Junchi Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Junchi Li has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Liyi Li
Harbin Institute of Technology
2 shared publications - Mingyi Wang
Department of Electrical Engineering, Harbin Institute of Technology, Harbin, China
2 shared publications - Qiang Tan
College of Automation Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing, China
2 shared publications
Latest Publications
- 1 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 36 (2) , 703-712
Pulsating Magnetic Field of Permanent Magnet Linear Synchronous Motor and Its Influence on Detent Force
For permanent magnet linear synchronous motor (PMLSM), the end effect not only changes the distribution of the end magnetic field, but also causes the pulsating magnetic field in the air gap between the primary and the secondary components. In this paper, the existence of the pulsating magnetic field is proved and the characteristics of the pulsating magnetic field are analyzed through the finite element analysis. On the base of that, the influence of the pulsating magnetic field on the detent force is studied, of which the result shows that the pulsating magnetic field generates the pulsating magnetic force, which is a part of the detent force. The amplitude of the pulsating magnetic force is closely related to the length of the primary component. By adjusting the length of the primary component, the pulsating magnetic field can be effectively suppressed. Moreover, the results of simulation and theoretical analysis prove that with the increase of primary component length, the influence of pulsating magnetic field is becoming weaker and weaker. Finally, a prototype is made to test the detent force characteristics, which verifies the research theory in this paper.
- 1 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 36 (2) , 703-712
Pulsating Magnetic Field of Permanent Magnet Linear Synchronous Motor and Its Influence on Detent Force
For permanent magnet linear synchronous motor (PMLSM), the end effect not only changes the distribution of the end magnetic field, but also causes the pulsating magnetic field in the air gap between the primary and the secondary components. In this paper, the existence of the pulsating magnetic field is proved and the characteristics of the pulsating magnetic field are analyzed through the finite element analysis. On the base of that, the influence of the pulsating magnetic field on the detent force is studied, of which the result shows that the pulsating magnetic field generates the pulsating magnetic force, which is a part of the detent force. The amplitude of the pulsating magnetic force is closely related to the length of the primary component. By adjusting the length of the primary component, the pulsating magnetic field can be effectively suppressed. Moreover, the results of simulation and theoretical analysis prove that with the increase of primary component length, the influence of pulsating magnetic field is becoming weaker and weaker. Finally, a prototype is made to test the detent force characteristics, which verifies the research theory in this paper.
- 7 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 68 (5) , 4120-4130
Research on Noninteger Pole Number for Segmental Permanent Magnet Linear Synchronous Motor
A segmental permanent magnet linear synchronous motor (S-PMLSM) with non-integer pole number, which has low detent force and high thrust, is presented in this paper. For the S-PMLSM, the non-integer pole structure makes up for the defect that the conventional integer pole structure cannot suppress the third and its times harmonics in the detent force, thereby can further reduces the thrust ripple rate of the motor. Special winding arrangement is adopted for non-integer pole structure, of which the winding factor is relatively high. Another advantage of the non-integer pole structure is the decoupling between the detent force and the cogging force. When designing cogging parameters and structures, it is not limited by the requirement of the detent force, which enlarges the range of cogging parameters and finally helps to improve the motor thrust. In this paper, 18-slot 24-pole and 18-slot 19.2-pole S-PMLSMs, representing integer and non-integer pole structures, respectively, are selected as samples for comparative analysis. The results show that the later removes almost all detent force while giving higher thrust than the former. The simulation and experimental results validate the research theory.
- 7 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 68 (5) , 4120-4130
Research on Noninteger Pole Number for Segmental Permanent Magnet Linear Synchronous Motor
A segmental permanent magnet linear synchronous motor (S-PMLSM) with non-integer pole number, which has low detent force and high thrust, is presented in this paper. For the S-PMLSM, the non-integer pole structure makes up for the defect that the conventional integer pole structure cannot suppress the third and its times harmonics in the detent force, thereby can further reduces the thrust ripple rate of the motor. Special winding arrangement is adopted for non-integer pole structure, of which the winding factor is relatively high. Another advantage of the non-integer pole structure is the decoupling between the detent force and the cogging force. When designing cogging parameters and structures, it is not limited by the requirement of the detent force, which enlarges the range of cogging parameters and finally helps to improve the motor thrust. In this paper, 18-slot 24-pole and 18-slot 19.2-pole S-PMLSMs, representing integer and non-integer pole structures, respectively, are selected as samples for comparative analysis. The results show that the later removes almost all detent force while giving higher thrust than the former. The simulation and experimental results validate the research theory.