Anatoliy Kukoba
Research Subjects
Research Interests
Anatoliy Kukoba has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Yuriy Tymofiiovych Zholudov
Laboratory of Analytical Optochemotronics, Biomedical Engineering Department, Kharkiv National University of Radio Electronics, Kharkiv 61166, Ukraine
6 shared publications A. I. Bykh
Department of Biomedical Electronics, Kharkov State Technical University of Radio Electronics, 14 Lenina Avenue, 61166-Kharkov, Ukraine UA
3 shared publications- Dmytro Snizhko
Харківський національний університет радіоелектроніки, Ukraine
2 shared publications Ghazi Khaled
Kharkiv National University of Radioelectronics,Department of Biomedical Engineering,Kharkiv,Ukraine
2 shared publicationsGuobao Xu
State Key Laboratory of Electroanalytical Chemistry, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences,Changchun,China
2 shared publicationsKateryna Muzyka
Kharkiv National University of Radioelectronics,Department of Biomedical Engineering,Kharkiv,Ukraine
2 shared publications
Latest Publications
- 1 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 552-556
9,10-diphenylanthracene/Polyvinylbutyral/Glassy Carbon Based Transducer: from Spin Coater Development to Electrochemiluminescent Applications
The work describes the development of a new electrochemiluminescent (ECL) transducer based on 9,10-diphenylanthracene (DPA) / polyvinyl butyral / glassy carbon film modified electrode along with the design and manufacture of a low-cost spin-coating system based on Arduino Atmega 2560, which was used to create the abovementioned transducer. It was proved that the performance of this spin coater is comparable to common commercial models, but with much lower total cost of the device. The appearance of ECL from DPA molecules of the transducer in reaction with a relatively new ECL co-reactant tetraphenylborate (TPB) in aqueous solution has demonstrated the applicability of spin-coating technique for creation of new types of ECL transducers. Application of such transducers allows full use of the unique properties of TPB co-reactant and eliminates a problem of formation of TPB based precipitates, which occurs when such common fluorophore as Ru(bpy)3 2 + is utilized.
- 1 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 552-556
9,10-diphenylanthracene/Polyvinylbutyral/Glassy Carbon Based Transducer: from Spin Coater Development to Electrochemiluminescent Applications
The work describes the development of a new electrochemiluminescent (ECL) transducer based on 9,10-diphenylanthracene (DPA) / polyvinyl butyral / glassy carbon film modified electrode along with the design and manufacture of a low-cost spin-coating system based on Arduino Atmega 2560, which was used to create the abovementioned transducer. It was proved that the performance of this spin coater is comparable to common commercial models, but with much lower total cost of the device. The appearance of ECL from DPA molecules of the transducer in reaction with a relatively new ECL co-reactant tetraphenylborate (TPB) in aqueous solution has demonstrated the applicability of spin-coating technique for creation of new types of ECL transducers. Application of such transducers allows full use of the unique properties of TPB co-reactant and eliminates a problem of formation of TPB based precipitates, which occurs when such common fluorophore as Ru(bpy)3 2 + is utilized.
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 151-156
Generation of Fluorescent Nanoparticles by Laser Fragmentation Technique for Electrochemiluminescent Assay
The work describes application of semiconductor quantum dots (QDs) in electrochemiluminescent assay of amine compounds and development of new method for production of shell-free semiconductor nanoparticles using laser fragmentation technique. Two basic strategies of electroanalytical application of QDs are presented. One is based on electrode modification with polymer films containing CdSe QDs that directly participate in ECL reaction with amine coreactants. The other is based on sensitization of ECL emission from fluorescent amino acids with CdSe QDs. We have also described efficient top-down method of fluorescent CdSe nanoparticles synthesis using laser fragmentation of its powder suspension in dimethylformamide, optical properties of produced QDs and discussed the applicability of produced nanoparticles for electroanalytical techniques.
- 1 September 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 151-156
Generation of Fluorescent Nanoparticles by Laser Fragmentation Technique for Electrochemiluminescent Assay
The work describes application of semiconductor quantum dots (QDs) in electrochemiluminescent assay of amine compounds and development of new method for production of shell-free semiconductor nanoparticles using laser fragmentation technique. Two basic strategies of electroanalytical application of QDs are presented. One is based on electrode modification with polymer films containing CdSe QDs that directly participate in ECL reaction with amine coreactants. The other is based on sensitization of ECL emission from fluorescent amino acids with CdSe QDs. We have also described efficient top-down method of fluorescent CdSe nanoparticles synthesis using laser fragmentation of its powder suspension in dimethylformamide, optical properties of produced QDs and discussed the applicability of produced nanoparticles for electroanalytical techniques.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 458-461
Top-down Synthesized CdSe Nanoparticles for Electroanalytical and Labeling Applications
In this work the prospects of analytical application of semiconductor nanocrystals synthesized using laser fragmentation method are discussed. The method of fluorescent CdSe nanoparticles synthesis using fragmentation of its powder suspension in dimethylformamide as well as optical properties of produced nanoparticles are described. The fragmentation method allows simple and efficient production of ultrasmall nanocrystals of high purity with unique properties that give good opportunity for using such structures as light emitting species in electrochemiluminescent analytical techniques and for biological imaging.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 458-461
Top-down Synthesized CdSe Nanoparticles for Electroanalytical and Labeling Applications
In this work the prospects of analytical application of semiconductor nanocrystals synthesized using laser fragmentation method are discussed. The method of fluorescent CdSe nanoparticles synthesis using fragmentation of its powder suspension in dimethylformamide as well as optical properties of produced nanoparticles are described. The fragmentation method allows simple and efficient production of ultrasmall nanocrystals of high purity with unique properties that give good opportunity for using such structures as light emitting species in electrochemiluminescent analytical techniques and for biological imaging.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 526-529
Nanotechnological Electrochemiluminescent Transducer for Heterogeneous Detection of 5,6,11,12-tetraphenyltetracene
This work is devoted to development of the nanotechnological electrochemiluminescent transducer for heterogeneous detection of 5,6,11,12-tetraphenyltetracene as a representative member of polycyclic aromatic hydrocarbons (PAHs) in water. This method has the advantage of incorporating the analyte into the supramolecular assembly nanolayer on the electrode, and resulted in the increase in the surface concentration of the target analyte as well as lowering the limit of detection. For a rational choice of the amphiphilic matrix for model PAH, quantum chemical calculations were performed to supplement the experimental results. Interestingly, PMMA was found to be the best matrix for the preparation of homogenous supramolecular assembly.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 526-529
Nanotechnological Electrochemiluminescent Transducer for Heterogeneous Detection of 5,6,11,12-tetraphenyltetracene
This work is devoted to development of the nanotechnological electrochemiluminescent transducer for heterogeneous detection of 5,6,11,12-tetraphenyltetracene as a representative member of polycyclic aromatic hydrocarbons (PAHs) in water. This method has the advantage of incorporating the analyte into the supramolecular assembly nanolayer on the electrode, and resulted in the increase in the surface concentration of the target analyte as well as lowering the limit of detection. For a rational choice of the amphiphilic matrix for model PAH, quantum chemical calculations were performed to supplement the experimental results. Interestingly, PMMA was found to be the best matrix for the preparation of homogenous supramolecular assembly.
- 26 March 2014
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 50 (3) , 260-266
Electrochemiluminescence at nitrogen doped diamond-like carbon film electrodes
In the given paper the results of investigation of nitrogen doped diamond-like carbon films (DLF) for the fabrication of electrodes of electrochemical and electrochemiluminescent (ECL) cells are presented. The surface nanomorphology of modified electrodes was studied using the atomic-force microscopy method. The mechanisms of ECL reactions with Ru(bpy) 3 1+ /Ru(bpy) 3 3+ (recombination Ru(bpy) 3 3+ /OH− (ECL without co-reactant) and Ru(bpy) 3 3+ /tripropylamine (ECL with co-reactant) were studied on DLF modified electrodes in the aqueous solution. The work shows advantages of DLF as an electrode material for further analytical applications.
- 26 March 2014
- Published by Pleiades Publishing Ltd in Russian Journal of Electrochemistry
- Vol. 50 (3) , 260-266
Electrochemiluminescence at nitrogen doped diamond-like carbon film electrodes
In the given paper the results of investigation of nitrogen doped diamond-like carbon films (DLF) for the fabrication of electrodes of electrochemical and electrochemiluminescent (ECL) cells are presented. The surface nanomorphology of modified electrodes was studied using the atomic-force microscopy method. The mechanisms of ECL reactions with Ru(bpy) 3 1+ /Ru(bpy) 3 3+ (recombination Ru(bpy) 3 3+ /OH− (ECL without co-reactant) and Ru(bpy) 3 3+ /tripropylamine (ECL with co-reactant) were studied on DLF modified electrodes in the aqueous solution. The work shows advantages of DLF as an electrode material for further analytical applications.
- 1 January 2011
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 136 (3) , 598-604
Electrogenerated chemiluminescence in systems with tetraphenylborate anion as a co-reactant
The study of electrogenerated chemiluminescence (ECL) in aqueous and non-aqueous media with tetraphenylborate anion as a co-reactant is reported. The obtained results indicate that tetraphenylborate acts according to an oxidative reduction scheme and forms a strong reducer after being homogeneously oxidized by a radical cation or dication of luminophore. Spectral measurements prove that light emission originates from the luminophore present in solution and practically no emission occurs when only tetraphenylborate ion is oxidized at the electrode. Since the tetraphenylborate ion is a well known analytical reactant and precipitates a number of metal and organic cations its electrochemiluminescent detection can be used for their assay. It can also be applied as an efficient co-reactant for electrogenerated chemiluminescence excitation both in aqueous and non-aqueous media.
- 1 January 2011
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 136 (3) , 598-604
Electrogenerated chemiluminescence in systems with tetraphenylborate anion as a co-reactant
The study of electrogenerated chemiluminescence (ECL) in aqueous and non-aqueous media with tetraphenylborate anion as a co-reactant is reported. The obtained results indicate that tetraphenylborate acts according to an oxidative reduction scheme and forms a strong reducer after being homogeneously oxidized by a radical cation or dication of luminophore. Spectral measurements prove that light emission originates from the luminophore present in solution and practically no emission occurs when only tetraphenylborate ion is oxidized at the electrode. Since the tetraphenylborate ion is a well known analytical reactant and precipitates a number of metal and organic cations its electrochemiluminescent detection can be used for their assay. It can also be applied as an efficient co-reactant for electrogenerated chemiluminescence excitation both in aqueous and non-aqueous media.
- 30 December 2008
- Published by Elsevier in Electrochimica Acta
- Vol. 54 (2) , 360-363
Aqueous electrochemiluminescence of polycyclic aromatic hydrocarbons immobilized into Langmuir–Blodgett film at the electrode
- 30 December 2008
- Published by Elsevier in Electrochimica Acta
- Vol. 54 (2) , 360-363
Aqueous electrochemiluminescence of polycyclic aromatic hydrocarbons immobilized into Langmuir–Blodgett film at the electrode
- 17 October 2000
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 368 (5) , 439-442
Analytical applications of electrochemiluminescence: an overview
- 17 October 2000
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 368 (5) , 439-442
Analytical applications of electrochemiluminescence: an overview
- 1 January 1999
- Published by Begell House Inc. Publishers in Telecommunications and Radio Engineering
- Vol. 53 (7-8) , 166-170
Development of Evaluation Criteria and Optimization of Electrochemiluminescent Compositions for Analyzing the Heterogeneity of Conducting Surfaces
- 1 January 1999
- Published by Begell House Inc. Publishers in Telecommunications and Radio Engineering
- Vol. 53 (7-8) , 166-170
Development of Evaluation Criteria and Optimization of Electrochemiluminescent Compositions for Analyzing the Heterogeneity of Conducting Surfaces
- 1 February 1978
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 28 (2) , 197-202
Steady-state electrochemiluminescence in solutions with organometallic electrolytes
- 1 February 1978
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 28 (2) , 197-202
Steady-state electrochemiluminescence in solutions with organometallic electrolytes