M. Doll
Research Subjects
M. Doll has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Dmitry Chizhik
Nokia Bell Labs, Murray Hill, NJ, USA
1 shared publication Dmitry Kozlov
Nokia Technology Center, Ulm, Germany
1 shared publicationDragan Samardzija
Nokia Bell Labs, Murray Hill, NJ, USA
1 shared publication- Ignacio Rodriguez
University of Oviedo
1 shared publication J. Diederich
1 shared publication- Jinfeng Du
Nokia Bell Laboratories, Murray Hill, NJ, USA
1 shared publication
Latest Publications
- 30 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (10) , 9596-9606
Directional Measurements and Propagation Models at 28 GHz for Reliable Factory Coverage
Directional measurements of over 2600 links in four distinct factories at 28 GHz are used to formulate path gain and azimuth gain models to allow reliable 90% coverage estimates. A simple theoretical model of path gain, dependent on ceiling and clutter heights, is found to represent path gain across the 4 factories with 4.4 dB RMSE, contrasted with 6.9 dB slope-intercept fit and 8.5 to 14.9 dB RMSE for 3GPP factory models. The model also did well against 3.5 GHz path loss data collected over 18 MHz bandwidth in one of the factories, with RMSE of 3.3 dB. In non-line-of-sight conditions, scattering reduces available antenna azimuth gain from nominal value by up to 7.3 dB in 90% of links. Line of sight blockage by a 1.7 m × 1 m obstacle in factory aisle leads to 7 dB signal reduction, attributed to availability of other paths. It is found that an Access Point (AP) using 25 dBm transmit power per polarization, with 23 dBi nominal gain and omnidirectional terminals, supporting 2×2 MIMO in 400 MHz bandwidth, can provide 130 Mbps for 90% of factory locations within 50 m.
- 30 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (10) , 9596-9606
Directional Measurements and Propagation Models at 28 GHz for Reliable Factory Coverage
Directional measurements of over 2600 links in four distinct factories at 28 GHz are used to formulate path gain and azimuth gain models to allow reliable 90% coverage estimates. A simple theoretical model of path gain, dependent on ceiling and clutter heights, is found to represent path gain across the 4 factories with 4.4 dB RMSE, contrasted with 6.9 dB slope-intercept fit and 8.5 to 14.9 dB RMSE for 3GPP factory models. The model also did well against 3.5 GHz path loss data collected over 18 MHz bandwidth in one of the factories, with RMSE of 3.3 dB. In non-line-of-sight conditions, scattering reduces available antenna azimuth gain from nominal value by up to 7.3 dB in 90% of links. Line of sight blockage by a 1.7 m × 1 m obstacle in factory aisle leads to 7 dB signal reduction, attributed to availability of other paths. It is found that an Access Point (AP) using 25 dBm transmit power per polarization, with 23 dBi nominal gain and omnidirectional terminals, supporting 2×2 MIMO in 400 MHz bandwidth, can provide 130 Mbps for 90% of factory locations within 50 m.
- 22 June 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 42-51
Best-effort low-delay service
- 22 June 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 42-51
Best-effort low-delay service