ZZZhenghua Zhou

Zhenghua Zhou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhenghua Zhou has a total of 56 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Grid‐reinforced hybrid fiber high‐performance concrete strengthened RC columns: Experimental investigation on axial compression behavior

    by Zhu Bian, Yi Han, Liting Du, Cheng Peng, Jiacong He, Deguang Li, Zhenghua Zhou

    To investigate the axial compressive behavior of reinforced concrete (RC) columns strengthened with novel composite materials, grid‐reinforced hybrid fiber high‐performance concretes (GR‐HyFHPCs) were developed. These composites combine rigid grids with a hybrid fiber high‐performance concrete (HyFHPC) matrix incorporating both steel and polyethylene (PE) fibers. Short RC cylinders were fabricated and categorized into three groups: unstrengthened, HyFHPC‐strengthened, and GR‐HyFHPC‐strengthened specimens. Key variables included the type of grid and the number of grid layers embedded in the HyFHPC. Axial compression tests were conducted to evaluate cracking behavior, failure modes, load–displacement responses, and load‐strain characteristics. The results demonstrated that GR‐HyFHPC‐confined specimens exhibited uniformly distributed surface cracking and a more gradual post‐peak load decline, indicating enhanced structural stability. Both compressive strength and deformation capacity were significantly improved, particularly in specimens reinforced with fiber‐reinforced polymer (FRP) grids—basalt grid (BG) and carbon grid (CG)—which showed notable improvements in ductility. Based on theoretical derivations and experimental data, predictive equations for the axial compressive load‐bearing capacity of RC columns confined with GR‐HyFHPC were developed and validated, showing good agreement with the experimental results. Additional experimental data are required to further refine the model and improve its general applicability.

  • Analysis of acceleration dominant azimuth distribution characteristics of Hualien MS7.3 earthquake

    by Xueliang Duan, Yanqiong Liu, Bian Zhu, Liting Du, Long Zhang, Cheng Peng, Yonghao Li, Zhenghua Zhou

  • Open Access

    Experimental Study on Dynamic Response Characteristics of Rural Residential Buildings Subjected to Blast-Induced Vibrations

    by Jingmin Pan, Dongli Zhang, Zhenghua Zhou, Jiacong He, Long Zhang, Yi Han, Cheng Peng, Sishun Wang

    Numerous rural residential buildings exhibit inadequate seismic performance when subjected to blast-induced vibrations, which poses potential threats to their overall stability and structural integrity when in proximity to blasting project sites. The investigation conducted in conjunction with the Qianshi Mountain blasting operations along the Wenzhou segment of the Hangzhou–Wenzhou High-Speed Railway integrates household field surveys and empirical measurements to perform modal analysis of rural residential buildings through finite element simulation. Adhering to the principle of stratified arrangement and composite measurement point configuration, an effective and reasonable experimental observation framework was established. In this investigation, the seven-story rural residential building in adjacent villages was selected as the research object. Strong-motion seismographs were strategically positioned adjacent to frame columns on critical stories (ground, fourth, seventh, and top floors) within the observational system to acquire test data. Methodical signal processing techniques, including effective signal extraction, baseline correction, and schedule conversion, were employed to derive temporal dynamic characteristics for each story. Combined with the Fourier transform, the frequency–domain distribution patterns of different floors are subsequently obtained. Leveraging the structural dynamic theory, time–domain records were mathematically converted to establish the structure’s maximum response spectra under blast-induced loading conditions. Through the analysis of characteristic curves, including floor acceleration response spectra, dynamic amplification coefficients, and spectral ratios, the dynamic response patterns of rural residential buildings subjected to blast-induced vibrations have been elucidated. Following the normalization of peak acceleration and velocity parameters, the mechanisms underlying differential floor-specific dynamic responses were examined, and the layout principles of measurement points were subsequently formulated and summarized. These findings offer valuable insights for enhancing the seismic resilience and structural safety of rural residential buildings exposed to blast-induced vibrations, with implications for both theoretical advancements and practical engineering applications.


  • Open Access

    Impact of Train Formation on the Dynamic Responses and Operational Safety of High-Speed Trains under Non-Uniform Seismic Ground Motion

    by Kangming Zhong, Xiaojun Li, Zhenghua Zhou

    The study of dynamic responses and operational safety of high-speed trains under seismic excitation has increasingly relied on numerical simulation as the most effective and convenient research approach. The majority of studies only focus on single-car formation, and fewer utilize train models with actual standard formation, inevitably resulting in differences in dynamic characteristics of train models and simulation results. Furthermore, trains also have different standard formations in different countries and operating scenarios. Therefore, the influences of train formation on the dynamic responses and operational safety of trains under seismic action are investigated. Hence, a detailed train/vehicle–track coupled dynamics model was established to simulate trains under non-uniform seismic ground motion. Moreover, due to wheel–rail contact simulation being the key factor constraining simulation efficiency, based on the influence pattern of train formation, whether fewer train formations can achieve the same simulation accuracy as the 8-car standard formation is also explored in this paper considering seismic wave propagation effect. Results indicate that variation in train formation can influence the dynamic responses of a coupled system significantly from both the perspective of wheel–rail interaction and vehicle kinematic responses. Moreover, the 5-car formation model can better meet the accuracy requirement and significantly improve computational efficiency compared to 8-car formation model.


  • Open Access

    Peak Acceleration Distribution on the Surface of Reef Islands under the Action of Vertical Ground Motion

    by Liguo Jin, Liting Du, Zhenghua Zhou, Xin Bao

    This paper adopts the fluid–structure coupling algorithm based on the acoustic fluid element, the fluid dynamic artificial boundary, and the consistent viscoelastic artificial boundary of solid media to establish a finite element model of the dynamic interaction of the reef-island–seawater system. Then, a numerical simulation of the seismic response of the reef-island site is carried out to study the seismic ground motion distribution patterns of the reef–seawater site and the reef-island–lagoon site. The innovation of this article is that the influence of reef–island topography and fluid–structure coupling is considered in the analysis when vertical ground motion is input. The results show that the slope angle of the bottom layer has a significant influence on the peak ground acceleration distribution and peak size on the island slope surface and the reef platform. For high-frequency input motion, a smaller reef platform width will induce a larger peak acceleration response on the reef platform. Seawater has a significant suppressive effect on vertical ground acceleration. The more high-frequency components of the input bedrock motion, the more obvious this suppression effect will be. The existence of the lagoon will amplify the maximum peak acceleration on the reef platform. According to the calculation results, lagoon terrain can amplify the maximum horizontal and vertical peak accelerations on the reef platform by about 19 and 6 times relative to the free-field results, respectively.


  • Open Access

    Analysis of Strong Ground Motion Characteristics for the Jishishan MS6.2 Earthquake December 18, 2023

    by Duan Xueliang, Liu Yanqiong, Zhou Zhenghua, Bian Zhu, Han Yi, He Jiacong, Peng Chen, Zhang Long

    The MS6.2 earthquake occurred in Jishishan, Gansu Province, China, on December 18, 2023. Based on some strong seismic acceleration time histories captured by some stations of China National Strong Earthquake Observation Network and National Earthquake Early Warning Network, the spatial distribution characteristics, rupture directivity effect, hanging wall and footwall effect, response spectrum characteristics, and attenuation of the peak ground acceleration (PGA) were analyzed in this paper. It can be used as reference for the site determination of post‐earthquake reconstruction and seismic design of engineering structures. The analysis shows that the spatial distribution of strong ground motion of the Jishishan MS6.2 earthquake is mainly controlled by the distribution of causative fault. Near the fault, the effect of rupture directivity is obvious. The effect of hanging wall and footwall significantly affects the distribution of PGAs for this earthquake, causing a pronounced asymmetric pattern about PGAs relative to the fault, with slower attenuation on the hanging wall compared to the footwall. The type of site obviously affects the characteristics of response spectrum. The ground motion intensity observed at the epicenter of this earthquake significantly exceeded the levels of rare and extremely rare seismic events in the current seismic design codes. The attenuation relationship of PGA obtained by regression analysis shows that ones in the 5th generation Chinese ground motion parameter zoning map for the Qinghai‐Tibet region underestimate the horizontal PGA.


  • Open Access

    Surface Motion for P-Wave Scattering by an Arbitrary-Shaped Canyon in Saturated Half-Space

    by Xueliang Duan, Liguo Jin, Zhenghua Zhou

    This paper obtained a semianalytical solution for the P-wave scattering problem by an arbitrary-shaped canyon in a saturated half-space by using Biot’s theory, the wave function expansion method, and the moments method. Firstly, based on the Biot fluid-saturated porous media theory and the wave function expansion method, the wave potentials which automatically satisfy the zero-stress boundary condition on the surface of the half-space are obtained. Then, the boundary value problem is transformed into an algebraic problem by the method of moments according to the boundary conditions, and then solved numerically by truncation. By adjusting the parameters, the saturated medium in the original model approximately degenerates into a single-phase elastic medium, and the correctness of the proposed method is verified by comparing it with published results. Finally, the effects of the canyon shape, the porosity of the soil, and the incidence angle and frequency of the incident wave on the amplitude of ground surface motion are investigated. The results show that the incidence angle has a significant effect on the ground surface motion, while the porosity of the soil has little influence on the amplitude of surface motion. The influence of canyon shape on surface motion is mainly reflected in the shielding effect on the incident wave. Although P-wave scattering by a canyon is a traditional problem, most of the analytical solutions are limited to solving the scattering of seismic waves in geometric regular canyons. However, the actual shape of the canyon is not regular, which limits the application of closed analytical solutions in practical engineering. In this paper, the scattering of P-waves in arbitrary-shaped canyons is successfully solved by using a semianalytical method combined with a numerical method-moments method, which provides a possibility for engineering application.


  • Open Access

    Influence of Borehole Casing on Received Signals in Downhole Method

    by Shi Yan, Yan Yu, Wenjun Zheng, Jie Su, Zhenghua Zhou

    Borehole shrinkage and collapse are likely to occur when downhole testing is conducted in soft or loose sandy soils, resulting in testing interruption. To prevent this situation from occurring, installing casing in the borehole is a common approach. However, in actual testing, the quality of the signal obtained from measuring points within the depth of the casing is often not ideal, and there is still no clear and unified justification for the causes of interference generated by the casing. Therefore, the team attempt to investigate and elucidate the impact of casing through on-site experiments and numerical simulations. Firstly, on-site tests on the impact of different materials of casing on the wave velocity test utilizing the downhole method are conducted, the waveform characteristics of the measurement points inside the PVC casing and steel casing boreholes are analyzed, and the usability of the test results are evaluated. Next, the contact state between shallow soil and casing is changed, and its impact on the waveform characteristics of signal at different depth measurement points is analyzed. Then, the ABAQUS finite element software is utilized to establish a three-dimensional finite element model for wave velocity testing using the casing method, and the dynamic response of the measuring points on the casing wall inside the hole under surface excitation is solved. By numerically simulating different casing materials, the contact state between the casing and the hole wall, and the presence of low wave velocity filling soil around the casing, the variation patterns of the affected measurement point signals in the time and frequency domains are investigated. Furthermore, combined with the measured data, the impact characteristics of the casing on the results of the wave velocity testing using the downhole method are systematically explored. This research can provide some insights for the application and data interpretation of signals in the downhole methods of cased wells.