Gorkem Liman
Gorkem Liman has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Aybüke Karaca Sakallı
Department of Endodontics, Faculty of Dentistry, Ankara Medipol University, Ankara, Turkey
1 shared publication Aydin Akbulut
1 shared publicationBekir Salih
Hacettepe University, Department of Chemistry, 06800, Ankara, Turkey
1 shared publication- Bilge Özcan
DentTarz Academy Dental Clinic
1 shared publication - Gokhan Demirel
Bio-inspired Materials Research Laboratory (BIMREL), Department of Chemistry, Gazi University, 06500 Ankara, Turkey
1 shared publication Gulay Bayramoglu
1 shared publication
Latest Publications
- 27 January 2026
- Published by Ankara Dis Hekimleri Odasi in ADO Klinik Bilimler Dergisi
- Vol. 15 (1) , 24-31
In Vitro Assessment of pH and Surface Contact Angle of Triton as a Novel All-In-One Disinfectant
Introduction: This study compared the pH levels and surface wettability of conventional endodontic irrigants with Triton, a novel all-in-one solution. Sodium hypochlorite (NaOCl), ethylenediaminetetraacetic acid (EDTA), chlorhexidine (CHX), and Triton were tested. Materials and Methods: Each irrigant (10 mL) was stored in glass tubes (n=10). pH was measured with an electronic pH meter on days 1, 2, 5, 7, and 14, with three repeated measurements at each time point. For contact angle analysis, 26 extracted anterior teeth were sectioned, standardized, and exposed to the irrigants. Angles were measured using a goniometer device (SEO Phonix Contact Angle, Republic of Korea). Data were analyzed using repeated-measures ANOVA followed by Bonferroni-adjusted pairwise comparisons (p<0.05). Results: Significant differences were found among irrigants for both pH and contact angle (p<0.05). All solutions showed lower pH values at day 14 compared to day 1 (p<0.05). In the Triton group, values at days 1, 2, and 5 were not significantly different, whereas decreases were observed at days 7 and 14 (p<0.05). CHX (14.73°) and NaOCl (15.82°) demonstrated the lowest contact angles, Triton an intermediate value (19.35°), and EDTA the highest (21.46°). Conclusion: Triton maintained stable pH values during the first week and provided satisfactory dentin wettability, superior to EDTA but lower than CHX and NaOCl. These properties support its potential as a next-generation irrigant that combines multiple functions in a single solution.
- 27 January 2026
- Published by Ankara Dis Hekimleri Odasi in ADO Klinik Bilimler Dergisi
- Vol. 15 (1) , 24-31
In Vitro Assessment of pH and Surface Contact Angle of Triton as a Novel All-In-One Disinfectant
Introduction: This study compared the pH levels and surface wettability of conventional endodontic irrigants with Triton, a novel all-in-one solution. Sodium hypochlorite (NaOCl), ethylenediaminetetraacetic acid (EDTA), chlorhexidine (CHX), and Triton were tested. Materials and Methods: Each irrigant (10 mL) was stored in glass tubes (n=10). pH was measured with an electronic pH meter on days 1, 2, 5, 7, and 14, with three repeated measurements at each time point. For contact angle analysis, 26 extracted anterior teeth were sectioned, standardized, and exposed to the irrigants. Angles were measured using a goniometer device (SEO Phonix Contact Angle, Republic of Korea). Data were analyzed using repeated-measures ANOVA followed by Bonferroni-adjusted pairwise comparisons (p<0.05). Results: Significant differences were found among irrigants for both pH and contact angle (p<0.05). All solutions showed lower pH values at day 14 compared to day 1 (p<0.05). In the Triton group, values at days 1, 2, and 5 were not significantly different, whereas decreases were observed at days 7 and 14 (p<0.05). CHX (14.73°) and NaOCl (15.82°) demonstrated the lowest contact angles, Triton an intermediate value (19.35°), and EDTA the highest (21.46°). Conclusion: Triton maintained stable pH values during the first week and provided satisfactory dentin wettability, superior to EDTA but lower than CHX and NaOCl. These properties support its potential as a next-generation irrigant that combines multiple functions in a single solution.
- 4 April 2025
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 338, 126156
Graphene oxide decorated with melamine-imprinted nanobeads for SERS detection of melamine in milk
- 4 April 2025
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 338, 126156
Graphene oxide decorated with melamine-imprinted nanobeads for SERS detection of melamine in milk
- 6 August 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (33) , 44105-44113
Magnetically Controllable Paper-Based Soft Robots for Colorimetric Detection of Heavy Metal Ions
Magnetically controllable soft robots are of great interest because they have unique properties compared with conventional rigid counterparts and can be used in diverse applications such as intelligent electronics, bionics, personalized medicine, and cargo grasping. However, the fabrication of such multifunctional soft robots has been challenging because of the integration of dissimilar materials into the robot body. Herein, we designed and fabricated a soft robotic multifunctional system using conventional papers and elastomeric polymers for the colorimetric detection of heavy metal ions (Hg2+ and Fe3+) in water samples. The magnetic actuation of the platforms was shown to correlate with the type of underlying paper and magnetic particle content in the mixtures. Moreover, it was observed that actuation can also be manipulated by controlling the magnetic field strength. A proof-of-concept robotic paper-based Hg2+, Zn2+, and Fe3+ ion detection was demonstrated by combining colorimetric paper sensors and magneto-papers. Our study highlights the significant potential of paper as a material for the fabrication of effective and multifunctional untethered soft robots.
- 6 August 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (33) , 44105-44113
Magnetically Controllable Paper-Based Soft Robots for Colorimetric Detection of Heavy Metal Ions
Magnetically controllable soft robots are of great interest because they have unique properties compared with conventional rigid counterparts and can be used in diverse applications such as intelligent electronics, bionics, personalized medicine, and cargo grasping. However, the fabrication of such multifunctional soft robots has been challenging because of the integration of dissimilar materials into the robot body. Herein, we designed and fabricated a soft robotic multifunctional system using conventional papers and elastomeric polymers for the colorimetric detection of heavy metal ions (Hg2+ and Fe3+) in water samples. The magnetic actuation of the platforms was shown to correlate with the type of underlying paper and magnetic particle content in the mixtures. Moreover, it was observed that actuation can also be manipulated by controlling the magnetic field strength. A proof-of-concept robotic paper-based Hg2+, Zn2+, and Fe3+ ion detection was demonstrated by combining colorimetric paper sensors and magneto-papers. Our study highlights the significant potential of paper as a material for the fabrication of effective and multifunctional untethered soft robots.
- 1 May 2016
- Published by Elsevier in Chemosphere
- Vol. 150, 275-284
Removal of bisphenol A from aqueous medium using molecularly surface imprinted microbeads
- 1 May 2016
- Published by Elsevier in Chemosphere
- Vol. 150, 275-284
Removal of bisphenol A from aqueous medium using molecularly surface imprinted microbeads