AAAmmar Salih Abbas

Ammar Salih Abbas

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ammar Salih Abbas has a total of 99 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Photo-Fenton oxidation of organic contaminants in wastewater over TiO 2 -ZnO/modified iron-exchanged zeolites: kinetics study and simulation using dispersion-based model

    by Rawan H. Ali, Sami M. Zaboon, Ammar S. Abbas

    Organic pollutants present in the wastewater of an oil refinery were oxidized using the advanced photo-Fenton oxidation method with a heterojunction-based photocatalyst consisting of titanium dioxide and zinc oxide nanoparticles deposited on an iron-modified zeolite substrate. The effects of temperature and reaction time on removal efficiency were systematically studied, based on the reduction in chemical oxygen demand, at temperatures ranging from 25 to 60 °C, up to 120 min. A kinetic model was developed to describe the kinetic data of the change in organic content over time at different temperatures. Activation energies were measured for the reaction constants, and the thermodynamic parameters associated with the activation step were evaluated. Subsequently, a dispersion model relied on reaction kinetics, dispersion number, and residence time to simulate the efficiency of different reactors in removing organic contaminants and to compare the performance of ideal and non-ideal flow systems. Simulated results for a dispersion-based model confirmed that an ideal tubular flow reactor has a higher efficiency in breaking down organic pollutants compared to its non-ideal counterpart. Increasing the axial dispersion led to a gradual decline in reactor performance, culminating in the lowest performance, where the lowest conversion rate was observed under fully mixed flow conditions. These results highlight the crucial role of both catalyst design and reactor dynamics in optimizing photocatalytic Fenton systems for the oxidation of organic contaminants in aqueous solutions.

  • Open Access

    Experimental and Simulation Study on Removing Congo Red Dye from Neutral Wastewater Using Green Activated Carbon

    by Hind Thwaini, Ammar S. Abbas, Rasha Salman, Sarmad Al-Anssari

    The removal of Congo red dye from industrial wastewater before its discharge to the environment is a critical problem, as it is non-biodegradable, toxic, and carcinogenic. Activated carbon was synthesized from a suggested sustainable source (sugarcane waste) and used as an adsorbent for the dye. Isotherm adsorption models and adsorption kinetics were investigated, and a simulated adsorption column model was proposed and developed based on the modified general rate model. The batch results showed that the highest removal rate achieved was 87.1% of the initial dye concentration (30 mg/L). The Freundlich isotherm model best described the equilibrium data, as evidenced by the high correlation coefficient (0.9535). Meanwhile, the maximum adsorption capacity was found to be 149.25 mg/g using the Langmuir isotherm. Furthermore, the kinetic results indicate that the pseudo-second-order model accurately describes the concentration-time relationship. A simulated maximum dynamic adsorption capacity of 0.096 mg/g was achieved at an optimal volumetric flow rate of 0.1 mL/min, with a dye concentration of 30 mg/L and a bed length of 39.69 cm. The continuous column efficiency increased with column length, reaching a maximum of 75% at 66.15 cm. Also, as the dye concentration increased, the column efficiency and dynamic adsorption capacity decreased. The study demonstrated an innovative approach to removing Congo red dye from its aqueous solution in a neutral medium using sustainably produced activated carbon derived from a sustainable source. A continuous removal process was simulated by developing a mathematical model based on adsorption curves and adsorption kinetics, which successfully described the adsorption process. This type of modeling, rather than relying on pre-existing equations, enables more efficient, scalable design.

  • Open Access

    Effect of Fe(II) addition by ion exchange and precipitation of different semiconductors on the textural properties of 13X zeolite

    by Rawan H. Ali, Sami M. Zaboon, Ammar S. Abbas

    This study investigated the textural properties of 13X zeolite, FeX zeolite, TiO2/FeX zeolite, ZnO/FeX zeolite, and TiO2+ZnO/FeX zeolite using nitrogen adsorption-desorption data at consistent low temperatures. The adsorption-desorption isotherm indicated that the studied materials have a type IV mesoporous structure, as defined by the International Union of Pure and Applied Chemistry. The results of nitrogen adsorption data analysis using the Langmuir, Freundlich, and Brunauer-Emmett-Teller models indicated that the data were best described by the Brunauer-Emmett-Teller model. The Barrett, Joyner, and Halenda model was used to analyze the pore size distribution, pore diameter, and average pore volume of the adsorbents. After the ion exchange and loading process, there was a notable decrease in surface area and pore size distribution values, while the reduction in pore volume was minimal. Zeolite 13X showed a larger pore diameter, suggesting that some structural damage or the formation of wider pores within the mesoporous range occurred during the ion exchange steps or modification by the addition of semiconductor oxides. In contrast, the FeX zeolite exhibited a smaller pore size, indicative of a more compact microporous structure. While the modified zeolites—TiO2, ZnO, and TiO2+ZnO—demonstrated a consistent pore structure, suggesting stable mesoporosity with a smaller pore size, this implies that some of the zeolite's pores were blocked or filled with TiO2 and ZnO particles.


  • Open Access

    Which Cultural Dimensions Predict Variations in Emotional Conformity? An Extension of Vishkin et al. (2023) Across 28 Nations

    by Peter B. Smith, Alexander Kirchner-Häusler, Lusine Grigoryan, Vivian Miu-Chi Lun, Olga Lopukhova, Lorena Perez Floriano, Paola Eunice Diaz Rivera, Ammar Abbas, Antonia Papastylianou, Doriana Tripodi, et al.

    Despite being a classic social psychology topic, cultural variability in conformity has only been examined systematically in the last few decades. Vishkin et al. reported evidence that conformity of experienced emotions and of valued emotions is stronger in individualistic cultures. We tested the replicability of this finding using data from 28 nations ( N = 6,168), incorporating two further relevant cultural predictors of cultural differences: flexibility-monumentalism and tightness-looseness. Contrasting effects regarding valence were found for conformity of experienced emotions and of valued emotions. Conformity of experienced positive emotions and of valued negative emotions was predicted by individualism, monumentalism, and looseness. The results are discussed in terms of the distinction between injunctive and descriptive norms and cultural variations in the salience of positive and negative emotions. Using additional indicators of cultural difference yields a fuller understanding of these effects than that provided by the contrast between individualism and collectivism. The use of deviation scores provides a useful operationalization of variations in conformity.


  • Open Access

    Challenges and future directions in photoelectro-Fenton techniques: A comprehensive review of emerging applications and innovations

    by Ihsan H. Dakhil, Ammar S. Abbas

    This comprehensive review examines the fundamental principles and practical applications of heterogeneous electrochemical wastewater treatment utilizing Fenton's reactions. The fundamental equations involved in generating hydroxyl-free radicals in electro-Fenton and photoelectro-Fenton processes have been reviewed. Photoelectro-Fenton processes have been proven to be the most effective methods for mineralizing and degrading pollutants in wastewater. The primary focus is on understanding the limitations of hybrid Fenton processes and proposing practical solutions to address these challenges. Additionally, the study evaluated the significance of electrode configuration development and light penetration enhancement in promoting hydrogen peroxide production and enhancing hydroxyl radical generation. These improvements contribute to the enhanced degradation and mineralization of contaminants in groundwater. A comparative analysis of electrode materials, novel reactor configurations, and operating conditions demonstrates the relationship between preparation methods and treatment efficiency. Research gaps for improving the photoelectro-Fenton process are identified, with suggestions for future work. Studies have shown that internal light irradiation leads to higher removal efficiency compared to external lighting systems with the same light source power. The most important recommendations were utilizing multi-electrode stacked reactors to reduce energy consumption, enhancing current efficiency, the shape of the electrodes also plays a vital role in increasing light exposure on the photoanode surfaces, and conducting long-term experiments with various contaminants to demonstrate the reactor's stability, efficiency, and efficacy in treating industrial wastewater.


  • Congo red dye removal from aqueous solutions by photocatalytic redox reactions: Degradation kinetics and simulation using dispersion model

    by Rusul Jassim, Ammar Abbas

    This study degrades Congo red dye in aqueous solutions using redox reactions and Anatase nano-TiO2 as a catalyst, examining the kinetics of photodegradation through redox reactions. Then, a model based on the dispersion number estimates the efficiency of different plug flow reactors (ideal and nonideal flow states up to a mixed flow reactor). The photocatalytic redox reactions were carried out in a closed batch photoreactor using 0.2 g/L Anatase nano-TiO2 as a catalyst to remove different initial concentrations (32, 71, and 178 ppm COD) of the dye from its neutral aqueous solutions at 40 oC. The air was supplied to the reactor as an oxygen source at 0.2 L/min. The COD removal values decreased with the increasing initial dye concentration, and the best removal value was recorded (89.47 %) for the lowest initial COD (32 ppm) after 255 minutes of radiation. The kinetics study showed that the dye removal followed a first-order reaction model. Effects of initial concentration, dispersion number, and space-time on the organic distribution through the reactors were studied and discussed using a developed mathematical model based on the dispersion approach for the nonideal flow in reactors. The simulated results show that the ideal plug flow reactor (zero dispersion) performance was better than that of the nonideal plug flow reactor, and the performance decreased with the increasing dispersion number and gave the worst performance in the mixed flow reactor (infinity dispersion).


  • Open Access

    Comparative study for degradation of Congo red dye from synthetic wastewater by photocatalytic redox reactions using various nanoscale semiconductors

    by Rusul A. Jassim, Ammar S. Abbas

    A comparative study for two nanoscale semiconductors (TiO2 and WO3) was conducted as heterogeneous photocatalysts to degrade about 50 ppm of Congo red dye in an aqueous solution. The reaction was carried out in a batch reactor placed in a dark box and equipped with an air pump. The dye solution and 0.2 g/L of the catalyst were mixed, firstly, in a dark environment to monitor the amount of adsorbed dye, then the ultraviolet light was turned on with two different powers (15 and 30 W) to study the photocatalytic degradation reactions. The results showed that TiO2 had higher photocatalytic activity to degrade the dye. The CRD removal values for TiO2 and WO3 were 99.67 and 72.16 %, respectively, using 15 W, and the UV power did not have a significant effect on redox reactions according to the observations and the electrical energy consumption. The reaction kinetics study showed that the results obtained followed a first-order kinetics model. A mathematical model was developed based on the recycle ratio approach to study the effects of the recycle ratio and space-time on the Congo red dye removal through the different types of reactors. The simulated results showed that the ideal plug flow reactor performance gave the highest removal in less space-time than the recycle plug flow reactors. The recorded reactor performance decreased with the increasing recycling ratio, and the worst reactor performance was reported for the mixed-flow reactor.