Murodbek Kuralov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Murodbek Kuralov has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jasurjon Akhatov
Doctor of Technical Sciences, Professor, S. A. Azimov Physical-Technical Institute, Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan
2 shared publications - Abdurauf Usmanov
Physical-Technical Institute, Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan
1 shared publication - Akbar Halimov
Physical-Technical Institute, Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan
1 shared publication D. U. Abdukhamidov
Solar Physics, AN RUz
1 shared publication- Ergashali Y. Rakhimov
Hydrometeorological Research Institute, Tashkent 100052, Uzbekistan; Central Asian University of Environmental and Climate Change Studies (Green University), Tashkent 111104, Uzbekistan
1 shared publication Sh. B. Imomov
Karshi Engineering Economic Institute
1 shared publication
Latest Publications
- 7 September 2026
- Published by Science and Innovation LLC
- Vol. 5 (8) , 50-68
REVERSE OSMOSIS MEMBRANES UNDER DUTY-CYCLED OPERATION: COMPACTION, SCALING, BIOFILM REGROWTH AND PERMEATE TRANSIENTS IN PHOTOVOLTAIC-DRIVEN BRACKISH DESALINATION
Photovoltaic-driven reverse osmosis is the dominant architecture for decentralised brackish-water supply in arid regions, yet it violates the condition under which almost all membrane performance data are obtained: steady pressure, steady flux and continuous operation. This review assembles the evidence on how the polyamide membrane itself, considered as a mechanical and biological object, responds to duty cycling, and reconciles findings that disagree in sign rather than merely in magnitude. Primary studies published between 2006 and 2026 were coded against a purpose-built parameterisation of non-steady operation comprising duty cycle, stop duration, cycle count, ramp rate, fluctuation amplitude and frequency, minimum-flux floor, idle-state fluid, flush protocol and buffering. Four membrane-side consequences are examined: irreversible compaction and creep recovery across repeated pressurisation; scaling induction time relative to residence time at peak supersaturation; biological regrowth during idle intervals; and permeate-quality transients on restart. Reported outcomes span a permeability loss exceeding fifty per cent after seven days of cycling and no measurable degradation after 1,568 start-stop cycles. Three variables reconcile most of that disagreement: idle-state chemistry, spontaneous osmotic backwash on depressurisation, and the partition between reversible compaction of the active layer and irreversible compaction of the support. No located study varies shutdown duration as a controlled independent variable against a biological endpoint on a membrane, and an experimental design closing that gap is specified.
- 7 September 2026
- Published by Science and Innovation LLC
- Vol. 5 (8) , 50-68
REVERSE OSMOSIS MEMBRANES UNDER DUTY-CYCLED OPERATION: COMPACTION, SCALING, BIOFILM REGROWTH AND PERMEATE TRANSIENTS IN PHOTOVOLTAIC-DRIVEN BRACKISH DESALINATION
Photovoltaic-driven reverse osmosis is the dominant architecture for decentralised brackish-water supply in arid regions, yet it violates the condition under which almost all membrane performance data are obtained: steady pressure, steady flux and continuous operation. This review assembles the evidence on how the polyamide membrane itself, considered as a mechanical and biological object, responds to duty cycling, and reconciles findings that disagree in sign rather than merely in magnitude. Primary studies published between 2006 and 2026 were coded against a purpose-built parameterisation of non-steady operation comprising duty cycle, stop duration, cycle count, ramp rate, fluctuation amplitude and frequency, minimum-flux floor, idle-state fluid, flush protocol and buffering. Four membrane-side consequences are examined: irreversible compaction and creep recovery across repeated pressurisation; scaling induction time relative to residence time at peak supersaturation; biological regrowth during idle intervals; and permeate-quality transients on restart. Reported outcomes span a permeability loss exceeding fifty per cent after seven days of cycling and no measurable degradation after 1,568 start-stop cycles. Three variables reconcile most of that disagreement: idle-state chemistry, spontaneous osmotic backwash on depressurisation, and the partition between reversible compaction of the active layer and irreversible compaction of the support. No located study varies shutdown duration as a controlled independent variable against a biological endpoint on a membrane, and an experimental design closing that gap is specified.
- Open Access
- 14 May 2026
- Published by Atlantis Press SARL
- p. 468-477
Taguchi-Based Optimization of Air-Gap Membrane Distillat
- 14 May 2026
- Published by Atlantis Press SARL
- p. 468-477
Open AccessTaguchi-Based Optimization of Air-Gap Membrane Distillat
- 1 October 2016
- Published by Allerton Press in Applied Solar Energy
- Vol. 52 (4) , 305-308
The evaluation of heat capacity and choice of materials for short-term storage of diurnal solar heat surplus in passive solar heating systems
The results of numerical studies aimed to evaluate the heat capacity of short-term phase change heat accumulators applied in passive solar heating systems (PSHS) with a three-layer energy active translucent enclosure (TE) are presented. An example is given of calculation of specific (per unit of TE surface area) weight of heat accumulator using dimethyl sulfoxide, (СН3)2SO, with melting temperature 18.6°C and latent heat of phase transition 173 kJ/kg, as the heat storage agent.
- 1 October 2016
- Published by Allerton Press in Applied Solar Energy
- Vol. 52 (4) , 305-308
The evaluation of heat capacity and choice of materials for short-term storage of diurnal solar heat surplus in passive solar heating systems
The results of numerical studies aimed to evaluate the heat capacity of short-term phase change heat accumulators applied in passive solar heating systems (PSHS) with a three-layer energy active translucent enclosure (TE) are presented. An example is given of calculation of specific (per unit of TE surface area) weight of heat accumulator using dimethyl sulfoxide, (СН3)2SO, with melting temperature 18.6°C and latent heat of phase transition 173 kJ/kg, as the heat storage agent.