AVAnton A. Vasilev

Anton A. Vasilev

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Anton A. Vasilev has a total of 163 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Suppressing Size-Dependent Efficiency Droop in Scaled InGaN/GaN Red Micro-LEDs via Porous GaN Compliant Buffers

    by Sang-Ik Lee, Lee-Woon Jang, Alexander Y. Polyakov, A. A. Romanov, E Yakimov, L. A. Alexanyan, A Vasilev, I Shchemerov, A Kuznetsov, In-Hwan Lee

    As III-nitride micro-LEDs are scaled toward sub-20 μm dimensions for full-color microdisplays, InGaN red micro-LEDs are less susceptible to sidewall-related size-dependent efficiency droop than AlGaInP red devices and blue/green InGaN micro-LEDs, owing to strong carrier localization. Here, InGaN/GaN red single-quantum-well micro-LEDs grown on porous GaN compliant buffers formed by sequential electrochemical and photoelectrochemical etching were systematically benchmarked against conventional planar-template reference devices. Across all chip sizes, the EC-PEC and EC micro-LEDs exhibited 1.4- and 1.2-fold higher peak external quantum efficiency (EQE), respectively, than the reference devices. The EC-PEC devices also showed a reduced and less size-sensitive injection current density at peak EQE, with Jmax = 5.5 - 9.2 A/cm2 compared with 10 - 14.5 A/cm2 for the reference over the 50 × 50 to 10 × 10 μm2 range. These trends indicate that porous GaN buffers mitigate strain-driven quantum-confined Stark effect and dislocation-mediated carrier loss during device scaling. Deep-level transient spectroscopy further revealed a prominent Ec - 0.55 eV trap in the reference sample, whereas this trap was undetectable in the porous-buffer samples. These results establish porous GaN compliant buffers as an effective defect- and strain-management strategy for scalable InGaN red micro-LEDs.

  • Thermal ionic stability under ISOS-D-2 decouples room-temperature efficiency from durability in CsFAPbI3 perovskite solar cells

    by Anna A. Zarudnyaya, Ekaterina A. Ilicheva, Lev O. Luchnikov, Alexandra A. Feklistova, Dmitry Yu Dorofeev, Vladislav Kalinichenko, Aleksandra Furasova, Irina M. Danilovskaya, Dmitry S. Muratov, Anton A. Vasilev, et al.

  • Open Access

    Thermal Ionic Stability Under ISOS-D-2 Decouples Room-Temperature Efficiency from Durability in CsFAPbI3 Perovskite Solar Cells

    by Anna A. Zarudnyaya, Ekaterina Ilicheva, Lev Luchnikov, Aleksandra Feklistova, Dmitri Dorofeev, Vladislav Kalinichenko, Aleksandra Furasova, Dmitry S. Muratov, A Vasilev, L. A. Alexanyan, et al.

    Thermal performance of perovskite solar cells under elevated operating temperatures remains poorly understood, being one of the key bottlenecks for commercial deployment. While composition engineering has driven record power conversion efficiencies (PCEs), its impact on defect landscape and ionic transport stability is rarely quantified at the device level under harsh thermal stress (85°C). Here we compare two CsXFA1-XPbI₃ absorbers (x = 0.05 and 0.20) across structural, optical and ionic transport measurements under prolonged ISOS-D-2. Devices with reduced Cs concentration achieved PCE of 22.23% with high room-temperature recombination metrics, attributed to reduced lattice strain (ε = -0.00431) and charge carrier lifetimes. Temperature-coefficient measurements revealed that this advantage reverses under heating, with TPCE reaching -0.624%/°C versus -0.294%/°C for Cs 20%, driven by fill factor losses. Admittance and photo-induced spectroscopies resolved an increase in ion activation energy from 0.4 to >0.6 eV across Cs 5% and 20% compositions with different trends of diffusion coefficient. In Cs 20% devices, CsPbI3-rich cluster formation acted as an ionic sink, passivating active interfaces, while in Cs 5% devices unimpeded ion migration along grain boundaries affected charge collection efficiency. These findings establish that room-temperature efficiency and thermal ionic stability are decoupled parameters requiring independent compositional optimization.

  • Electron Beam Induced Current Studies of Defects Generated by Soft Breakdown of Ga2O3 Schottky Diodes

    by Eugene B. Yakimov, Ivan V. Shchemerov, Alexander Y Polyakov, P. S. Vergeles, Yury Kulanchikov, Evgene E Yakimov, Nikolai R Matros, Luiza Aleksanyan, Anton A. Vasilev, Alexey Chernykh, et al.

    Electron Beam Induced Current (EBIC) mapping of Ga2O3 Schottky diodes after soft breakdown reveal the presence of defects with bright contrast absent before the breakdown. The defects are of two types: smaller point-like defect features with weaker contrast and larger (about 1 m) defects with a very strong EBIC contrast. For both types of defects a prominent gain of the EBIC signal compared to the signal expected for theoretically estimated value based on the assumption of total collection of charge of electrons and holes generated by the probing beam was observed. For point-like defects the gain was on the order of 100, with the time of gain-build-up lower than 5 μs and the time of gain decay of 15 μs. For the “strong” defects the gain was very high, on the order of 104, with the gain build-up time also below 5 μs, while the gain decay time was slightly longer than for point-like defects (20-25 μs). The appearance of the defects in EBIC images correlates with the recently reported localized enhancement of the signal due to traps with levels close to 0.75 eV and 1 eV below the conduction band.

  • Enhanced Thermal Stability of Inverted Perovskite Solar Cells by Bulky Passivation With Pyridine‐Functionalized Triphenylamine

    by Ekaterina A. Ilicheva, Irina A. Chuyko, Lev O. Luchnikov, Polina K. Sukhorukova, Nikita S. Saratovsky, Anton A. Vasilev, Luiza Alexanyan, Anna A. Zarudnyaya, Dmitri Yu. Dorofeev, Sergey S. Kozlov, et al.

    Despite competitive efficiency compared to Si solar cells and relevant stability at near room temperatures, the rapid degradation at elevated temperatures remains the critical obstacle for the exploitation of perovskite photovoltaics. In this work, a 4‐(pyridin‐4‐yl)triphenylamine (TPA‐Py) with pyridine anchor group was employed for intergrain bulk modification of double‐cation CsCH(NH 2 ) 2 PbI 3 perovskite absorbers to enhance thermal stability. Through coordination and dipole–dipole interactions, nitrogen‐containing fragments (diphenylamine and pyridine) of TPA‐Py passivate uncoordinated cations and improve the phase resilience of perovskite films against segregation. This resulted in a power conversion efficiency of 21.3% with a high open‐circuit voltage of 1.14 V. Notable impact of self‐assembled monolayer incorporated into the bulk of the perovskite film manifested in a huge improvement of thermal stability at 85°C (ISOS‐D‐2). TPA‐Py modification extended the T80 lifetime to ≈700 h compared to only 200 h for the reference under harsh heating stress in ambient conditions. In‐depth analysis using photoinduced voltage transients and admittance spectroscopy after different stress periods revealed the screening of ion migration (0.45 eV) for devices with TPA‐Py. This work offers an important understanding of the bulk modification of microcrystalline perovskite absorbers and a guide for robust design of bulk and buried interfaces in highly efficient perovskite solar cells.


  • Open Access

    Deep traps in Ga 2 O 3 Schottky diodes induced by soft electric breakdown

    by Alexander Y. Polyakov, Ivan Shchemerov, Eugene Borisovich Yakimov, Alexey Chernykh, Sergey V. Chernykh, Anton Vasilev, Nikolai Matros, Andrey A. Romanov, Luiza Alexanyan, Eugene E. Yakimov, et al.

    Ga 2 O 3 Schottky diodes showed an inverse relationship between diameter and breakdown voltage due to defects that enhance localized electric fields. Breakdown increased reverse current by Poole–Frenkel hopping through E2* traps near defect sites.


  • Open Access

    Depth-resolved cathodoluminescence in γ/β-Ga2O3 polymorph junctions

    by E. E. Yakimov, A. Y. Polyakov, A. A. Vasilev, I. V. Schemerov, A. Kuznetsov, S. J. Pearton

    The dominant emission bands were assessed in γ/β-Ga2O3 polymorph junctions for the first time, using depth-resolved cathodoluminescence. By comparing our results collected from the γ-Ga2O3 films with literature data available for β-Ga2O3, we conclude that the emission properties for these Ga2O3 polymorphs are rather similar, and the origin of this emission may be tentatively assigned to the recombination involving the conduction band electrons and self-trapped holes or Ga vacancy acceptors. In particular, the most prominent emissions peaked around 2.4 and 2.9 eV bands, and two minor bands peaked at 2.6 and 2.8 eV. Importantly, these band positions were not affected by subsequent irradiation of γ-Ga2O3 upon its formation via disorder-induced ordering. On the other hand, the intensities of these bands are greatly enhanced by increased electron concentration supplied by donors introduced into γ-Ga2O3 by hydrogen plasma treatment. These data add to the understanding of emission properties in Ga2O3 polymorphs.


  • Trap states and hydrogenation of implanted Si in semi-insulating Ga2O3(Fe)

    by A. Y. Polyakov, I. V. Schemerov, A. A. Vasilev, A. A. Romanov, P. B. Lagov, A. V. Miakonkikh, A. V. Chernykh, E. P. Romanteeva, S. V. Chernykh, O. I. Rabinovich, et al.

    The electrical properties and deep trap spectra of semi-insulating Ga2O3(Fe) implanted with Si ions and subsequently annealed at 1000 °C were investigated. A significant discrepancy was observed between the measured shallow donor concentration profile and the profile predicted by Stopping Power and Range of Ions in Matter simulations, indicating substantial compensation. Deep level transient spectroscopy revealed the presence of deep acceptors at Ec −0.5 eV with a concentration of ∼10¹⁷ cm−³, insufficient to fully account for the observed compensation. Photocapacitance spectroscopy identified additional deep acceptors with optical ionization thresholds near 2 and 2.8–3.1 eV, tentatively attributed to gallium vacancy-related defects. However, the combined concentration of these deep acceptors still fell short of explaining the observed donor deactivation, suggesting the formation of electrically neutral Si-vacancy complexes. Furthermore, the properties of Ga2O3 (Fe) implanted with Si and subjected to hydrogen plasma treatment at 330 °C were also examined. This material exhibited high resistivity with the Fermi level pinned near Ec –0.3 eV, similar to common radiation defects in proton-implanted Ga2O3. A prominent deep center near Ec −0.6 eV, consistent with the known E1 electron trap attributed to Si-H complexes, was also observed. These results highlight the challenges associated with Si implantation and activation in Ga2O3 and suggest that hydrogen plasma treatment, while effective for Ga-implanted Ga2O3 is less suitable for Si-implanted material due to the formation of compensating Si-H complexes.


  • Deep traps and persistent photocapacitance in p-SnO2/i-Zr Sn1-O2/n-SnO2 p-i-n diodes

    by Mingkai Li, A.Y. Polyakov, Qiang Li, A.A. Vasilev, A.A. Romanov, N.R. Matros, L.A. Alexanyan, Qi Zhang, Degang Lai, Baoxia Zhang, et al.

  • Open Access

    Point defect effects in AlGaN 270-nm light emitting diodes introduced by MeV electron and proton irradiation

    by A. Y. Polyakov, L. A. Alexanyan, I. V. Schemerov, A. A. Vasilev, A. V. Chernykh, Anton Ivanov, Nadezhda Talnishnikh, Anton Chernyakov, A. L. Zakgeim, N. M. Shmidt, et al.

    Point defects were controllably introduced into 270 nm AlGaN Light-Emitting Diodes (LEDs) by 5 MeV electron and 1.1 MeV proton irradiations to examine the effect on electrical and luminescent characteristics. The 5 MeV electron irradiations had only a marginal effect on the charge distribution, current flow, and electroluminescence of LEDs for electron fluences up to 4.5 × 1016 e/cm2 that cause very strong degradation in green, blue, and near-UV LEDs. This lack of changes is attributed to the much higher charge densities in quantum-wells (QWs) and quantum barriers (QBs) of the 270 nm LEDs and to higher bond strength in high Al mole fraction AlGaN layers. By contrast, irradiation with 1.1 MeV protons with a fluence of 1016 p/cm2 leads to more than two orders of magnitude decrease in charge density in the QWs and QBs, a strong increase in the series resistance, and the emergence of deep electron traps near Ec-0.5 eV. The difference is explained by a much higher density of primary defects produced by protons. The observed effects are compared to changes in performance caused by aging after high driving current.