Ravindra Kollu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ravindra Kollu has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Ch. Mahesh
Airports Authority of India
2 shared publications - Patibandla Anilkumar
Terahertz Radiation and Application Key Laboratory of Sichuan Province, School of Electronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu, China
2 shared publications Ramalinga Raju Manyala
Electrical and Electronics Engineering, University College of Engineering Kakinada, Jawaharlal Nehru Technological University Kakinada, India
2 shared publications- V. Kamakshi Prasad
JNTUH Hyderabad, India
2 shared publications Adireddy Ramesh
1 shared publication- Alajingi RamKumar
School of Electrical Engineering, Vellore Institute of Technology, Vellore, India
1 shared publication
Latest Publications
- 16 March 2026
- Published by Elsevier in Next Research
- Vol. 8
Performance analysis of improved half-bridge NPC inverter-fed PMSM drive with fault tolerant operation
- 16 March 2026
- Published by Elsevier in Next Research
- Vol. 8
Performance analysis of improved half-bridge NPC inverter-fed PMSM drive with fault tolerant operation
- Open Access
- 13 February 2026
- Published by Elsevier in Results in Engineering
- Vol. 29
An optimal approach for AVR and DG allocation in distribution systems considering voltage-dependent load models and load variations
- 13 February 2026
- Published by Elsevier in Results in Engineering
- Vol. 29
Open AccessAn optimal approach for AVR and DG allocation in distribution systems considering voltage-dependent load models and load variations
- Open Access
- 6 November 2025
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4) , 045350
Design and identification of an optimal approach for modelling a hybrid renewable energy system
Most power generation relies on fossil fuels, which are both finite resources and major contributors to greenhouse gas emissions. In recent years, renewable energy sources such as solar, wind, and biomass have played an important role in power generation to mitigate these concerns. However, the successful modelling, operation, and integration of these sources into the grid system poses significant challenges due to their inherent variability and dependency on environmental conditions. Due to these challenges, determining the optimal capacity of renewables in a hybrid system is complex. Thus, a robust methodology is required to address this design challenge effectively. To achieve this, development of advanced modelling techniques is suggested that consider the probabilistic nature of renewable energy sources and load patterns. This study analyses different approaches, including the deterministic and probabilistic methods, and proposes an optimal approach and design for a hybrid renewable energy system, which is more reliable with a reduced loss of power supply probability and produces energy with 26.3% lower levelised cost of electricity (LCOE) than fossil fuel–based alternatives such as the utility grid. A detailed analysis of the compatibility of the proposed method with the actual real-time data is carried out, and the effect of the grid purchase and sale capacities on the LCOE of the produced energy is examined.
- 6 November 2025
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4) , 045350
Open AccessDesign and identification of an optimal approach for modelling a hybrid renewable energy system
Most power generation relies on fossil fuels, which are both finite resources and major contributors to greenhouse gas emissions. In recent years, renewable energy sources such as solar, wind, and biomass have played an important role in power generation to mitigate these concerns. However, the successful modelling, operation, and integration of these sources into the grid system poses significant challenges due to their inherent variability and dependency on environmental conditions. Due to these challenges, determining the optimal capacity of renewables in a hybrid system is complex. Thus, a robust methodology is required to address this design challenge effectively. To achieve this, development of advanced modelling techniques is suggested that consider the probabilistic nature of renewable energy sources and load patterns. This study analyses different approaches, including the deterministic and probabilistic methods, and proposes an optimal approach and design for a hybrid renewable energy system, which is more reliable with a reduced loss of power supply probability and produces energy with 26.3% lower levelised cost of electricity (LCOE) than fossil fuel–based alternatives such as the utility grid. A detailed analysis of the compatibility of the proposed method with the actual real-time data is carried out, and the effect of the grid purchase and sale capacities on the LCOE of the produced energy is examined.
- Open Access
- 27 October 2025
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 13, 1664533
Optimal allocation of renewable energy sources and power filters in unbalanced distribution systems with nonlinear loads under load growth condition
In recent years, the world’s energy needs have increased significantly. In order to meet this demand and mitigate the environmental issues brought on by the use of conventional power plants, numerous studies were offered to develop renewable energy sources (RES) as green energy distributed generators. This study uses probability distribution functions to simulate the fluctuating nature of RES and load. A novel approach to minimize Power Loss, Total Harmonic Distortion, and Cost is proposed which employs Pareto front-based Multi Objective Backtracking Search Algorithm (PMBSA) to optimally distribute RES and Power Filters in an Unbalanced Distribution System (UDS). The proposed approach takes into account load growth and multiple non-linear loads in addition to linear loads while optimally allocating RES, Passive power filters (PPFs) and Active power filters (APFs) in UDS. The results of simultaneous placement of RES and PPFs are compared with simultaneous placement of RES and APFs by testing on a 123-bus UDS to demonstrate which combination performs better in reducing THD along with other objectives. Automatic Voltage Regulators (AVRs) and Shunt Capacitor Banks (SCBs) are also installed in UDS in the event of voltage limit violations. Furthermore, results comparison is carried out with results obtained using Non-dominated Sorting Genetic Algorithm (NSGA-II), Multi-Objective Particle Swarm Optimization (MOPSO) and Weighted Sum technique (WSA) to demonstrate the effectiveness of the proposed approach employing PMBSA in improving UDS performance.
- 27 October 2025
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 13, 1664533
Open AccessOptimal allocation of renewable energy sources and power filters in unbalanced distribution systems with nonlinear loads under load growth condition
In recent years, the world’s energy needs have increased significantly. In order to meet this demand and mitigate the environmental issues brought on by the use of conventional power plants, numerous studies were offered to develop renewable energy sources (RES) as green energy distributed generators. This study uses probability distribution functions to simulate the fluctuating nature of RES and load. A novel approach to minimize Power Loss, Total Harmonic Distortion, and Cost is proposed which employs Pareto front-based Multi Objective Backtracking Search Algorithm (PMBSA) to optimally distribute RES and Power Filters in an Unbalanced Distribution System (UDS). The proposed approach takes into account load growth and multiple non-linear loads in addition to linear loads while optimally allocating RES, Passive power filters (PPFs) and Active power filters (APFs) in UDS. The results of simultaneous placement of RES and PPFs are compared with simultaneous placement of RES and APFs by testing on a 123-bus UDS to demonstrate which combination performs better in reducing THD along with other objectives. Automatic Voltage Regulators (AVRs) and Shunt Capacitor Banks (SCBs) are also installed in UDS in the event of voltage limit violations. Furthermore, results comparison is carried out with results obtained using Non-dominated Sorting Genetic Algorithm (NSGA-II), Multi-Objective Particle Swarm Optimization (MOPSO) and Weighted Sum technique (WSA) to demonstrate the effectiveness of the proposed approach employing PMBSA in improving UDS performance.
- Open Access
- 24 January 2025
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 165
A multi-objective strategy for optimal DG and capacitors placement to improve technical, economic, and environmental benefits
- 24 January 2025
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 165
Open AccessA multi-objective strategy for optimal DG and capacitors placement to improve technical, economic, and environmental benefits
- 25 April 2024
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (6) , 6797-6814
A multi-objective approach for optimal placement of renewable energy sources, voltage regulators and capacitors in radial unbalanced distribution systems
- 25 April 2024
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (6) , 6797-6814
A multi-objective approach for optimal placement of renewable energy sources, voltage regulators and capacitors in radial unbalanced distribution systems
- 21 April 2023
- Published by Taylor & Francis in Electric Power Components and Systems
- Vol. 51 (15) , 1523-1545
An Optimal Multi-Objective Approach for Distributed Generation and AVR Placement in Distribution Networks Using IPMBSA
Inclusion of automatic voltage regulators (AVRs) and distributed generation units (DGs) in the distribution system (DS) will enhance the system performance if allocated optimally. Optimal allocation of AVRs and DGs is a complex combinatorial problem requiring a powerful optimization algorithm for solving the optimization problem. This paper proposes an improved pareto multi-objective backtracking search algorithm (IPMBSA) based Pareto front approach for optimal siting and sizing of DGs and AVRs. The proposed approach considers DS technical (such as minimizing of voltage deviation, power losses and voltage stability index), cost and emission indices as objective functions while solving the allocation problem. To evaluate the performance of the proposed approach, five different operational scenarios are considered for analysis on IEEE 33-bus, IEEE 69-bus and practical 43-bus Indian distribution test systems. The effectiveness of the proposed approach is highlighted by comparison of results obtained using a multi-objective approach based on NSGA-II and weighted sum method (WSM). Results propounded that allocation of DG along with AVR yielded better DS performance compared to the scenarios where only DG or AVRs are placed in DS.
- 21 April 2023
- Published by Taylor & Francis in Electric Power Components and Systems
- Vol. 51 (15) , 1523-1545
An Optimal Multi-Objective Approach for Distributed Generation and AVR Placement in Distribution Networks Using IPMBSA
Inclusion of automatic voltage regulators (AVRs) and distributed generation units (DGs) in the distribution system (DS) will enhance the system performance if allocated optimally. Optimal allocation of AVRs and DGs is a complex combinatorial problem requiring a powerful optimization algorithm for solving the optimization problem. This paper proposes an improved pareto multi-objective backtracking search algorithm (IPMBSA) based Pareto front approach for optimal siting and sizing of DGs and AVRs. The proposed approach considers DS technical (such as minimizing of voltage deviation, power losses and voltage stability index), cost and emission indices as objective functions while solving the allocation problem. To evaluate the performance of the proposed approach, five different operational scenarios are considered for analysis on IEEE 33-bus, IEEE 69-bus and practical 43-bus Indian distribution test systems. The effectiveness of the proposed approach is highlighted by comparison of results obtained using a multi-objective approach based on NSGA-II and weighted sum method (WSM). Results propounded that allocation of DG along with AVR yielded better DS performance compared to the scenarios where only DG or AVRs are placed in DS.
- 21 October 2021
- Published by Springer Nature in International Journal of Energy and Environmental Engineering
- Vol. 13 (3) , 995-1019
A multi-objective approach for renewable distributed generator unit’s placement considering generation and load uncertainties
- 21 October 2021
- Published by Springer Nature in International Journal of Energy and Environmental Engineering
- Vol. 13 (3) , 995-1019
A multi-objective approach for renewable distributed generator unit’s placement considering generation and load uncertainties
- Open Access
- 25 June 2021
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (12) , 18121-18148
A multi‐objective approach for the optimal design of a standalone hybrid renewable energy system
Summary: Dependency on alternative energy sources has increased due to the depletion of fossil fuel and their costs. Even though the usage of renewable energy sources (RESs) has significantly reduced these problems, there are quite a few challenges like reliability, lower efficiency, and high cost which can be overcome by the integration of multiple RES to meet the energy demand. In this study, a multi‐objective approach is proposed to get the best optimal sizing configuration of a standalone hybrid renewable energy system (HRES) by choosing the minimization of the total cost of the system and loss of power supply probability. In this regard, wind turbines, solar photovoltaic (PV), battery storage systems, biomass, and diesel generators are used to design HRES. The proposed approach deals with the intermittent nature of wind and solar PV power generation using Weibull distribution to model wind speed and solar irradiance. The normal distribution is used to model the load demand. The backtracking search algorithm capable of solving single‐objective optimization problems is modified to handle the multi‐objective optimization problem and to find the optimal sizes of wind turbines, solar PV, battery storage system, diesel, and biomass generators for efficient HRES performance.
- 25 June 2021
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (12) , 18121-18148
Open AccessA multi‐objective approach for the optimal design of a standalone hybrid renewable energy system
Summary: Dependency on alternative energy sources has increased due to the depletion of fossil fuel and their costs. Even though the usage of renewable energy sources (RESs) has significantly reduced these problems, there are quite a few challenges like reliability, lower efficiency, and high cost which can be overcome by the integration of multiple RES to meet the energy demand. In this study, a multi‐objective approach is proposed to get the best optimal sizing configuration of a standalone hybrid renewable energy system (HRES) by choosing the minimization of the total cost of the system and loss of power supply probability. In this regard, wind turbines, solar photovoltaic (PV), battery storage systems, biomass, and diesel generators are used to design HRES. The proposed approach deals with the intermittent nature of wind and solar PV power generation using Weibull distribution to model wind speed and solar irradiance. The normal distribution is used to model the load demand. The backtracking search algorithm capable of solving single‐objective optimization problems is modified to handle the multi‐objective optimization problem and to find the optimal sizes of wind turbines, solar PV, battery storage system, diesel, and biomass generators for efficient HRES performance.
- 5 September 2015
- Published by Springer Nature
- p. 617-627
Denoising of GPS Positioning Data Using Wavelet-Based Hidden Markov Tree
- 5 September 2015
- Published by Springer Nature
- p. 617-627
Denoising of GPS Positioning Data Using Wavelet-Based Hidden Markov Tree