Anatoliy Shapoval
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Anatoliy Shapoval has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Yurii V. Kovtun
Institute of Plasma Physics of the National Science Center “Kharkiv Institute of Physics and Technology
5 shared publications - Demian Baron
Institute of Plasma Physics
4 shared publications - Mykhailo M. Kozulya
Institute of Plasma Physics
4 shared publications - Valerii Korovin
Institute of Plasma Physics
4 shared publications - Volodymyr E. Moiseenko
Institute of Plasma Physics, National Science Center “Kharkiv Institute of Physics and Technology
4 shared publications - Alexander Krasyuk
Institute of Plasma Physics of the National Science Center “Kharkiv Institute of Physics and Technology 1 ,” 61108 Kharkiv, Ukraine
3 shared publications
Latest Publications
- 29 April 2025
- Published by Taylor & Francis in Fusion Science and Technology
- Vol. 81 (6) , 530-541
Glow Discharge Cleaning on the Uragan-2M Stellarator
- 29 April 2025
- Published by Taylor & Francis in Fusion Science and Technology
- Vol. 81 (6) , 530-541
Glow Discharge Cleaning on the Uragan-2M Stellarator
- Open Access
- 1 April 2024
- Published by AIP Publishing in Physics of Plasmas
- Vol. 31 (4)
ICRF production of plasma with hydrogen minority in Uragan-2M stellarator by two-strap antenna
The experiments on medium-size stellarator Uragan-2M (U-2M) in Kharkiv, Ukraine, are carried on in support of the Wendelstein 7-X (W7-X) experimental program. The scenario ion cyclotron frequency range (ICRF) plasma production at the hydrogen minority regime had been experimentally tested on U-2M and was qualified at the Large Helical Device (LHD). The paper presents the results of further research on the ICRF plasma production. The ICRF discharge studies were carried out in a H2 + He mixture with a controlled hydrogen concentration ranging from few percents to 75%. The two-strap like antenna mimicks the W7-X antenna operated in monopole phasing. The applied RF power was in the range of ∼100 kW. Relatively dense plasma of up to Ne ∼ 1019 m−3 was produced near the first harmonic of the hydrogen cyclotron frequency. The maximum temperature of the electrons and ions was not more than a few tens of electron volt. The characteristic features of RF plasma production and the propagation of electromagnetic waves in the experimental conditions are discussed. The experiments on U-2M and LHD indicate that the minority scenario of ICRF plasma production appears to be scalable and could be used in large stellarator machines. This is, in particular, important for the future experiments ICRF production of target plasma in W-7X in conditions where electron cyclotron resonance heating start-up is not possible.
- 1 April 2024
- Published by AIP Publishing in Physics of Plasmas
- Vol. 31 (4)
Open AccessICRF production of plasma with hydrogen minority in Uragan-2M stellarator by two-strap antenna
The experiments on medium-size stellarator Uragan-2M (U-2M) in Kharkiv, Ukraine, are carried on in support of the Wendelstein 7-X (W7-X) experimental program. The scenario ion cyclotron frequency range (ICRF) plasma production at the hydrogen minority regime had been experimentally tested on U-2M and was qualified at the Large Helical Device (LHD). The paper presents the results of further research on the ICRF plasma production. The ICRF discharge studies were carried out in a H2 + He mixture with a controlled hydrogen concentration ranging from few percents to 75%. The two-strap like antenna mimicks the W7-X antenna operated in monopole phasing. The applied RF power was in the range of ∼100 kW. Relatively dense plasma of up to Ne ∼ 1019 m−3 was produced near the first harmonic of the hydrogen cyclotron frequency. The maximum temperature of the electrons and ions was not more than a few tens of electron volt. The characteristic features of RF plasma production and the propagation of electromagnetic waves in the experimental conditions are discussed. The experiments on U-2M and LHD indicate that the minority scenario of ICRF plasma production appears to be scalable and could be used in large stellarator machines. This is, in particular, important for the future experiments ICRF production of target plasma in W-7X in conditions where electron cyclotron resonance heating start-up is not possible.
- 22 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (24)
Optical emission spectroscopy of vanadium cathodic arc plasma at different nitrogen pressure
Optical emission spectroscopy studies of vanadium plasma in a cathodic-arc discharge in a nitrogen atmosphere have been carried out. Spectral lines of neutral atoms and ions of the cathode material V, V1+, and V2+, and nitrogen N2 and N2+ were observed in the discharge plasma. Analysis and comparison of the intensity of vanadium and nitrogen spectral lines as a function of nitrogen pressure showed that in vacuum excited ions V2+ and V+ are registered, with increasing pressure, the lines V+*, N2*, and N2+* are observed, and at pressures above 0.5 Pa, the neutral vanadium lines are additionally registered. The electron temperature of Te decreases from 5.9 to 3–4 eV with increasing pressure. Studies of cross-sectional scanning electron microscopy images of VN coatings deposited at different nitrogen pressures have shown that a dense, homogeneous, fine-grained microstructure is formed in the coating when the number of neutral V in the plasma is low, while in the presence of a large number of neutrals, the coating structure changes to a dense structure with columnar growth.
- 22 December 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (24)
Optical emission spectroscopy of vanadium cathodic arc plasma at different nitrogen pressure
Optical emission spectroscopy studies of vanadium plasma in a cathodic-arc discharge in a nitrogen atmosphere have been carried out. Spectral lines of neutral atoms and ions of the cathode material V, V1+, and V2+, and nitrogen N2 and N2+ were observed in the discharge plasma. Analysis and comparison of the intensity of vanadium and nitrogen spectral lines as a function of nitrogen pressure showed that in vacuum excited ions V2+ and V+ are registered, with increasing pressure, the lines V+*, N2*, and N2+* are observed, and at pressures above 0.5 Pa, the neutral vanadium lines are additionally registered. The electron temperature of Te decreases from 5.9 to 3–4 eV with increasing pressure. Studies of cross-sectional scanning electron microscopy images of VN coatings deposited at different nitrogen pressures have shown that a dense, homogeneous, fine-grained microstructure is formed in the coating when the number of neutral V in the plasma is low, while in the presence of a large number of neutrals, the coating structure changes to a dense structure with columnar growth.
- 26 June 2022
- Published by Springer Nature in Journal of Fusion Energy
- Vol. 41 (2) , 1-7
Plasma Production in ICRF in the Uragan-2M Stellarator in Hydrogen–Helium Gas Mixture
- 26 June 2022
- Published by Springer Nature in Journal of Fusion Energy
- Vol. 41 (2) , 1-7
Plasma Production in ICRF in the Uragan-2M Stellarator in Hydrogen–Helium Gas Mixture
- 9 August 2021
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Science and innovation
- Vol. 17 (4) , 33-43
Development of Technology for Vacuum Surface Conditioning by RF Plasma Discharge Combined With DC Discharge
Introduction. It is important to decrease light and heavy impurities influxes towards the plasma volume during the high temperature plasma experiments in fusion devices. This is why the conditioning of the wall inner vacuumsurfaces is a basic part of the fusion device operation.Problem Statement. The conventional inner vacuum chamber surface conditioning methods has a significant drawback: sputtering materials in a vacuum chamber. The inner vacuum surfaces can be also conditioned with radio-frequency (RF) discharge plasma, but the conditioning effectiveness is limited by low ion energy.Purpose. The purpose of this research is to develop vacuum surface conditioning technology by the radio frequency plasma combined with DC discharge. Materials and Methods. The noncontact passive method of optical plasma spectroscopy has been used to estimate ion plasma composition. The stainless steel outgassing has been determined in situ with the thermodesorption probe method. The sputtering of the samples has been measured with the weight loss method.Results. The studies of combined discharge have shown that: the anode voltage of combined discharge is lower than in case of the glow discharge; the stainless steel 12Kh18N10T erosion coefficient is about 1.5 times less in thecase of combined discharge than in the glow one; the thermal desorption diagnostic of wall conditions in the DSM-1 has shown better efficiency with the combined discharge as compared with the glow discharge. Theproposed technology is an original one and has no analogs.Conclusions. The reported research results have shown good prospects for the combined discharge usage for plasma walls conditioning and opportunities for using the combined discharge technology for big fusion machines.
- 9 August 2021
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Science and innovation
- Vol. 17 (4) , 33-43
Development of Technology for Vacuum Surface Conditioning by RF Plasma Discharge Combined With DC Discharge
Introduction. It is important to decrease light and heavy impurities influxes towards the plasma volume during the high temperature plasma experiments in fusion devices. This is why the conditioning of the wall inner vacuumsurfaces is a basic part of the fusion device operation.Problem Statement. The conventional inner vacuum chamber surface conditioning methods has a significant drawback: sputtering materials in a vacuum chamber. The inner vacuum surfaces can be also conditioned with radio-frequency (RF) discharge plasma, but the conditioning effectiveness is limited by low ion energy.Purpose. The purpose of this research is to develop vacuum surface conditioning technology by the radio frequency plasma combined with DC discharge. Materials and Methods. The noncontact passive method of optical plasma spectroscopy has been used to estimate ion plasma composition. The stainless steel outgassing has been determined in situ with the thermodesorption probe method. The sputtering of the samples has been measured with the weight loss method.Results. The studies of combined discharge have shown that: the anode voltage of combined discharge is lower than in case of the glow discharge; the stainless steel 12Kh18N10T erosion coefficient is about 1.5 times less in thecase of combined discharge than in the glow one; the thermal desorption diagnostic of wall conditions in the DSM-1 has shown better efficiency with the combined discharge as compared with the glow discharge. Theproposed technology is an original one and has no analogs.Conclusions. The reported research results have shown good prospects for the combined discharge usage for plasma walls conditioning and opportunities for using the combined discharge technology for big fusion machines.