blade wheel (blade frequencies) can lead to stabilization problems in the application field of turbomolecular pumps. If such a rotor is stabilized by active magnetic bearings, the control structure could be destabilized by the splitting up of the rigid body eigen-frequencies caused by the gyroscopic effect. The control structure of the magnetic bearings can also destabilize the eigen-modes caused by the blade wheel, if the gain of the control structure is too high in the range of the eigen-frequencies of the blade wheel. To deal with the problem of the gyroscopic effect, a decoupling and compensation method was developed based on the inverse dynamics of the rigid body rotor. The gain of the control structure in the range of the blade frequencies is decreased using a Kalman filter. To increase the damping of the system, the predicted states of the linear magnetic bearing model using a Kalman filter are applied instead of the sampled values of the sensors directly. For the decoupled structure, PID controllers are used for stabilization. The functionality of the control structure is verified by a measurement of the current and position signal using the Kalman states and the sensor values. The robustness and performance in the frequency range are verified using the sensitivity and compliance function.