VVVijay Vaiyapuri

Vijay Vaiyapuri

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Vijay Vaiyapuri has a total of 29 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Hot-Pressed SnS/rGO Electrodes for High-Power Asymmetric Supercapacitors

    by Nivin Thulasibai Sasidharan, Vijay Vaiyapuri, Karvannan Elamurugan, Ajaijawahar Kaliyaperumal, Navaneethan Mani, Karthigeyan Annamalai

    Herein, we present the rational engineering of SnS/reduced graphene oxide (rGO) composites to enhance pseudocapacitance through carrier concentration optimization. The orthorhombic pnma-based SnS showed transitions from p- to n-type transport with the addition of rGO. This leads to changes in the bandgap, Fermi levels, conductivity, and diffusion coefficient to achieve the desired properties. The SnS/rGO 5% composite illustrates a specific capacitance of 200 F/g at 1 A/g, three times higher than that of pure SnS owing to its extrinsic pseudocapacitive nature and diffusion-controlled kinetics. The half-cell demonstrates exceptional capacitance retention of 93% over 1200 cycles, attributed to the conducting framework provided by rGO. In a full-cell configuration, using SnS/rGO 5% as the anode and activated carbon as the cathode, an operational voltage of 1.2 V is obtained. This configuration delivers a specific capacitance of 100 F/g at 1 A/g and maintains a capacity retention of 88% at 40 A/g for 5000 cycles. The energy density is 20.081 Wh/kg, and the power density is 22,454 W/kg for the asymmetric SnS/rGO||activated carbon (AC) device. Furthermore, two identical full cells can power a red LED for 128 s, an orange LED for 83 s, and a green LED for 61 s, demonstrating their practical potential in energy storage applications.

  • Carrier–phonon decoupling-driven enhanced thermoelectric performance of Sb–Bi co-doped Mg2Si0.6Sn0.4 solid solution

    by M. Saran, V. Vijay, S. Harish, N. Wakiya, M. Navaneethan, P. Justin Jesuraj, J. Archana

    Strong carrier–phonon coupling poses a significant challenge to decoupling of electrical and thermal transport in Mg2(Si, Sn)-based systems, which limits their thermoelectric performance over a wide temperature range. Herein, we demonstrate that Sb–Bi co-doping in Mg2Si0.6Sn0.4 solid solutions modulates carrier–phonon interactions through acoustic phonon scattering and alloying-induced band structure tuning, respectively. This strategy effectively optimizes the carrier concentration while simultaneously tuning the alloy scattering parameter and acoustic phonon scattering potential, resulting in weakened carrier–phonon coupling and enhanced carrier transport. The optimized composition, Mg2(Si0.6Sn0.4)0.98Bi0.015Sb0.005, exhibits enhanced electrical transport with a high weighted mobility (μW) of 123 cm2 V−1 s−1 and a superior power factor of 3 mW m−1 K−2. Furthermore, the synergistic effect of multiple phonon scattering mechanisms results in an ultra-low lattice thermal conductivity of 0.89 W m−1 K−1. Consequently, a record-high figure of merit (zTmax) of 1.57 at 753 K and zTavg of ∼0.9 over 303–753 K were achieved, highlighting a promising strategy for optimizing carrier–phonon dynamics in n-type Mg2(Si, Sn)-based thermoelectric (TE) materials.

  • Open Access

    Grain-boundary and interfacial scattering enable an excellent thermoelectric performance in carbon nanofiber reinforced silver selenide composites

    by Tony Mathew, V. Vijay, J. Archana, S. Ponnusamy, M. Navaneethan

    Interface-engineered carbon nanofiber incorporation in Ag 2 Se decouples thermal and electrical transport, yielding an ultralow lattice thermal conductivity and a zT of 1.1 at 393 K.

  • Open Access

    Synergistic phonon suppression and transport optimization in Ge-substituted Cu 2 SnSe 3 enabled by secondary CuSe 2 phase formation

    by S. Karunakaran, V. Vijay, S. Harish, M. Navaneethan, J. Archana

    The CuSe 2 secondary phase formation in Ge substituted Cu 2 SnSe 3 , significantly improves the power factor to 284 µW m −1 K −2 and reducing the lattice thermal conductivity to 0.58 W m −1 K −1 , resulting an enhanced zT of 0.31 at 653 K for Cu 2 Sn 0.3 Ge 0.7 Se 3 .


  • Tuning the phonon dynamics via Sn-resonant impurities assists strong anharmonicity in p -type Zintl Mg3Sb2

    by S. Priyadharshini, V. Vijay, J. Archana, M. Navaneethan

    Mg3Sb2-based Zintl compounds are promising p-type thermoelectric (TE) materials with a hexagonal crystal structure and are considered promising candidates due to their abundance in nature, low cost, and low toxicity. Here, the Sn-substituted p-type Mg3−xZnxSb2-based solid solution was synthesized via spark plasma sintering, and its transport properties were investigated through experimental and theoretical aspects. Sn at Sb sites in Mg1.8Zn1.2Sb2 softens the chemical bonding, and Sn-Sb 5p orbital overlapping introduces resonant states, resulting in an enhanced density of states. The improved carrier concentration of 1.47 × 1019 cm−3 and electrical conductivity of 324 S/cm, with the Seebeck coefficient of 133 μV/K, yielded a maximum power factor of 579.8 μW/mK2 at 753 K. Additionally, Sn doping induced lattice disorders, and point defects led to reduced the sound velocity of 2225 m/s, resulting in a low lattice thermal conductivity of 0.72 W/mK at 753 K. The synergistic effect of an enhanced power factor and suppressed thermal conductivity resulted in a maximum zT of 0.43 at 753 K for Mg1.8Zn1.2Sb1.94Sn0.06. This work underscored the critical role of resonant states and lattice disorders in boosting the TE performance of p-type Mg3−xZnxSb2.


  • Band degeneracy driven high power factor in higher manganese silicide for thermoelectric application

    by J. Karuna, V. Vijay, M. Navaneethan, J. Archana

    Higher Manganese Silicide (HMS), a p-type semiconductor that obeys the 14-th electron rule, exhibits a high Seebeck coefficient and electrical conductivity attributed to the contribution of partially filled d-orbitals near the fermi level and high carrier mobility. However, its thermoelectric performance remains constrained by its high lattice thermal conductivity. To overcome this limitation, Cr and Sn were substituted in HMS in the nominal stoichiometries of Mn1-xCrxSi1.74-ySny (x = 0, 0.06, 0.08, y = 0.001). The Cr doping shifts the chemical potential toward the valence band edge, promoting metallic behavior that led to an enhanced electrical conductivity. Concurrently, the dislocation networks and grain boundary effects minimized the lattice thermal conductivity to ∼1.14 Wm−1K−1, yielding a peak ZT of ∼0.50 at 803 K in Mn0.92Cr0.08Si1.74. To further enhance the Seebeck coefficient, Sn co-doping has been carried out to explore the electronic structure by shifting the chemical potential toward the valence band, which results in enhanced Seebeck coefficient and electrical conductivity via carrier energy filtering. This co-doping approach results in a maximum power factor of ∼1154 μWm−1K−2 at 703 K in the Mn0.92Cr0.08Si1.739Sn0.001 sample, highlighting the synergistic role of Cr and Sn in tuning the carrier transport properties without severely compromising the thermal conductivity. These findings demonstrate that Cr and Sn co-doping serves as a viable approach to enhance the thermoelectric performance of HMS-based materials.


  • Synergistic effect of fermi level modulation and valence band regulation in mohite Cu2SnS3 for thermoelectric applications

    by Parvathi Krishna, V. Vijay, C. Kanagaraj, J. Archana, S. Ponnusamy, M. Navaneethan

    The p-type Cu2SnS3 compounds have been experimentally identified as a promising thermoelectric material. Here, we demonstrate the p-type nature of mohite Cu2SnS3 using experimental techniques as well as density functional theory calculations. The experimental results have shown that Ga substitution at the Sn site remarkably enhances the hole concentration and electrical conductivity, reduces the bandgap, and decreases the thermal conductivity, resulting in increased figure of merit. First principle calculations have indicated that Ga substitution changes the electronic structure of Cu2SnS3, primarily due to the reduction in lattice volume and interatomic bond distances. Notably, the appearance of DOS states near the Fermi level has been significantly increased, driven by enhanced hybridization among Cu 3d, Ga 4p, Sn 5p, and S 3p orbitals, which has led to increased electrical conductivity of Cu2Sn0.80Ga0.20S3 to 79 S/cm. Moreover, the substitution of Ga in Cu2SnS3 modifies the electronic structure of Cu2SnS3 substantially, especially the density of states near fermi level is increased, which leads to high carrier concentration of 9.38 × 1020 cm−3, power factor of 329 μW/mK2, and lattice thermal conductivity of 0.50 W/mK, thus high zT of 0.4 is realized in Cu2Sn0.70Ga0.20S3.


  • Carrier–phonon coupling driven enhanced thermoelectric performance of Sn-substituted bismuth sulphide for intermediate-temperature applications

    by E. Karvannan, V. Vijay, T. S. Nivin, M. Navaneethan, J. Archana, A. Karthigeyan

    Sn substitution in Bi2S3 gives a significantly optimized power factor of 192 μW m−1 K−2 with a low lattice thermal conductivity of 0.340 W m−1 K−1, resulting in an enhanced zT of 0.42 at 623 K for the Bi1.90Sn0.10S3 sample.


  • Probing the band structure and phonon dynamics in Fe mediated Cu2SnS3 for thermoelectric applications

    by Parvathi Krishna, V. Vijay, C. Kanagaraj, J. Archana, S. Ponnusamy, M. Navaneethan

    Ternary Cu2SnS3 (CTS) is a less toxic, earth abundant, and low-cost p-type semiconductor material, suitable for thermoelectric applications, which can work at mid-temperature. This work aims to investigate the effect of substituting Fe on the thermoelectric properties of the CTS system. It is found that the electrical conductivity enhanced after Fe substitution due to the simultaneous enhancement of carrier concentration, as well as a reduced bandgap from 0.88 to 0.5 eV. The high power factor of ∼514 μW/mK2 was obtained for the Cu2Sn0.7Fe0.3S3 sample. The Fe substitution generated different types of phonon scatterings, such as mass fluctuation scattering arising from the difference in atomic mass of Sn and Fe and strain field scattering as a result of size and interatomic coupling force difference between Sn and Fe. Accordingly, the Fe-substituted CTS samples obtained the thermal conductivity of 0.45 W/mK at 753 K. In addition, the density functional theory calculations reveal that the substitution of Fe in Cu2SnS3 significantly alters the electronic structure and reduces the bandgap, resulting in enhanced electrical conductivity and power factor, thereby a high zT of ∼0.5 is obtained in Cu2Sn0.7Fe0.3S3.


  • Band Flattening and Strain Field Assists an Excellent Thermoelectric Performance of n‐type Bi2Se3 for Room to Mid‐Temperature Application

    by Vijay Vaiyapuri, Kamalakannan Shanmugasundaram, Archana Jayaram, Navaneethan Mani

    Bismuth selenide, (Bi2Se3) is a typical n‐type V‐VI chalcogenide‐based thermoelectric (TE) material with high lattice thermal conductivity, which limits its TE performance. Single element doping is generally adopted to enhance the TE performance, since it is not affect significantly. Herein, it is revealed that the impact of the co‐doping strategy boost the TE performance of Bi2Se3 through tuning the band structure and phonon transport properties. The synergy of isovalent Ga (gallium) and aliovalent Ge (germanium) co‐doping produces a noteworthy improvement in carrier tuning from −1.1 × 1018 to −3.56 × 1018 cm−3. Bi1.95Ga0.05Ge0.033Se3 sample reached the enhanced power factor of 1403 µWm−1K−2 obtained at 303 K. The reduced low lattice thermal conductivity of 0.24 Wm−1K−1 is occurred by the multi‐scale phonon scattering mechanisms through the dissemination of strain field raised from various defects. The combined strategy of flat band structure and low lattice thermal conductivity significantly optimized the thermoelectric zT of 0.7 is achieved at 513 K and the highest zTaverage of 0.68 is obtained. The maximum zT values leads to attain a theoretical efficiency of 5.9% in the temperature range between 333–573 K. This work shows a practical approach to improve the zT of n‐type Bi2Se3 via co‐doping.