Lorenzo Degli Esposti
Research Subjects
Lorenzo Degli Esposti has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Elena Bassoli
Department of Engineering “Enzo Ferrari” (DIEF), University of Modena and Reggio Emilia, Via P. Vivarelli, 10, 41125 Modena, Italy
1 shared publication - Emanuele Tognoli
Department of Engineering “Enzo Ferrari”, Università di Modena e Reggio Emilia, Via P. Vivarelli 10, 41125 Modena, Italy
1 shared publication - Nicolò Vincenzi
Department of Engineering “Enzo Ferrari” (DIEF), University of Modena and Reggio Emilia, Via P. Vivarelli, 10, 41125 Modena, Italy
1 shared publication - Silvio Defanti
Department of Engineering “Enzo Ferrari”, University of Modena and Reggio Emilia, Modena, Italy
1 shared publication
Latest Publications
- Open Access
- 18 August 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (16) , 7559
Design for Additive Manufacturing and for Machining in the Automotive Field
High cost, unpredictable defects and out-of-tolerance rejections in final parts are preventing the complete deployment of Laser-based Powder Bed Fusion (LPBF) on an industrial scale. Repeatability, speed and right-first-time manufacturing require synergistic design approaches. In addition, post-build finishing operations of LPBF parts are the object of increasing attention to avoid the risk of bottlenecks in the machining step. An aluminum component for automotive application was redesigned through topology optimization and Design for Additive Manufacturing. Simulation of the build process allowed to choose the orientation and the support location for potential lowest deformation and residual stresses. Design for Finishing was adopted in order to facilitate the machining operations after additive construction. The optical dimensional check proved a good correspondence with the tolerances predicted by process simulation and confirmed part acceptability. A cost and time comparison versus CNC alone attested to the convenience of LPBF unless single parts had to be produced.
- 18 August 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (16) , 7559
Open AccessDesign for Additive Manufacturing and for Machining in the Automotive Field
High cost, unpredictable defects and out-of-tolerance rejections in final parts are preventing the complete deployment of Laser-based Powder Bed Fusion (LPBF) on an industrial scale. Repeatability, speed and right-first-time manufacturing require synergistic design approaches. In addition, post-build finishing operations of LPBF parts are the object of increasing attention to avoid the risk of bottlenecks in the machining step. An aluminum component for automotive application was redesigned through topology optimization and Design for Additive Manufacturing. Simulation of the build process allowed to choose the orientation and the support location for potential lowest deformation and residual stresses. Design for Finishing was adopted in order to facilitate the machining operations after additive construction. The optical dimensional check proved a good correspondence with the tolerances predicted by process simulation and confirmed part acceptability. A cost and time comparison versus CNC alone attested to the convenience of LPBF unless single parts had to be produced.