Hitoshi Yashiro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hitoshi Yashiro has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Seung-Taek Myung
Hybrid Materials Research Center Department of Nanotechnology and Advanced Materials Engineering & Sejong Battery Institute Sejong University Seoul South Korea
6 shared publications Masanobu Kumagai
JFE Techno-Research Corporation
4 shared publications- Aklima Jahan
Department of Chemistry, Faculty of Science, University of Chittagong, Chattogram-4331, Bangladesh; Division of Fundamental and Applied Sciences, Graduate School of Sciences and Engineering, Iwate University, 4-3-5 Ueda, Morioka, Iwate 020-8551, Japan
3 shared publications - Ashraful Alam
Iwate University
3 shared publications Eiichi Suzuki
Department of Chemistry and Biological Sciences, Faculty of Science and Engineering, Iwate University, 4-3-5 Ueda, Morioka, Iwate 020-8551, Japan
2 shared publicationsHee Jae Kim
2 shared publications
Latest Publications
- Open Access
- 9 October 2026
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 38 (10) , 2751-2759
Corrosion Inhibition of Aluminum using Methyl-1H-Benzotriazole in Deaerated Fluoride-Sulphate Media: Corrosion Behaviour and Surface Protection
The inhibitive effect of methyl-1H-benzotriazole (Me-BTA) on pure aluminum was investigated in fluoride-sulphate media at different sulphate concentrations. The corrosion rate, surface roughness, surface morphology and elemental composition of aluminum were evaluated after 24 h of immersion at 80 ºC in deaerated fluoride-sulphate solutions both with and without Me-BTA. Weight-loss measurements showed that the addition of Me-BTA decreased the corrosion rate of aluminum under the investigated conditions. AFM analysis further revealed a reduction in the surface roughness of the aluminum specimens in the presence of Me-BTA, indicating a less damaged surface after exposure to the aggressive medium. SEM analysis revealed fewer corrosion-related surface products on the Me-BTA-treated specimens than on the uninhibited aluminum. EDX further detected nitrogen and increased carbon content after treatment, consistent with the presence of Me-BTA-derived species on the surface. These surface and elemental changes support the protective role of Me-BTA and the formation of an inhibitor-derived layer on aluminum in the investigated deaerated fluoride-sulphate media.
- 9 October 2026
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 38 (10) , 2751-2759
Open AccessCorrosion Inhibition of Aluminum using Methyl-1H-Benzotriazole in Deaerated Fluoride-Sulphate Media: Corrosion Behaviour and Surface Protection
The inhibitive effect of methyl-1H-benzotriazole (Me-BTA) on pure aluminum was investigated in fluoride-sulphate media at different sulphate concentrations. The corrosion rate, surface roughness, surface morphology and elemental composition of aluminum were evaluated after 24 h of immersion at 80 ºC in deaerated fluoride-sulphate solutions both with and without Me-BTA. Weight-loss measurements showed that the addition of Me-BTA decreased the corrosion rate of aluminum under the investigated conditions. AFM analysis further revealed a reduction in the surface roughness of the aluminum specimens in the presence of Me-BTA, indicating a less damaged surface after exposure to the aggressive medium. SEM analysis revealed fewer corrosion-related surface products on the Me-BTA-treated specimens than on the uninhibited aluminum. EDX further detected nitrogen and increased carbon content after treatment, consistent with the presence of Me-BTA-derived species on the surface. These surface and elemental changes support the protective role of Me-BTA and the formation of an inhibitor-derived layer on aluminum in the investigated deaerated fluoride-sulphate media.
- Open Access
- 1 July 2025
- Published by The Electrochemical Society of Japan in Electrochemistry
- Vol. 93 (7) , 077002
Surface Modification of Titanium Bipolar Plates with TiN/SBR Coating for PEM Water Electrolysis
Access full-text academic articles: J-STAGE is an online platform for Japanese academic journals.
- 1 July 2025
- Published by The Electrochemical Society of Japan in Electrochemistry
- Vol. 93 (7) , 077002
Open AccessSurface Modification of Titanium Bipolar Plates with TiN/SBR Coating for PEM Water Electrolysis
Access full-text academic articles: J-STAGE is an online platform for Japanese academic journals.
- 27 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 506
Unlocking long-term stability: Electrolyte additives for suppressing zinc dendrite growth in aqueous zinc metal batteries
- 27 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 506
Unlocking long-term stability: Electrolyte additives for suppressing zinc dendrite growth in aqueous zinc metal batteries
- 16 November 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (47) , 20223-20235
Corrosion Behavior of Pure Aluminum in the Simulated and Real Environments for Use as a Bipolar Plate Component in Polymer Electrolyte Membrane Fuel Cells
- 16 November 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (47) , 20223-20235
Corrosion Behavior of Pure Aluminum in the Simulated and Real Environments for Use as a Bipolar Plate Component in Polymer Electrolyte Membrane Fuel Cells
- Open Access
- 22 June 2023
- Published by Wiley in ChemistrySelect
- Vol. 8 (24)
Fluoride Ions Effect on the Corrosion Behavior of Pure Aluminum in Deaerated 0.05 M Sulfuric Acid Solutions
The corrosion study of aluminum‐based materials is the topic of a great scientific attention because of increasing the applications in many sectors of these materials. The fluoride ions (F − ) effect on the corrosion behavior of pure aluminum in deaerated 0.05 M sulfuric acid (H 2 SO 4 ) solutions at 25 °C was investigated. The electrochemical measurements such as open circuit potential and potentiodynamic polarization were accomplished to study the effect of fluoride and sulfate ions present in the test solutions. The optical microscopic and atomic force microscopic images were taken to view the morphologies and surface roughness of pure aluminum which coincidence with the corrosion rates found from the immersion of the test specimens using weight loss method. The surface morphology and elemental compositions of pure aluminum was evaluated by scanning electron microscope and energy dispersive X‐ray spectroscopy, respectively. The results showed that the general corrosion was formed on the surface of pure aluminum. It is also revealed that the surface roughness and amount of corrosion of pure aluminum were increased by the presence of even a very small amount of fluoride ions in deaerated sulfuric acid solutions.
- 22 June 2023
- Published by Wiley in ChemistrySelect
- Vol. 8 (24)
Open AccessFluoride Ions Effect on the Corrosion Behavior of Pure Aluminum in Deaerated 0.05 M Sulfuric Acid Solutions
The corrosion study of aluminum‐based materials is the topic of a great scientific attention because of increasing the applications in many sectors of these materials. The fluoride ions (F − ) effect on the corrosion behavior of pure aluminum in deaerated 0.05 M sulfuric acid (H 2 SO 4 ) solutions at 25 °C was investigated. The electrochemical measurements such as open circuit potential and potentiodynamic polarization were accomplished to study the effect of fluoride and sulfate ions present in the test solutions. The optical microscopic and atomic force microscopic images were taken to view the morphologies and surface roughness of pure aluminum which coincidence with the corrosion rates found from the immersion of the test specimens using weight loss method. The surface morphology and elemental compositions of pure aluminum was evaluated by scanning electron microscope and energy dispersive X‐ray spectroscopy, respectively. The results showed that the general corrosion was formed on the surface of pure aluminum. It is also revealed that the surface roughness and amount of corrosion of pure aluminum were increased by the presence of even a very small amount of fluoride ions in deaerated sulfuric acid solutions.
- 1 October 2021
- Published by Elsevier in Journal of Power Sources
- Vol. 510
Highly concentrated electrolyte enabling high-voltage application of metallic components for potassium-ion batteries
- 1 October 2021
- Published by Elsevier in Journal of Power Sources
- Vol. 510
Highly concentrated electrolyte enabling high-voltage application of metallic components for potassium-ion batteries
- Open Access
- 1 November 2019
- Published by The Materials Research Society of Korea in Korean Journal of Materials Research
- Vol. 29 (11) , 657-663
Physical Properties of Oxide Films Formed by Plasma Anodization on Mg Alloy
- 1 November 2019
- Published by The Materials Research Society of Korea in Korean Journal of Materials Research
- Vol. 29 (11) , 657-663
Open AccessPhysical Properties of Oxide Films Formed by Plasma Anodization on Mg Alloy
- Open Access
- 1 January 2014
- Published by Japan Institute of Electronics Packaging in Transactions of The Japan Institute of Electronics Packaging
- Vol. 7 (1) , 79-86
Multilayered Sn/Ag3Sn Electroplating on Cu Alloys for High Reliable Electronic/Electric Materials
- 1 January 2014
- Published by Japan Institute of Electronics Packaging in Transactions of The Japan Institute of Electronics Packaging
- Vol. 7 (1) , 79-86
Open AccessMultilayered Sn/Ag3Sn Electroplating on Cu Alloys for High Reliable Electronic/Electric Materials