Krzysztof Dmitruk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Krzysztof Dmitruk has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Andrzej Sikorski
Faculty of Electrical Engineering, Bialystok University of Technology, Wiejska 45D, 15-351 Bialystok, Poland
3 shared publications Adam Kuźma
Politech Bialostocka, Wydzial Elekt, Wiejska 45D, PL-15351 Bialystok, Poland
1 shared publicationAndrzej Sikorski
Electric Engineering Faculty, Department of Power Electronic and Electric Drives Bialystok, Bialystok University of Technology, Poland
1 shared publicationHubert Jakubowski
Wojskowe Centralne Biuro Konstrukcyjno Technol SA, ul Radiowa 13, PL-01485 Warsaw, Poland
1 shared publication- Krzysztof Kulikowski
Department of Electrotechnics, Power Electronics and Electrical Power Engineering, Biaystok University of Technology, Biaystok, Poland
1 shared publication Krzysztof Nowaszewski
Politech Bialostocka, Wydzial Elekt, Wiejska 45D, PL-15351 Bialystok, Poland
1 shared publication
Latest Publications
- 23 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (9) , 12095-12111
A Novel Continuous Control Set Current-Based Model Predictive Control for a Three-Phase, Two-Level AC/DC Converter With the LCL Filter
This article presents a developed novel continuous control set current-based model predictive control (CCS C-BMPC) for an ac–dc grid converter connected to the grid through an LCL filter. Most CCS MPC algorithms control the converter current by regulating the reference voltage derived from the prediction algorithm in the final control stage. The proposed algorithm enables direct control of the grid current by regulating the converter current and the voltage on the filter capacitor. The algorithm uses optimized prediction to compensate for the grid current vector error, minimizing total harmonic distortion (THD) at a relatively low switching frequency. It exhibits high robustness to power grid disturbances and avoids current distortions during zero crossing, especially at low current amplitudes. The advantages of the proposed method have been confirmed in simulations and laboratory tests in steady-state and transient conditions. It confirms that the developed control technique shows a high quality of the grid current (low THDi value), high dynamic performance, and immunity in case of weak grid conditions. The proposed method was compared with a method that uses a typical proportional-resonant current controller.
- 23 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (9) , 12095-12111
A Novel Continuous Control Set Current-Based Model Predictive Control for a Three-Phase, Two-Level AC/DC Converter With the LCL Filter
This article presents a developed novel continuous control set current-based model predictive control (CCS C-BMPC) for an ac–dc grid converter connected to the grid through an LCL filter. Most CCS MPC algorithms control the converter current by regulating the reference voltage derived from the prediction algorithm in the final control stage. The proposed algorithm enables direct control of the grid current by regulating the converter current and the voltage on the filter capacitor. The algorithm uses optimized prediction to compensate for the grid current vector error, minimizing total harmonic distortion (THD) at a relatively low switching frequency. It exhibits high robustness to power grid disturbances and avoids current distortions during zero crossing, especially at low current amplitudes. The advantages of the proposed method have been confirmed in simulations and laboratory tests in steady-state and transient conditions. It confirms that the developed control technique shows a high quality of the grid current (low THDi value), high dynamic performance, and immunity in case of weak grid conditions. The proposed method was compared with a method that uses a typical proportional-resonant current controller.
- Open Access
A Simplified Guide to Control Algorithms for Grid Converters in Renewable Energy Systems
This article provides an overview of control algorithms for grid-connected converters in renewable energy systems, demonstrating their relevance and potential for further research. A common issue among authors of scientific works is the lack of a wide range of conducted research. Often, the results showing the operation of the developed algorithms in transient states or under abnormal supply conditions (such as asymmetries and distortions) are missing. This significantly reduces the ability to compare developed solutions, making it difficult to choose the appropriate control method for future research. The article suggests which control algorithm for power converters is best suited for research considering various factors.
Open AccessA Simplified Guide to Control Algorithms for Grid Converters in Renewable Energy Systems
This article provides an overview of control algorithms for grid-connected converters in renewable energy systems, demonstrating their relevance and potential for further research. A common issue among authors of scientific works is the lack of a wide range of conducted research. Often, the results showing the operation of the developed algorithms in transient states or under abnormal supply conditions (such as asymmetries and distortions) are missing. This significantly reduces the ability to compare developed solutions, making it difficult to choose the appropriate control method for future research. The article suggests which control algorithm for power converters is best suited for research considering various factors.
- 24 July 2024
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 1 (7) , 193-199
Ocena skuteczności wykrywania niepożądanej pracy przekształtnika na wydzieloną grupę odbiorników
Wydawnictwo SIGMA-NOT wydaje czasopisma fachowe informujące swoich czytelników o najnowszych osiągnięciach naukowych i nowoczesnych rozwiązaniach technicznych w Polsce i na świecie, popularyzuje problemy techniczne oraz poszerza wiedzę i kulturę techniczną.
- 24 July 2024
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 1 (7) , 193-199
Ocena skuteczności wykrywania niepożądanej pracy przekształtnika na wydzieloną grupę odbiorników
Wydawnictwo SIGMA-NOT wydaje czasopisma fachowe informujące swoich czytelników o najnowszych osiągnięciach naukowych i nowoczesnych rozwiązaniach technicznych w Polsce i na świecie, popularyzuje problemy techniczne oraz poszerza wiedzę i kulturę techniczną.
- 14 May 2024
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 1 (5) , 84-87
Emisja przewodzona na porcie wejściowym naziemnej jednostki zasilającej statki powietrzne w standardzie 28 V DC oraz 270 V DC
W artykule przedstawiono badania konstruktorskie emisji przewodzonej zasilacza statków powietrznych zbudowanego z przekształtników energoelektronicznych AC/DC oraz DC/AC/DC z separacją transformatorową. Badana wersja zasilacza może być zasilana z dwóch standardów napięcia 400 V / 50 Hz albo 480 V / 60 Hz. Zasilacz na wyjściu wytwarza separowane napięcie 28 V DC oraz 270 V DC. Badania emisji przewodzonej wykonano na porcie zasilającym dla napięcia 400 V / 50 Hz w oparciu o procedurę CE102 normy MIL-STD-461G.
- 14 May 2024
- Published by Wydawnictwo SIGMA-NOT, sp. z.o.o. in PRZEGLĄD ELEKTROTECHNICZNY
- Vol. 1 (5) , 84-87
Emisja przewodzona na porcie wejściowym naziemnej jednostki zasilającej statki powietrzne w standardzie 28 V DC oraz 270 V DC
W artykule przedstawiono badania konstruktorskie emisji przewodzonej zasilacza statków powietrznych zbudowanego z przekształtników energoelektronicznych AC/DC oraz DC/AC/DC z separacją transformatorową. Badana wersja zasilacza może być zasilana z dwóch standardów napięcia 400 V / 50 Hz albo 480 V / 60 Hz. Zasilacz na wyjściu wytwarza separowane napięcie 28 V DC oraz 270 V DC. Badania emisji przewodzonej wykonano na porcie zasilającym dla napięcia 400 V / 50 Hz w oparciu o procedurę CE102 normy MIL-STD-461G.
- Open Access
Implementation of the Improved Active Frequency Drift Anti-Islanding Method into the Three-Phase AC/DC Converter with the LCL Grid Filter
The article presents a modified standard Active Frequency Drift (AFD) method used to detect unintentional island operation in converters generating electricity from renewable energy sources to the power grid. The primary aim of each of the island operation detection methods is the possibility of shortening the energising of a separate part of the power grid. The proposed method eliminates fragments of the reference current signal when it reaches a constant value for a particular time. This part of the signal is replaced with the hyperbolic sine function. It allows reducing the value of Total Harmonic Distortions (THD) while maintaining the same effectiveness of island operation detection. The article contains a detailed description of the newly proposed type of disturbance generation. The proposed solution is verified by conducting simulation and laboratory tests. The possibility of shortening the island operation detection time is proven by increasing the maximum distortion introduced into the current without exceeding the permissible THD limit for converters connected to the power grid.
Open AccessImplementation of the Improved Active Frequency Drift Anti-Islanding Method into the Three-Phase AC/DC Converter with the LCL Grid Filter
The article presents a modified standard Active Frequency Drift (AFD) method used to detect unintentional island operation in converters generating electricity from renewable energy sources to the power grid. The primary aim of each of the island operation detection methods is the possibility of shortening the energising of a separate part of the power grid. The proposed method eliminates fragments of the reference current signal when it reaches a constant value for a particular time. This part of the signal is replaced with the hyperbolic sine function. It allows reducing the value of Total Harmonic Distortions (THD) while maintaining the same effectiveness of island operation detection. The article contains a detailed description of the newly proposed type of disturbance generation. The proposed solution is verified by conducting simulation and laboratory tests. The possibility of shortening the island operation detection time is proven by increasing the maximum distortion introduced into the current without exceeding the permissible THD limit for converters connected to the power grid.
- Open Access
- 31 October 2020
- Published by Polish Academy of Sciences Chancellery in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
- Vol. 68 (5) , 1049-1056
Predictive-SVM control method dedicated to an AC/DC converter with an LCL grid filter
This paper presents simulation and laboratory test results of an implementation of an infinite control set model predictive control into a three-phase AC/DC converter. The connection between the converter and electric grid is made through an LCL filter, which is characterized by a better reduction of grid current distortions and smaller (cheaper) components in comparison to an L-type filter. On the other hand, this type of filter can cause strong resonance at specific current harmonics, which is efficiently suppressed by the control strategy focusing on the strict control input filter capacitors voltage vector. The presented method links the benefits of using linear control methods based on a space vector modulator and the nonlinear ones, which result in excellent control performance in a steady state as well as in a transient state.
- 31 October 2020
- Published by Polish Academy of Sciences Chancellery in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
- Vol. 68 (5) , 1049-1056
Open AccessPredictive-SVM control method dedicated to an AC/DC converter with an LCL grid filter
This paper presents simulation and laboratory test results of an implementation of an infinite control set model predictive control into a three-phase AC/DC converter. The connection between the converter and electric grid is made through an LCL filter, which is characterized by a better reduction of grid current distortions and smaller (cheaper) components in comparison to an L-type filter. On the other hand, this type of filter can cause strong resonance at specific current harmonics, which is efficiently suppressed by the control strategy focusing on the strict control input filter capacitors voltage vector. The presented method links the benefits of using linear control methods based on a space vector modulator and the nonlinear ones, which result in excellent control performance in a steady state as well as in a transient state.
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Predictive SVM Control Method of AC/DC Converter with LCL Filter
This paper presents simulation results of infinite control set model predictive control implemented into three-phase AC/DC converter. The connection between the converter and electric grid is made through LCL filter which is characterized by a better reduction of grid current distortions and smaller (cheaper) components in comparison to L-type filter. On the other hand, this type of filter can cause strong resonance at specific current harmonic which are efficiently suppressed by the control strategy which focuses on the strict control of the voltage vector of input filter capacitors. The presented method links benefits of using linear control methods based on space vector modulator and the non-linear ones which allow obtaining good control performance in steady state as well as in a transient state.
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Predictive SVM Control Method of AC/DC Converter with LCL Filter
This paper presents simulation results of infinite control set model predictive control implemented into three-phase AC/DC converter. The connection between the converter and electric grid is made through LCL filter which is characterized by a better reduction of grid current distortions and smaller (cheaper) components in comparison to L-type filter. On the other hand, this type of filter can cause strong resonance at specific current harmonic which are efficiently suppressed by the control strategy which focuses on the strict control of the voltage vector of input filter capacitors. The presented method links benefits of using linear control methods based on space vector modulator and the non-linear ones which allow obtaining good control performance in steady state as well as in a transient state.