Kaidong Peng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kaidong Peng has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Alec Yen
Massachusetts Institute of Technology
4 shared publications - Jennifer Wang
Massachusetts Institute of Technology
4 shared publications - Kevin P. O'Brien
Department of Electrical Engineering and Computer Science Massachusetts Institute of Technology Cambridge USA
4 shared publications - Andres E. Lombo
Department of Electrical Engineering and Computer Science, Massachusetts Institute of Technology, Cambridge, MA, USA
3 shared publications - Mollie E. Schwartz
Lincoln Laboratory, Massachusetts Institute of Technology, Lexington, USA
3 shared publications - Bethany M. Niedzielski
Lincoln Laboratory, Massachusetts Institute of Technology
2 shared publications
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 36 (8) , 1700910
Designing Josephson Traveling-Wave Parametric Amplifiers: EM-Circuit Cosimulation and Experimental Validation
The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 36 (8) , 1700910
Designing Josephson Traveling-Wave Parametric Amplifiers: EM-Circuit Cosimulation and Experimental Validation
The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.
- 27 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 882-892
Reflectionless Filter for Superconducting Quantum Circuits
Protecting superconducting quantum circuits from nonideal return loss, including out-of-band circulator behavior, and enhancing the performance of broadband quantum-limited amplifiers can be accomplished using a superconducting version of a special class of microwave filters known as reflectionless filters. These filters can simultaneously permit low passband loss to preserve quantum efficiency and broadband reflectionless characteristics in the stop and pass bands. The filter also suppresses thermal photons emitted in its passband from the termination resistors by the nature of the dual-network topology. This work will review the application, theory, design, and modeling of a superconducting reflectionless filter, followed by fabrication details and the presentation of cryogenic performance measurements of a monolithic device. The filter was fabricated using Al on Si and incorporated NiCr resistors, allowing simple integration with other superconducting quantum devices. The filter with an area of 0.6 mm2 achieves insertion loss of $-0.75{\,}\text {dB}$ ( $\sigma = 0.24{\,}\text {dB}$ ), including its connectorized package over a 80% fractional bandwidth centered at 8 GHz, and 10-dB packaged return loss from dc to above 14.5 GHz.
- 27 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 882-892
Reflectionless Filter for Superconducting Quantum Circuits
Protecting superconducting quantum circuits from nonideal return loss, including out-of-band circulator behavior, and enhancing the performance of broadband quantum-limited amplifiers can be accomplished using a superconducting version of a special class of microwave filters known as reflectionless filters. These filters can simultaneously permit low passband loss to preserve quantum efficiency and broadband reflectionless characteristics in the stop and pass bands. The filter also suppresses thermal photons emitted in its passband from the termination resistors by the nature of the dual-network topology. This work will review the application, theory, design, and modeling of a superconducting reflectionless filter, followed by fabrication details and the presentation of cryogenic performance measurements of a monolithic device. The filter was fabricated using Al on Si and incorporated NiCr resistors, allowing simple integration with other superconducting quantum devices. The filter with an area of 0.6 mm2 achieves insertion loss of $-0.75{\,}\text {dB}$ ( $\sigma = 0.24{\,}\text {dB}$ ), including its connectorized package over a 80% fractional bandwidth centered at 8 GHz, and 10-dB packaged return loss from dc to above 14.5 GHz.
- Open Access
Reflection-less filter for superconducting quantum circuits
Protecting superconducting quantum circuits from non-ideal return loss, including out-of-band circulator behavior and enhancing the performance of broadband quantum-limited amplifiers can be accomplished using a superconducting version of a special class of microwave filters known as reflection-less filters. These filters can simultaneously permit low pass band loss to preserve quantum efficiency and broad band reflection-less characteristics in the stop and pass bands. The filter also suppresses thermal photons emitted in its pass band from the termination resistors by the nature of the dual network topology. This work will review the application, theory, design, and modeling of a superconducting reflection-less filter, followed by fabrication details and the presentation of cryogenic performance measurements of a monolithic device. The filter was fabricated using Al on Si, incorporating NiCr resistors, which allows for simple integration with other superconducting quantum devices. The filter with an area of 0.6 $\mathrm{\mathbf{mm^2}}$ achieves insertion loss below 1 dB, including its connectorized package over a 80\% fractional bandwidth centered at 8 GHz, and 10 dB packaged return loss from DC to above 14.5 GHz.Open AccessReflection-less filter for superconducting quantum circuits
Protecting superconducting quantum circuits from non-ideal return loss, including out-of-band circulator behavior and enhancing the performance of broadband quantum-limited amplifiers can be accomplished using a superconducting version of a special class of microwave filters known as reflection-less filters. These filters can simultaneously permit low pass band loss to preserve quantum efficiency and broad band reflection-less characteristics in the stop and pass bands. The filter also suppresses thermal photons emitted in its pass band from the termination resistors by the nature of the dual network topology. This work will review the application, theory, design, and modeling of a superconducting reflection-less filter, followed by fabrication details and the presentation of cryogenic performance measurements of a monolithic device. The filter was fabricated using Al on Si, incorporating NiCr resistors, which allows for simple integration with other superconducting quantum devices. The filter with an area of 0.6 $\mathrm{\mathbf{mm^2}}$ achieves insertion loss below 1 dB, including its connectorized package over a 80\% fractional bandwidth centered at 8 GHz, and 10 dB packaged return loss from DC to above 14.5 GHz. - 27 February 2025
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 23 (2)
Interferometric Purcell suppression of spontaneous emission in a superconducting qubit
- 27 February 2025
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 23 (2)
Interferometric Purcell suppression of spontaneous emission in a superconducting qubit
- 13 September 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (3)
Directional emission of a readout resonator for qubit measurement
- 13 September 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (3)
Directional emission of a readout resonator for qubit measurement
- Top Cited Papers
- 9 February 2023
- Published by Springer Nature in Nature Physics
- p. 1-8
Broadband squeezed microwaves and amplification with a Josephson travelling-wave parametric amplifier
- 9 February 2023
- Published by Springer Nature in Nature Physics
- p. 1-8
Top Cited PapersBroadband squeezed microwaves and amplification with a Josephson travelling-wave parametric amplifier
- Open Access
- 8 April 2022
- Published by American Physical Society (APS) in PRX Quantum
- Vol. 3 (2) , 020306
Floquet-Mode Traveling-Wave Parametric Amplifiers
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation. In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system. Such Floquet-mode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth. Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements. Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers. Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve gain and a QE of of the quantum limit over more than an octave of bandwidth. The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers.- 8 April 2022
- Published by American Physical Society (APS) in PRX Quantum
- Vol. 3 (2) , 020306
Open AccessFloquet-Mode Traveling-Wave Parametric Amplifiers
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation. In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system. Such Floquet-mode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth. Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements. Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers. Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve gain and a QE of of the quantum limit over more than an octave of bandwidth. The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers. - Open Access
- 29 July 2021
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 127 (5) , 050502
Engineering Purely Nonlinear Coupling between Superconducting Qubits Using a Quarton
Strong nonlinear coupling of superconducting qubits and/or photons is a critical building block for quantum information processing. Because of the perturbative nature of the Josephson nonlinearity, linear coupling is often used in the dispersive regime to approximate nonlinear coupling. However, this dispersive coupling is weak and the underlying linear coupling mixes the local modes, which, for example, distributes unwanted self-Kerr nonlinearity to photon modes. Here, we use the quarton to yield purely nonlinear coupling between two linearly decoupled transmon qubits. The quarton’s zero potential enables an ultrastrong gigahertz-level cross-Kerr coupling, which is an order of magnitude stronger compared to existing schemes, and the quarton’s positive potential can cancel the negative self-Kerr nonlinearity of qubits to linearize them into resonators. This ultrastrong cross-Kerr coupling between bare modes of qubit-qubit, qubit-photon, and even photon-photon is ideal for applications such as single microwave photon detection, ultrafast two-qubit gates, and readout.- 29 July 2021
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 127 (5) , 050502
Open AccessEngineering Purely Nonlinear Coupling between Superconducting Qubits Using a Quarton
Strong nonlinear coupling of superconducting qubits and/or photons is a critical building block for quantum information processing. Because of the perturbative nature of the Josephson nonlinearity, linear coupling is often used in the dispersive regime to approximate nonlinear coupling. However, this dispersive coupling is weak and the underlying linear coupling mixes the local modes, which, for example, distributes unwanted self-Kerr nonlinearity to photon modes. Here, we use the quarton to yield purely nonlinear coupling between two linearly decoupled transmon qubits. The quarton’s zero potential enables an ultrastrong gigahertz-level cross-Kerr coupling, which is an order of magnitude stronger compared to existing schemes, and the quarton’s positive potential can cancel the negative self-Kerr nonlinearity of qubits to linearize them into resonators. This ultrastrong cross-Kerr coupling between bare modes of qubit-qubit, qubit-photon, and even photon-photon is ideal for applications such as single microwave photon detection, ultrafast two-qubit gates, and readout.