Khairul Aimi Yusof
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Khairul Aimi Yusof has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad AlHadi Zulkefle
NANO-Electronic Centre (NET), Faculty of Electrical Engineering, Universiti Teknologi MARA, 40450 Shah Alam, Selangor, Malaysia
4 shared publications - Rohanieza Abdul Rahman
NANO-Electronic Centre (NET), Faculty of Electrical Engineering, Universiti Teknologi MARA, 40450 Shah Alam, Selangor, Malaysia
4 shared publications - Sukreen Hana Herman
Universiti Teknologi MARA
4 shared publications - Wan Fazlida Hanim Abdullah
Universiti Teknologi MARA
4 shared publications - Aimi Bazilah Binti Rosli
Integrated Sensors Research Group, School of Electrical Engineering, College of Engineering, Universiti Teknologi MARA (UiTM), Shah Alam 40450, Selangor, Malaysia
1 shared publication - Mohamad Hafiz Mamat
NANO-SciTech Centre (NST), Institute of Science (IOS), Universiti Teknologi MARA (UiTM), 40450 Shah Alam, Selangor, Malaysia
1 shared publication
Latest Publications
- Open Access
- 7 June 2021
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 83 (4) , 119-125
EVALUATION ON THE EGFET PH SENSING PERFORMANCE OF SOL-GEL SPIN COATED TITANIUM DIOXIDE THIN FILM
For this study, TiO2 thin film was fabricated using the sol-gel spin coating method. The fabricated film was then applied as a sensing membrane in an extended gate field effect transistor (EGFET) pH sensor system. The pH sensing performance of the sol-gel spin-coated TiO2 was evaluated in terms of sensitivity, linearity, and hysteresis where the value obtained was 58.70 mV/pH, 0.9922, and 86.17 mV respectively. The drift rate of the sample when being measured for 12 consecutive hours was also determined where measurement in pH 4, pH 7, and pH 10 yield drift rate of 1.72 mV/h, 4.14 mV/h, and 6.05 mV/h respectively. Besides that, the TiO2 was characterized for its thickness (24.32 nm) and surface roughness (5.129 nm). From the results obtained, it was found that sol-gel spin-coated TiO2 thin film with thickness between 20 - 29 nm will have high pH sensitivity (more than 50 mV/pH).
- 7 June 2021
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 83 (4) , 119-125
Open AccessEVALUATION ON THE EGFET PH SENSING PERFORMANCE OF SOL-GEL SPIN COATED TITANIUM DIOXIDE THIN FILM
For this study, TiO2 thin film was fabricated using the sol-gel spin coating method. The fabricated film was then applied as a sensing membrane in an extended gate field effect transistor (EGFET) pH sensor system. The pH sensing performance of the sol-gel spin-coated TiO2 was evaluated in terms of sensitivity, linearity, and hysteresis where the value obtained was 58.70 mV/pH, 0.9922, and 86.17 mV respectively. The drift rate of the sample when being measured for 12 consecutive hours was also determined where measurement in pH 4, pH 7, and pH 10 yield drift rate of 1.72 mV/h, 4.14 mV/h, and 6.05 mV/h respectively. Besides that, the TiO2 was characterized for its thickness (24.32 nm) and surface roughness (5.129 nm). From the results obtained, it was found that sol-gel spin-coated TiO2 thin film with thickness between 20 - 29 nm will have high pH sensitivity (more than 50 mV/pH).
- Open Access
- 10 October 2016
- Published by Wiley in Journal of Sensors
- Vol. 2016, 1-8
Spin Speed and Duration Dependence of TiO2Thin Films pH Sensing Behavior
Titanium dioxide (TiO2) thin films were applied as the sensing membrane of an extended-gate field-effect transistor (EGFET) pH sensor. TiO2thin films were deposited by spin coating method and the influences of the spin speed and spin duration on the pH sensing behavior of TiO2thin films were investigated. The spin coated TiO2thin films were connected to commercial metal-oxide-semiconductor field-effect transistor (MOSFET) to form the extended gates and the MOSFET was integrated in a readout interfacing circuit to complete the EGFET pH sensor system. For the spin speed parameter investigation, the highest sensitivity was obtained for the sample spun at 3000 rpm at a fixed spinning time of 60 s, which was 60.3 mV/pH. The sensitivity was further improved to achieve 68 mV/pH with good linearity of 0.9943 when the spin time was 75 s at the speed of 3000 rpm.
- 10 October 2016
- Published by Wiley in Journal of Sensors
- Vol. 2016, 1-8
Open AccessSpin Speed and Duration Dependence of TiO2Thin Films pH Sensing Behavior
Titanium dioxide (TiO2) thin films were applied as the sensing membrane of an extended-gate field-effect transistor (EGFET) pH sensor. TiO2thin films were deposited by spin coating method and the influences of the spin speed and spin duration on the pH sensing behavior of TiO2thin films were investigated. The spin coated TiO2thin films were connected to commercial metal-oxide-semiconductor field-effect transistor (MOSFET) to form the extended gates and the MOSFET was integrated in a readout interfacing circuit to complete the EGFET pH sensor system. For the spin speed parameter investigation, the highest sensitivity was obtained for the sample spun at 3000 rpm at a fixed spinning time of 60 s, which was 60.3 mV/pH. The sensitivity was further improved to achieve 68 mV/pH with good linearity of 0.9943 when the spin time was 75 s at the speed of 3000 rpm.
- Open Access
- 1 January 2016
- Published by Wiley in Journal of Sensors
- Vol. 2016, 1-9
EGFET pH Sensor Performance Dependence on Sputtered TiO2Sensing Membrane Deposition Temperature
Titanium dioxide (TiO2) thin films were sputtered by radio frequency (RF) magnetron sputtering method and have been employed as the sensing membrane of an extended gate field effect transistor (EGFET) for pH sensing detection application. The TiO2thin films were deposited onto indium tin oxide (ITO) coated glass substrates at room temperature and 200°C, respectively. The effect of deposition temperature on thin film properties and pH detection application was analyzed. The TiO2samples used as the sensing membrane for EGFET pH-sensor and the current-voltage (I-V), hysteresis, and drift characteristics were examined. The sensitivity of TiO2EGFET sensing membrane was obtained from the transfer characteristic (I-V) curves for different substrate heating temperatures. TiO2thin film sputtered at room temperature achieved higher sensitivity of 59.89 mV/pH compared to the one deposited at 200°C indicating lower sensitivity of 37.60 mV/pH. Moreover the hysteresis and the drift of TiO2thin film deposited at room temperature showed lower values compared to the one at 200°C. We have also tested the effect of operating temperature on the performance of the EGFET pH-sensing and found that the temperature effect was very minimal.
- 1 January 2016
- Published by Wiley in Journal of Sensors
- Vol. 2016, 1-9
Open AccessEGFET pH Sensor Performance Dependence on Sputtered TiO2Sensing Membrane Deposition Temperature
Titanium dioxide (TiO2) thin films were sputtered by radio frequency (RF) magnetron sputtering method and have been employed as the sensing membrane of an extended gate field effect transistor (EGFET) for pH sensing detection application. The TiO2thin films were deposited onto indium tin oxide (ITO) coated glass substrates at room temperature and 200°C, respectively. The effect of deposition temperature on thin film properties and pH detection application was analyzed. The TiO2samples used as the sensing membrane for EGFET pH-sensor and the current-voltage (I-V), hysteresis, and drift characteristics were examined. The sensitivity of TiO2EGFET sensing membrane was obtained from the transfer characteristic (I-V) curves for different substrate heating temperatures. TiO2thin film sputtered at room temperature achieved higher sensitivity of 59.89 mV/pH compared to the one deposited at 200°C indicating lower sensitivity of 37.60 mV/pH. Moreover the hysteresis and the drift of TiO2thin film deposited at room temperature showed lower values compared to the one at 200°C. We have also tested the effect of operating temperature on the performance of the EGFET pH-sensing and found that the temperature effect was very minimal.
- Open Access
- 19 November 2015
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 99 (1) , 012019
Effect of Annealing Time Process on the pH Sensitivity of Spin-coated TiO2/ ZnO Bilayer Film
This paper presents an investigation on titanium dioxide (TiO 2) and zinc oxide (ZnO) bilayer film, which is used as sensing membrane for extended-gate field effect transistor (EGFET) for pH sensing application. TiO 2 /ZnO thin films were deposited using sol-gel spin coating method on indium tin oxide (ITO) substrates. After the deposition, the bilayer films were annealed at constant temperatures which is 400 °C for 15, 30, 40 and 60 minutes. The sensitivity of the TiO 2 thin film towards pH buffer solution was measured by dipping the sensing membrane in pH4, pH7 and pH10 buffer solution. By varying the annealing time, we found that the TiO 2 /ZnO thin film annealed at 400°C for 15 minutes gave the highest sensitivity compared to other annealing conditions, with the value of 64.87 mV/pH.
- 19 November 2015
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 99 (1) , 012019
Open AccessEffect of Annealing Time Process on the pH Sensitivity of Spin-coated TiO2/ ZnO Bilayer Film
This paper presents an investigation on titanium dioxide (TiO 2) and zinc oxide (ZnO) bilayer film, which is used as sensing membrane for extended-gate field effect transistor (EGFET) for pH sensing application. TiO 2 /ZnO thin films were deposited using sol-gel spin coating method on indium tin oxide (ITO) substrates. After the deposition, the bilayer films were annealed at constant temperatures which is 400 °C for 15, 30, 40 and 60 minutes. The sensitivity of the TiO 2 thin film towards pH buffer solution was measured by dipping the sensing membrane in pH4, pH7 and pH10 buffer solution. By varying the annealing time, we found that the TiO 2 /ZnO thin film annealed at 400°C for 15 minutes gave the highest sensitivity compared to other annealing conditions, with the value of 64.87 mV/pH.