Ping Long
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ping Long has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Ying Huang
4 shared publications- Guanshi Wang
School of Civil and Surveying & Mapping Engineering, Jiangxi University of Science and Technology, Ganzhou 341000, China
3 shared publications Chao Zhang
2 shared publicationsGuanshi Wang
2 shared publicationsShi-Li Hu
Jiangxi University of Science and Technology
2 shared publicationsSihai Luo
2 shared publications
Latest Publications
- Open Access
- 23 September 2026
- Published by Elsevier in SSRN Electronic Journal
A Chebyshev spectral method for the advection-dominated advection-dispersion equation
Numerical oscillations and dispersion commonly occur in the numerical solution of the solute transport equation when the advection is dominant. A solution strategy based on the Chebyshev spectral method (CSM) is proposed to solve the problem. The advection-dispersion equation (ADE) serves as the governing model, and the CSM is employed to transform the ADE into first-order ordinary differential equations; conventional methods are then used to solve them. The variation of computational error () with the number of Chebyshev nodes (N) is systematically analyzed. The results show that the error decreases rapidly in an L-shaped trend as N increases and then levels off. The knee point of the ~N curve is taken as the lower bound of the number of nodes for CSM, denoted as Ncri. Through comprehensive numerical experiments, the effects of different Péclet numbers (Pe) and source-sink terms on Ncri and computational accuracy are investigated. The results indicate that Ncri increases exponentially with Pe. The upper envelope of the Ncri~Pe curve is used to determine the number of nodes for the CSM, and the relative error in using the CSM to solve the advection-dominated ADE is consistently below 0.30%, which essentially resolves numerical oscillations and dispersion in the numerical solution. Compared with common methods (upwind difference scheme (UDS), weighted essentially non-oscillatory scheme (WENO), and decoupled solution method (DSM)), the ranking of computational accuracy from highest to lowest is: CSM > DSM > WENO > UDS. The proposed method provides a new idea to improve efficiency and precision for advection-dominated solute transport problem
- 23 September 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessA Chebyshev spectral method for the advection-dominated advection-dispersion equation
Numerical oscillations and dispersion commonly occur in the numerical solution of the solute transport equation when the advection is dominant. A solution strategy based on the Chebyshev spectral method (CSM) is proposed to solve the problem. The advection-dispersion equation (ADE) serves as the governing model, and the CSM is employed to transform the ADE into first-order ordinary differential equations; conventional methods are then used to solve them. The variation of computational error () with the number of Chebyshev nodes (N) is systematically analyzed. The results show that the error decreases rapidly in an L-shaped trend as N increases and then levels off. The knee point of the ~N curve is taken as the lower bound of the number of nodes for CSM, denoted as Ncri. Through comprehensive numerical experiments, the effects of different Péclet numbers (Pe) and source-sink terms on Ncri and computational accuracy are investigated. The results indicate that Ncri increases exponentially with Pe. The upper envelope of the Ncri~Pe curve is used to determine the number of nodes for the CSM, and the relative error in using the CSM to solve the advection-dominated ADE is consistently below 0.30%, which essentially resolves numerical oscillations and dispersion in the numerical solution. Compared with common methods (upwind difference scheme (UDS), weighted essentially non-oscillatory scheme (WENO), and decoupled solution method (DSM)), the ranking of computational accuracy from highest to lowest is: CSM > DSM > WENO > UDS. The proposed method provides a new idea to improve efficiency and precision for advection-dominated solute transport problem
- 22 January 2026
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 227, 46-53
Competitive exchange model of aluminium ions and rare earth ions in the leaching of ion-adsorption type rare earth ores
- 22 January 2026
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 227, 46-53
Competitive exchange model of aluminium ions and rare earth ions in the leaching of ion-adsorption type rare earth ores
- Open Access
Ion-Exchange Model for the Leaching Process of Ion-Adsorption-Type Rare-Earth Ores Considering the Influence of Anions
Clay minerals have a specific adsorption capability for anions, which increases the amount of net negative charge on the surface, leading to the increased adsorption of rare-earth ions in clay minerals and some change from exchangeable to non-exchangeable. Further, anions show a shielding effect on rare-earth ions. The shielding capacity of anions in the leaching agents for rare-earth ions was measured in this study. The relationship between the solid-phase concentration of rare-earth ions shielded and the anion concentration was consistent with the Langmuir model. Based on the Kerr model describing the exchange of rare-earth ions by ammonium ions, an ion-exchange model considering the shielding influence of anions was proposed. The accuracy of the proposed model was higher than that of the Kerr model. When the leaching agent was ammonium sulfate, the calculation accuracy of XW and AY samples was increased by 1.15% and 5.75%, respectively. The improvement in accuracy positively correlated with the proportion of iron oxides, aluminium oxides, and Kaolin. The established ion-exchange model can provide accurate source and sink terms for the numerical simulation of the leaching process of ion-adsorption-type rare-earth ores.
Open AccessIon-Exchange Model for the Leaching Process of Ion-Adsorption-Type Rare-Earth Ores Considering the Influence of Anions
Clay minerals have a specific adsorption capability for anions, which increases the amount of net negative charge on the surface, leading to the increased adsorption of rare-earth ions in clay minerals and some change from exchangeable to non-exchangeable. Further, anions show a shielding effect on rare-earth ions. The shielding capacity of anions in the leaching agents for rare-earth ions was measured in this study. The relationship between the solid-phase concentration of rare-earth ions shielded and the anion concentration was consistent with the Langmuir model. Based on the Kerr model describing the exchange of rare-earth ions by ammonium ions, an ion-exchange model considering the shielding influence of anions was proposed. The accuracy of the proposed model was higher than that of the Kerr model. When the leaching agent was ammonium sulfate, the calculation accuracy of XW and AY samples was increased by 1.15% and 5.75%, respectively. The improvement in accuracy positively correlated with the proportion of iron oxides, aluminium oxides, and Kaolin. The established ion-exchange model can provide accurate source and sink terms for the numerical simulation of the leaching process of ion-adsorption-type rare-earth ores.
- Open Access
Decoupling Method for the Convective-Dominated Leaching Process of Ion-Adsorption-Type Rare-Earth Ores
Ion-adsorption-type rare-earth ores (IATREOs) that have experienced granite weathering have good permeability, and their leaching process involves the solute transport problem, which is dominated by convection. Because of the oscillation and dispersion errors of existing numerical methods for solving the convective-dominated solute transport equation, the results have low precision in the twin leaching process. In this paper, the convection–dispersion equation is decoupled into the dispersion equation, the convection equation, and the source-sink equation; the Crank–Nicolson and implicit difference methods are used to solve the dispersion equation and the source-sink equation, respectively. The solution of the convection equation is achieved on the basis of its physical interpretation. Therefore, a decoupling method for the convective-dominated solute transport equation is established. In comparison to the two examples with analytical solutions, the calculation errors of the method established in this paper are less than 2.00%, and it can solve the oscillation and dispersion problems. The rationality of the method is further demonstrated through the column leaching experiment of IATREOs. In comparison to the test results, the coefficients of determination of the breakthrough curves of rare-earth ions and ammonium ions calculated by the proposed method are all greater than 0.850, and the peak concentration error of rare-earth ions is less than 7.00%. This indicates that the proposed method can simulate the leaching process well. Furthermore, by combining the multiple/half method and the dichotomy method, an optimization method for determining the leaching agent amount was established to analyze the relationship between the leaching agent and the ratio of dispersion to pillar length. The results can provide a solution that can be used to mine IATREOs from experience to theory.
Open AccessDecoupling Method for the Convective-Dominated Leaching Process of Ion-Adsorption-Type Rare-Earth Ores
Ion-adsorption-type rare-earth ores (IATREOs) that have experienced granite weathering have good permeability, and their leaching process involves the solute transport problem, which is dominated by convection. Because of the oscillation and dispersion errors of existing numerical methods for solving the convective-dominated solute transport equation, the results have low precision in the twin leaching process. In this paper, the convection–dispersion equation is decoupled into the dispersion equation, the convection equation, and the source-sink equation; the Crank–Nicolson and implicit difference methods are used to solve the dispersion equation and the source-sink equation, respectively. The solution of the convection equation is achieved on the basis of its physical interpretation. Therefore, a decoupling method for the convective-dominated solute transport equation is established. In comparison to the two examples with analytical solutions, the calculation errors of the method established in this paper are less than 2.00%, and it can solve the oscillation and dispersion problems. The rationality of the method is further demonstrated through the column leaching experiment of IATREOs. In comparison to the test results, the coefficients of determination of the breakthrough curves of rare-earth ions and ammonium ions calculated by the proposed method are all greater than 0.850, and the peak concentration error of rare-earth ions is less than 7.00%. This indicates that the proposed method can simulate the leaching process well. Furthermore, by combining the multiple/half method and the dichotomy method, an optimization method for determining the leaching agent amount was established to analyze the relationship between the leaching agent and the ratio of dispersion to pillar length. The results can provide a solution that can be used to mine IATREOs from experience to theory.
- 1 December 2020
- Published by Elsevier in Journal of Rare Earths
- Vol. 38 (12) , 1354-1360
Kinetics model for leaching of ion-adsorption type rare earth ores
- 1 December 2020
- Published by Elsevier in Journal of Rare Earths
- Vol. 38 (12) , 1354-1360
Kinetics model for leaching of ion-adsorption type rare earth ores
- 1 November 2020
- Published by Elsevier in Journal of Rare Earths
- Vol. 38 (11) , 1251-1256
A two-parameter model for ion exchange process of ion-adsorption type rare earth ores
- 1 November 2020
- Published by Elsevier in Journal of Rare Earths
- Vol. 38 (11) , 1251-1256
A two-parameter model for ion exchange process of ion-adsorption type rare earth ores
- 16 January 2020
- Published by Springer Nature in International Journal of Minerals, Metallurgy and Materials
- Vol. 27 (4) , 463-471
A mathematical model for column leaching of ion adsorption-type rare earth ores
- 16 January 2020
- Published by Springer Nature in International Journal of Minerals, Metallurgy and Materials
- Vol. 27 (4) , 463-471
A mathematical model for column leaching of ion adsorption-type rare earth ores
- 1 March 2019
- Published by Elsevier in Transactions of Nonferrous Metals Society of China
- Vol. 29 (3) , 625-633
Simulation of one-dimensional column leaching of weathered crust elution-deposited rare earth ore
- 1 March 2019
- Published by Elsevier in Transactions of Nonferrous Metals Society of China
- Vol. 29 (3) , 625-633
Simulation of one-dimensional column leaching of weathered crust elution-deposited rare earth ore