Yingying Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yingying Chen has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
James C. Baygents
Department of Chemical and Environmental Engineering, University of Arizona, Tucson, USA
6 shared publications- James Farrell
University of Arizona
4 shared publications - Jacob A. Wrubel
National Laboratory of the Rockies
2 shared publications Jake R. Davis
Department of Chemical and Environmental Engineering University of Arizona , Tucson, Arizona 85721, United States
2 shared publicationsJames Farrell
2 shared publications- Kenneth C. Neyerlin
National Renewable Energy Laboratory
2 shared publications
Latest Publications
- 8 February 2022
- Published by Elsevier in Chem Catalysis
- Vol. 2 (2) , 400-421
The effect of catholyte and catalyst layer binders on CO2 electroreduction selectivity
- 8 February 2022
- Published by Elsevier in Chem Catalysis
- Vol. 2 (2) , 400-421
The effect of catholyte and catalyst layer binders on CO2 electroreduction selectivity
- 11 May 2020
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 5 (6) , 1825-1833
A Robust, Scalable Platform for the Electrochemical Conversion of CO2 to Formate: Identifying Pathways to Higher Energy Efficiencies
- 11 May 2020
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 5 (6) , 1825-1833
A Robust, Scalable Platform for the Electrochemical Conversion of CO2 to Formate: Identifying Pathways to Higher Energy Efficiencies
- 8 January 2020
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 167 (11) , 114502
Modeling Water Electrolysis in Bipolar Membranes
Bipolar membranes (BPMs) have proven useful in numerous electrochemical energy conversion and storage applications, including fuel cells and electrolyzers. However, water dissociation in bipolar membrane electrolysis cells (BPMECs) is a complicated phenomenon that occurs via several different pathways. In this work, we develop a model based on the Poisson-Nernst-Planck system that includes a multistep water-dissociation mechanism to observe the fundamental processes that contribute to BPMEC performance. The model, which is validated to in-house experimental data, demonstrates that the junction potential is the most significant contributor to the total electrolysis voltage. We investigated the effects of water-dissociation catalysts and found that the optimal catalyst p K a depends on how the catalyst is integrated into the BPM (although values near 7 are typically best, in accordance with conventional wisdom). We also simulated the water content across the BPM and found that dry-out is not a significant issue when the membrane is in contact with liquid water on both sides. The species conservation approach taken here leads to a physical understanding of the system without using any fitting parameters.
- 8 January 2020
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 167 (11) , 114502
Modeling Water Electrolysis in Bipolar Membranes
Bipolar membranes (BPMs) have proven useful in numerous electrochemical energy conversion and storage applications, including fuel cells and electrolyzers. However, water dissociation in bipolar membrane electrolysis cells (BPMECs) is a complicated phenomenon that occurs via several different pathways. In this work, we develop a model based on the Poisson-Nernst-Planck system that includes a multistep water-dissociation mechanism to observe the fundamental processes that contribute to BPMEC performance. The model, which is validated to in-house experimental data, demonstrates that the junction potential is the most significant contributor to the total electrolysis voltage. We investigated the effects of water-dissociation catalysts and found that the optimal catalyst p K a depends on how the catalyst is integrated into the BPM (although values near 7 are typically best, in accordance with conventional wisdom). We also simulated the water content across the BPM and found that dry-out is not a significant issue when the membrane is in contact with liquid water on both sides. The species conservation approach taken here leads to a physical understanding of the system without using any fitting parameters.
- 6 November 2019
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 50 (1) , 33-40
Water splitting promoted by electronically conducting interlayer material in bipolar membranes
- 6 November 2019
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 50 (1) , 33-40
Water splitting promoted by electronically conducting interlayer material in bipolar membranes
- 1 October 2017
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 19, 18-25
Removing phosphonate antiscalants from membrane concentrate solutions using granular ferric hydroxide
- 1 October 2017
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 19, 18-25
Removing phosphonate antiscalants from membrane concentrate solutions using granular ferric hydroxide
- 1 June 2017
- Published by SAGE Publications in Environmental Engineering Science
- Vol. 34 (6) , 401-409
Understanding Competitive Adsorption of NTMP and Silica on Ferric Hydroxide
Ferric hydroxide adsorbents are commonly used to remove phosphonate antiscalants from membrane concentrate solutions. This research investigated competitive adsorption of nitrilotris(methylenephosphonic acid) (NTMP) and silica on ferric hydroxide. Equilibrium adsorption isotherms were measured and column breakthrough and regeneration experiments were performed for an NTMP adsorbate in simulated membrane concentrate solutions with and without dissolved orthosilicic acid. Quantum chemistry simulations using density functional theory (DFT) were used to evaluate the thermodynamic favorability of possible adsorption mechanisms for NTMP and silica. Column breakthrough experiments showed that 86 mg/L of dissolved silica decreased adsorption of NTMP by 36% after 3,685 bed volumes. DFT modeling indicated that NTMP and silica adsorption on ferric hydroxide may occur through both mono- and bidentate complex formation. NTMP adsorption through a bidentate binuclear complex was 12 kcal/mol more energetically favorable than monodentate complexation. Dimerization reactions between adsorbed silica and dissolved silica greatly increased silica adsorption for dissolved silica concentrations greater than 60 mg/L. DFT modeling and experimental results also indicated that dissolved NTMP may react with adsorbed silica through condensation reactions. Although adsorbed silica decreased the total uptake of NTMP, it increased the efficiency of regeneration by 0.10 M NaOH solutions. This is consistent with adsorbed silica decreasing formation of bidentate binuclear NTMP complexes.
- 1 June 2017
- Published by SAGE Publications in Environmental Engineering Science
- Vol. 34 (6) , 401-409
Understanding Competitive Adsorption of NTMP and Silica on Ferric Hydroxide
Ferric hydroxide adsorbents are commonly used to remove phosphonate antiscalants from membrane concentrate solutions. This research investigated competitive adsorption of nitrilotris(methylenephosphonic acid) (NTMP) and silica on ferric hydroxide. Equilibrium adsorption isotherms were measured and column breakthrough and regeneration experiments were performed for an NTMP adsorbate in simulated membrane concentrate solutions with and without dissolved orthosilicic acid. Quantum chemistry simulations using density functional theory (DFT) were used to evaluate the thermodynamic favorability of possible adsorption mechanisms for NTMP and silica. Column breakthrough experiments showed that 86 mg/L of dissolved silica decreased adsorption of NTMP by 36% after 3,685 bed volumes. DFT modeling indicated that NTMP and silica adsorption on ferric hydroxide may occur through both mono- and bidentate complex formation. NTMP adsorption through a bidentate binuclear complex was 12 kcal/mol more energetically favorable than monodentate complexation. Dimerization reactions between adsorbed silica and dissolved silica greatly increased silica adsorption for dissolved silica concentrations greater than 60 mg/L. DFT modeling and experimental results also indicated that dissolved NTMP may react with adsorbed silica through condensation reactions. Although adsorbed silica decreased the total uptake of NTMP, it increased the efficiency of regeneration by 0.10 M NaOH solutions. This is consistent with adsorbed silica decreasing formation of bidentate binuclear NTMP complexes.
- 17 May 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 50 (11) , 5900-5907
Electrochemical Ion-Exchange Regeneration and Fluidized Bed Crystallization for Zero-Liquid-Discharge Water Softening
This research investigated the use of an electrochemical system for regenerating ion-exchange media and for promoting the crystallization of hardness minerals in a fluidized bed crystallization reactor (FBCR). The closed-loop process eliminates the creation of waste brine solutions that are normally produced when regenerating ion-exchange media. A bipolar membrane electrodialysis stack was used to generate acids and bases from 100 mM salt solutions. The acid was used to regenerate weak acid cation (WAC) ion-exchange media used for water softening. The base solutions were used to absorb CO2 gas and to provide a source of alkalinity for removing noncarbonate hardness by WAC media operated in H+ form. The base solutions were also used to promote the crystallization of CaCO3 and Mg(OH)2 in a FBCR. The overall process removes hardness ions from the water being softened and replaces them with H+ ions, slightly decreasing the pH value of the softened water. The current utilization efficiency for acid and base production was ∼75% over the operational range of interest, and the energy costs for producing acids and bases were an order of magnitude lower than the costs for purchasing acid and base in bulk quantities. Ion balances indicate that the closed-loop system will accumulate SO42–, Cl–, and alkali metal ions. Acid and base balances indicate that for a typical water, small amounts of base will be accumulated.
- 17 May 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 50 (11) , 5900-5907
Electrochemical Ion-Exchange Regeneration and Fluidized Bed Crystallization for Zero-Liquid-Discharge Water Softening
This research investigated the use of an electrochemical system for regenerating ion-exchange media and for promoting the crystallization of hardness minerals in a fluidized bed crystallization reactor (FBCR). The closed-loop process eliminates the creation of waste brine solutions that are normally produced when regenerating ion-exchange media. A bipolar membrane electrodialysis stack was used to generate acids and bases from 100 mM salt solutions. The acid was used to regenerate weak acid cation (WAC) ion-exchange media used for water softening. The base solutions were used to absorb CO2 gas and to provide a source of alkalinity for removing noncarbonate hardness by WAC media operated in H+ form. The base solutions were also used to promote the crystallization of CaCO3 and Mg(OH)2 in a FBCR. The overall process removes hardness ions from the water being softened and replaces them with H+ ions, slightly decreasing the pH value of the softened water. The current utilization efficiency for acid and base production was ∼75% over the operational range of interest, and the energy costs for producing acids and bases were an order of magnitude lower than the costs for purchasing acid and base in bulk quantities. Ion balances indicate that the closed-loop system will accumulate SO42–, Cl–, and alkali metal ions. Acid and base balances indicate that for a typical water, small amounts of base will be accumulated.
- 27 August 2015
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 3 (9) , 2337-2342
Production of Acids and Bases for Ion Exchange Regeneration from Dilute Salt Solutions Using Bipolar Membrane Electrodialysis
- 27 August 2015
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 3 (9) , 2337-2342
Production of Acids and Bases for Ion Exchange Regeneration from Dilute Salt Solutions Using Bipolar Membrane Electrodialysis