Jennifer Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jennifer Wang has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Kaidong Peng
Massachusetts Institute of Technology
4 shared publications - Alec Yen
Massachusetts Institute of Technology
2 shared publications - Bethany M. Niedzielski
Lincoln Laboratory, Massachusetts Institute of Technology
2 shared publications Hannah Stickler
MIT Lincoln Laboratory
2 shared publications- Kevin P. O'Brien
Department of Electrical Engineering and Computer Science Massachusetts Institute of Technology Cambridge USA
2 shared publications Kevin P. O’bRien
Massachusetts Institute of Technology
2 shared publications
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 36 (8) , 1700910
Designing Josephson Traveling-Wave Parametric Amplifiers: EM-Circuit Cosimulation and Experimental Validation
The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 36 (8) , 1700910
Designing Josephson Traveling-Wave Parametric Amplifiers: EM-Circuit Cosimulation and Experimental Validation
The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.
- 30 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 03, 54
Advancing Mentorship Through Authentic Research Experiences in High School Quantum Computing and Engineering
Retaining STEM students, particularly those from underrepresented groups, can be enhanced through effective mentorship programs that provide authentic research experiences. The Quantum Engineering Research and You (QuERY) program is a collaborative initiative involving graduate students from MIT and Harvard, who partner with public high school science teachers to mentor high school students. QuERY uses mentorship to equip students with the skills necessary for research in quantum science, engineering, and computing. Throughout the semester, students work in small groups with their graduate student mentors via videoconferencing to develop a genuine research project. This effort culminates in an end-of-program research symposium, where mentors and students meet in person to present their work. Topics related to quantum science and engineering generate significant interest and enthusiasm among student researchers. Various example projects and symposium posters will be discussed. Preliminary results from a study on student self-efficacy will also be shared.
- 30 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 03, 54
Advancing Mentorship Through Authentic Research Experiences in High School Quantum Computing and Engineering
Retaining STEM students, particularly those from underrepresented groups, can be enhanced through effective mentorship programs that provide authentic research experiences. The Quantum Engineering Research and You (QuERY) program is a collaborative initiative involving graduate students from MIT and Harvard, who partner with public high school science teachers to mentor high school students. QuERY uses mentorship to equip students with the skills necessary for research in quantum science, engineering, and computing. Throughout the semester, students work in small groups with their graduate student mentors via videoconferencing to develop a genuine research project. This effort culminates in an end-of-program research symposium, where mentors and students meet in person to present their work. Topics related to quantum science and engineering generate significant interest and enthusiasm among student researchers. Various example projects and symposium posters will be discussed. Preliminary results from a study on student self-efficacy will also be shared.
- 27 February 2025
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 23 (2)
Interferometric Purcell suppression of spontaneous emission in a superconducting qubit
- 27 February 2025
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 23 (2)
Interferometric Purcell suppression of spontaneous emission in a superconducting qubit
- 13 September 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (3)
Directional emission of a readout resonator for qubit measurement
- 13 September 2024
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 22 (3)
Directional emission of a readout resonator for qubit measurement
- Open Access
- 8 April 2022
- Published by American Physical Society (APS) in PRX Quantum
- Vol. 3 (2) , 020306
Floquet-Mode Traveling-Wave Parametric Amplifiers
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation. In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system. Such Floquet-mode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth. Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements. Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers. Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve gain and a QE of of the quantum limit over more than an octave of bandwidth. The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers.- 8 April 2022
- Published by American Physical Society (APS) in PRX Quantum
- Vol. 3 (2) , 020306
Open AccessFloquet-Mode Traveling-Wave Parametric Amplifiers
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward-wave generation. In this work, we introduce a new class of amplifiers that encode the information in the Floquet modes of the system. Such Floquet-mode amplifiers prevent information leakage and overcome the trade-off between quantum efficiency (QE) and bandwidth. Crucially, Floquet-mode amplifiers strongly suppress the nonlinear forward-backward wave coupling and are therefore genuinely directional and readily integrable with qubits, clearing another major obstacle toward broadband ideal quantum measurements. Furthermore, Floquet-mode amplifiers are insensitive to out-of-band impedance mismatch, which otherwise may lead to gain ripples, parametric oscillations, and instability in conventional traveling-wave parametric amplifiers. Finally, we show that a Floquet-mode Josephson traveling-wave parametric amplifier implementation can simultaneously achieve gain and a QE of of the quantum limit over more than an octave of bandwidth. The proposed Floquet scheme is also widely applicable to other platforms, such as kinetic inductance traveling-wave amplifiers and optical parametric amplifiers. - 5 January 2022
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 128 (1) , 015501
Topological Phononic Logic
Topological metamaterials have robust properties engineered from their macroscopic arrangement, rather than their microscopic constituency. They can be designed by starting from Dirac metamaterials with either symmetry-enforced or accidental degeneracy. The latter case provides greater flexibility in the design of topological switches, waveguides, and cloaking devices, because a large number of tuning parameters can be used to break the degeneracy and induce a topological phase. However, the design of a topological logic element—a switch that can be controlled by the output of a separate switch—remains elusive. Here we numerically demonstrate a topological logic gate for ultrasound by exploiting the large phase space of accidental degeneracies in a honeycomb lattice. We find that a degeneracy can be broken by six physical parameters, and we show how to tune these parameters to create a phononic switch that transitions between a topological waveguide and a trivial insulator by ultrasonic heating. Our design scheme is directly applicable to photonic crystals and may guide the design of future electronic topological transistors.
- 5 January 2022
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 128 (1) , 015501
Topological Phononic Logic
Topological metamaterials have robust properties engineered from their macroscopic arrangement, rather than their microscopic constituency. They can be designed by starting from Dirac metamaterials with either symmetry-enforced or accidental degeneracy. The latter case provides greater flexibility in the design of topological switches, waveguides, and cloaking devices, because a large number of tuning parameters can be used to break the degeneracy and induce a topological phase. However, the design of a topological logic element—a switch that can be controlled by the output of a separate switch—remains elusive. Here we numerically demonstrate a topological logic gate for ultrasound by exploiting the large phase space of accidental degeneracies in a honeycomb lattice. We find that a degeneracy can be broken by six physical parameters, and we show how to tune these parameters to create a phononic switch that transitions between a topological waveguide and a trivial insulator by ultrasonic heating. Our design scheme is directly applicable to photonic crystals and may guide the design of future electronic topological transistors.