Omar M. Elmeligy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Omar M. Elmeligy has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Abdelrazek E. Ebrahim1 shared publication
- Belal AbdelRahman
Concordia University
1 shared publication - Hamed S. Askar
Professor, Structural Engineering Department, Faculty of Engineering, Mansoura University, Mansoura 35516, Egypt
1 shared publication - Khaled Galal
Concordia Univ
1 shared publication - Mashhour A. Ghoneim1 shared publication
- Salah E. El-Metwally1 shared publication
Latest Publications
- 30 June 2021
- Published by Golden Light Publishing in Journal of Structural Engineering & Applied Mechanics
- Vol. 4 (2) , 111-125
Refined strength prediction of concrete 2D bottle-shaped struts
For better strength prediction using strut-and-tie models (STM), it is essential to use reliable strength parameters of the model components; e.g., struts, ties, and nodes. Among all the elements of the STM, the strength of the bottle-shaped struts is not well quantified. The purpose of this study is to develop more accurate formulas for the calculation of the effectiveness factors for 2D bottle-shaped struts, that are unreinforced, reinforced with minimum reinforcement, and reinforced with sufficient transverse reinforcement. The nonlinear finite element analysis, with the aid of the software ABAQUS, has been utilized in this study, which has been verified against experimental tests. The study has been carried out for grades of concrete varying from 20 to 100MPa, and for bearing plate to width ratio varying from 0.1 to 0.9. The obtained formulas for the effectiveness factors of bottle-shaped struts are functions of the concrete strength, which is not the case with the ACI 318-19 provisions. These formulas have been verified against experimental tests and have been compared with the ACI 318-19 provisions. The predictions based on these formulas are more accurate than those based on the ACI 318-19 provisions. Also, the results from these formulas are always on the safe side. On the other hand, the ACI 318-19 provisions lead to unsafe results in the case of high-strength concrete and very conservative results for the case of unreinforced struts from normal-strength concrete.
- 30 June 2021
- Published by Golden Light Publishing in Journal of Structural Engineering & Applied Mechanics
- Vol. 4 (2) , 111-125
Refined strength prediction of concrete 2D bottle-shaped struts
For better strength prediction using strut-and-tie models (STM), it is essential to use reliable strength parameters of the model components; e.g., struts, ties, and nodes. Among all the elements of the STM, the strength of the bottle-shaped struts is not well quantified. The purpose of this study is to develop more accurate formulas for the calculation of the effectiveness factors for 2D bottle-shaped struts, that are unreinforced, reinforced with minimum reinforcement, and reinforced with sufficient transverse reinforcement. The nonlinear finite element analysis, with the aid of the software ABAQUS, has been utilized in this study, which has been verified against experimental tests. The study has been carried out for grades of concrete varying from 20 to 100MPa, and for bearing plate to width ratio varying from 0.1 to 0.9. The obtained formulas for the effectiveness factors of bottle-shaped struts are functions of the concrete strength, which is not the case with the ACI 318-19 provisions. These formulas have been verified against experimental tests and have been compared with the ACI 318-19 provisions. The predictions based on these formulas are more accurate than those based on the ACI 318-19 provisions. Also, the results from these formulas are always on the safe side. On the other hand, the ACI 318-19 provisions lead to unsafe results in the case of high-strength concrete and very conservative results for the case of unreinforced struts from normal-strength concrete.