James Farrell
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
James Farrell has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
James C. Baygents
Department of Chemical and Environmental Engineering, University of Arizona, Tucson, AZ 85721, USA
7 shared publications- Rodrigo Javier Martínez
Centro de Investigación Y Desarrollo en Electroquímica, S.C., Parque Tecnológico Querétaro, Sanfandila, Pedro Escobedo, Querétaro, Mexico
4 shared publications - Yingying Chen
National Renewable Energy Laboratory, Golden, Colorado 80401, United States
4 shared publications Jake R. Davis
Department of Chemical and Environmental Engineering University of Arizona , Tucson, Arizona 85721, United States
3 shared publications- Andrea Achilli
Department of Chemical and Environmental Engineering, University of Arizona, Tucson, Arizona 85721, United States
2 shared publications Binod K. Chaudhary
Chemical and Environmental Engineering, University of Arizona, Tucson, Arizona
2 shared publications
Latest Publications
- 29 August 2023
- Published by Office of Scientific and Technical Information (OSTI)
Non-Fouling, Low Cost Electrolytic Coagulation & Disinfection for Treating Flowback and Produced Water for Reuse
Executive Summary This Final Report is composed of two major sections. The first section presents experimental results obtained in the laboratory during Budget Period 1. The second section presents results from the field test conducted during Budget Period 2. Laboratory Results This research investigated a novel electrochemical process for producing a ferric iron coagulant for use in treating flowback and produced water from hydraulic fracturing and oil production operations. The treatment system improves the effectiveness and lowers the cost of coagulation processes using Fe3+ as the coagulant. The electrolytic coagulant generation (ECG) system uses an electrochemical cell to produce acid and base from oilfield brine solutions. The acid is used to dissolve scrap iron to provide a Fe3+ coagulating agent. The base is used to neutralize the treated water. Compared to conventional electrocoagulation (EC), the main advantage of the ECG system is an order of magnitude lower cost for the source of iron. The second advantage over conventional EC is that it can deliver Fe3+ doses greater than 1 mM, since it is not limited by the amount of dissolved oxygen in the water required to oxidize ferrous to ferric iron. The capital costs for conventional EC and the ECGmore » system are similar, but the operational costs for the ECG system are an order of magnitude lower than conventional EC. The combined costs for iron and electrical energy for treating 1 m3 of FPW with 1 mM Fe3+ is estimated to be $0.87 for conventional EC, and $0.087 for the ECG system. The estimated all-in cost for treating FPW with a 2 mM Fe3+ dose is $0.73/m3 ($0.12/bbl). Field Test Results The field test was conducted at the Paul Foster Central Tank Battery (CTB) in Lea County, New Mexico from November 10, 2022 through December 15, 2022. The feed water to the system was produced water from the Tatanka 1H formation. After approximately two weeks of testing, the initial batch of produced water had been treated and no untreated produced water was available. Thus, after this time, the feed water to the system consisted of previously treated water (i.e., recycled water). The recycled water had nearly all colloidal particles removed, and had a much lower alkalinity due to precipitation of carbonate minerals during the first pass through the system. Although the recycled water was not an ideal test solution due to its low particulate concentrations, its lower alkalinity did allow us to identify the main problem with the treatment system. The main problem with the treatment system was caused by the high alkalinity of the initial feed water (5.4 meq/L) that consumed a significant fraction of the electrochemically generated acid. This resulted in pH values exiting the iron contact tank that were too high to dissolve enough iron to effectively treat the produced water. Tests performed with recycled water with lower alkalinity did not have this issue, and dissolved iron concentrations greater than 20 mM could be achieved. One consistent observation was that effluent water from the iron contact tank was always free of particulates, even when fed with circumneutral solutions. This suggests that there is no need to dissolve high concentrations of iron if all the water to be treated is passed through the scrap iron canister. In this case, dissolved O2 and hypochlorous acid can promote sufficient iron corrosion to provide an effective coagulating agent – even in neutral pH water. This solves the problem resulting from highly alkaline produced water. Modifications to the design of the treatment system were made based on the field test results. These modifications will add minimal additional cost, and were tested in bench-scale laboratory experiments. In short-term testing, the modified treatment process was able to remove colloidal FeS particulates to levels below detection. Long-term, steady state testing will be required to determine whether the modified process is suitable for commercial treatment systems. « less
- 29 August 2023
- Published by Office of Scientific and Technical Information (OSTI)
Non-Fouling, Low Cost Electrolytic Coagulation & Disinfection for Treating Flowback and Produced Water for Reuse
Executive Summary This Final Report is composed of two major sections. The first section presents experimental results obtained in the laboratory during Budget Period 1. The second section presents results from the field test conducted during Budget Period 2. Laboratory Results This research investigated a novel electrochemical process for producing a ferric iron coagulant for use in treating flowback and produced water from hydraulic fracturing and oil production operations. The treatment system improves the effectiveness and lowers the cost of coagulation processes using Fe3+ as the coagulant. The electrolytic coagulant generation (ECG) system uses an electrochemical cell to produce acid and base from oilfield brine solutions. The acid is used to dissolve scrap iron to provide a Fe3+ coagulating agent. The base is used to neutralize the treated water. Compared to conventional electrocoagulation (EC), the main advantage of the ECG system is an order of magnitude lower cost for the source of iron. The second advantage over conventional EC is that it can deliver Fe3+ doses greater than 1 mM, since it is not limited by the amount of dissolved oxygen in the water required to oxidize ferrous to ferric iron. The capital costs for conventional EC and the ECGmore » system are similar, but the operational costs for the ECG system are an order of magnitude lower than conventional EC. The combined costs for iron and electrical energy for treating 1 m3 of FPW with 1 mM Fe3+ is estimated to be $0.87 for conventional EC, and $0.087 for the ECG system. The estimated all-in cost for treating FPW with a 2 mM Fe3+ dose is $0.73/m3 ($0.12/bbl). Field Test Results The field test was conducted at the Paul Foster Central Tank Battery (CTB) in Lea County, New Mexico from November 10, 2022 through December 15, 2022. The feed water to the system was produced water from the Tatanka 1H formation. After approximately two weeks of testing, the initial batch of produced water had been treated and no untreated produced water was available. Thus, after this time, the feed water to the system consisted of previously treated water (i.e., recycled water). The recycled water had nearly all colloidal particles removed, and had a much lower alkalinity due to precipitation of carbonate minerals during the first pass through the system. Although the recycled water was not an ideal test solution due to its low particulate concentrations, its lower alkalinity did allow us to identify the main problem with the treatment system. The main problem with the treatment system was caused by the high alkalinity of the initial feed water (5.4 meq/L) that consumed a significant fraction of the electrochemically generated acid. This resulted in pH values exiting the iron contact tank that were too high to dissolve enough iron to effectively treat the produced water. Tests performed with recycled water with lower alkalinity did not have this issue, and dissolved iron concentrations greater than 20 mM could be achieved. One consistent observation was that effluent water from the iron contact tank was always free of particulates, even when fed with circumneutral solutions. This suggests that there is no need to dissolve high concentrations of iron if all the water to be treated is passed through the scrap iron canister. In this case, dissolved O2 and hypochlorous acid can promote sufficient iron corrosion to provide an effective coagulating agent – even in neutral pH water. This solves the problem resulting from highly alkaline produced water. Modifications to the design of the treatment system were made based on the field test results. These modifications will add minimal additional cost, and were tested in bench-scale laboratory experiments. In short-term testing, the modified treatment process was able to remove colloidal FeS particulates to levels below detection. Long-term, steady state testing will be required to determine whether the modified process is suitable for commercial treatment systems. « less
- 8 August 2023
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 3 (9) , 2883-2889
Electrolytic Coagulant Generation for Treating Flowback and Produced Water for Reuse
- 8 August 2023
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 3 (9) , 2883-2889
Electrolytic Coagulant Generation for Treating Flowback and Produced Water for Reuse
- 1 April 2020
- Vol. 6 (2) , 218-225
Alkaline Stability of Novel Aminated Polyphenylene-Based Polymers in Bipolar Membranes
- 1 April 2020
- Vol. 6 (2) , 218-225
Alkaline Stability of Novel Aminated Polyphenylene-Based Polymers in Bipolar Membranes
- 6 November 2019
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 50 (1) , 33-40
Water splitting promoted by electronically conducting interlayer material in bipolar membranes
- 6 November 2019
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 50 (1) , 33-40
Water splitting promoted by electronically conducting interlayer material in bipolar membranes
- 1 September 2019
- Published by Elsevier in Computational and Theoretical Chemistry
- Vol. 1164
Water splitting activity of oxygen-containing groups in graphene oxide catalyst in bipolar membranes
- 1 September 2019
- Published by Elsevier in Computational and Theoretical Chemistry
- Vol. 1164
Water splitting activity of oxygen-containing groups in graphene oxide catalyst in bipolar membranes
- Open Access
- 19 July 2019
- Published by Wiley in ChemElectroChem
- Vol. 6 (17) , 4330-4331
Trends in Synthetic Diamond for Electrochemical Applications
- 19 July 2019
- Published by Wiley in ChemElectroChem
- Vol. 6 (17) , 4330-4331
Open AccessTrends in Synthetic Diamond for Electrochemical Applications
- 1 June 2017
- Published by SAGE Publications in Environmental Engineering Science
- Vol. 34 (6) , 401-409
Understanding Competitive Adsorption of NTMP and Silica on Ferric Hydroxide
Ferric hydroxide adsorbents are commonly used to remove phosphonate antiscalants from membrane concentrate solutions. This research investigated competitive adsorption of nitrilotris(methylenephosphonic acid) (NTMP) and silica on ferric hydroxide. Equilibrium adsorption isotherms were measured and column breakthrough and regeneration experiments were performed for an NTMP adsorbate in simulated membrane concentrate solutions with and without dissolved orthosilicic acid. Quantum chemistry simulations using density functional theory (DFT) were used to evaluate the thermodynamic favorability of possible adsorption mechanisms for NTMP and silica. Column breakthrough experiments showed that 86 mg/L of dissolved silica decreased adsorption of NTMP by 36% after 3,685 bed volumes. DFT modeling indicated that NTMP and silica adsorption on ferric hydroxide may occur through both mono- and bidentate complex formation. NTMP adsorption through a bidentate binuclear complex was 12 kcal/mol more energetically favorable than monodentate complexation. Dimerization reactions between adsorbed silica and dissolved silica greatly increased silica adsorption for dissolved silica concentrations greater than 60 mg/L. DFT modeling and experimental results also indicated that dissolved NTMP may react with adsorbed silica through condensation reactions. Although adsorbed silica decreased the total uptake of NTMP, it increased the efficiency of regeneration by 0.10 M NaOH solutions. This is consistent with adsorbed silica decreasing formation of bidentate binuclear NTMP complexes.
- 1 June 2017
- Published by SAGE Publications in Environmental Engineering Science
- Vol. 34 (6) , 401-409
Understanding Competitive Adsorption of NTMP and Silica on Ferric Hydroxide
Ferric hydroxide adsorbents are commonly used to remove phosphonate antiscalants from membrane concentrate solutions. This research investigated competitive adsorption of nitrilotris(methylenephosphonic acid) (NTMP) and silica on ferric hydroxide. Equilibrium adsorption isotherms were measured and column breakthrough and regeneration experiments were performed for an NTMP adsorbate in simulated membrane concentrate solutions with and without dissolved orthosilicic acid. Quantum chemistry simulations using density functional theory (DFT) were used to evaluate the thermodynamic favorability of possible adsorption mechanisms for NTMP and silica. Column breakthrough experiments showed that 86 mg/L of dissolved silica decreased adsorption of NTMP by 36% after 3,685 bed volumes. DFT modeling indicated that NTMP and silica adsorption on ferric hydroxide may occur through both mono- and bidentate complex formation. NTMP adsorption through a bidentate binuclear complex was 12 kcal/mol more energetically favorable than monodentate complexation. Dimerization reactions between adsorbed silica and dissolved silica greatly increased silica adsorption for dissolved silica concentrations greater than 60 mg/L. DFT modeling and experimental results also indicated that dissolved NTMP may react with adsorbed silica through condensation reactions. Although adsorbed silica decreased the total uptake of NTMP, it increased the efficiency of regeneration by 0.10 M NaOH solutions. This is consistent with adsorbed silica decreasing formation of bidentate binuclear NTMP complexes.