Chunlei Li
Chunlei Li has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Shiyou Li
School of Petrochemical Technology, Lanzhou University of Technology, Lanzhou 730050, PR China
3 shared publications - Chen Zhang
Laboratory of Control of Power Transmission and Conversion, Department of Electrical Engineering, Shanghai Jiao Tong University, Ministry of Education, Shanghai, China
1 shared publication - Dongni Zhao
School of Petrochemical Technology, Lanzhou University of Technology, Lanzhou 730050, PR China
1 shared publication - Fei Xu
State Key Laboratory of Solidification Processing, Center for Nano Energy Materials, Shaanxi Joint Laboratory of Graphene (NPU), School of Materials Science and Engineering, Northwestern Polytechnical University, Xi’an, China
1 shared publication Haitao Shen
School of Petrochemical Technology
1 shared publicationHao Ding
School of Petrochemical Technology, Lanzhou University of Technology, Lanzhou, Gansu 730050, China
1 shared publication
Latest Publications
- 18 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (8) , 13076-13085
Cation-Acceptor DMI Boosts NaNO 3 Solubility via Solvation Regulation for High-Performance Nonaqueous Sodium Rechargeable Batteries
Sodium nitrate (NaNO3) serves as an effective film-forming additive, facilitating the formation of inorganic, nitride-rich solid electrolyte interphase (SEI) layers at the electrode interface. However, its limited solubility in conventional ether-based electrolytes constrains its practical application. To overcome this limitation, a high donor-number solvent, 1,3-dimethyl-2-imidazolidinone (DMI), was introduced to enhance the solubility of NaNO3 in hard carbon (HC)-based sodium-ion batteries. Due to its strong donor number (DN), DMI acts as a cation acceptor, which can disrupt the ion-pairing limitation by attracting Na+ ions and weakening the interaction between Na+ and NO3, thereby increases the solubility of NaNO3 in the ether-based electrolyte to 0.05 M. Meanwhile, in order to overcome the problem of thicker film formation caused by the introduction of DMI, it was preferred that the addition amount of DMI in the electrolyte be 10%. The optimized electrolyte system generates a nitrogen-rich SEI film. As a result, the HC||Na half-cell achieved a specific charge capacity of 300 mAh·g-1 at 0.5 C and a 91% capacity retention after 400 cycles. This work proposes a strategy to manipulate solvation structures by improving NaNO3 solubility via high donor-number solvents, offering a straightforward approach to designing advanced electrolytes for sodium-ion batteries.
- 18 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (8) , 13076-13085
Cation-Acceptor DMI Boosts NaNO 3 Solubility via Solvation Regulation for High-Performance Nonaqueous Sodium Rechargeable Batteries
Sodium nitrate (NaNO3) serves as an effective film-forming additive, facilitating the formation of inorganic, nitride-rich solid electrolyte interphase (SEI) layers at the electrode interface. However, its limited solubility in conventional ether-based electrolytes constrains its practical application. To overcome this limitation, a high donor-number solvent, 1,3-dimethyl-2-imidazolidinone (DMI), was introduced to enhance the solubility of NaNO3 in hard carbon (HC)-based sodium-ion batteries. Due to its strong donor number (DN), DMI acts as a cation acceptor, which can disrupt the ion-pairing limitation by attracting Na+ ions and weakening the interaction between Na+ and NO3, thereby increases the solubility of NaNO3 in the ether-based electrolyte to 0.05 M. Meanwhile, in order to overcome the problem of thicker film formation caused by the introduction of DMI, it was preferred that the addition amount of DMI in the electrolyte be 10%. The optimized electrolyte system generates a nitrogen-rich SEI film. As a result, the HC||Na half-cell achieved a specific charge capacity of 300 mAh·g-1 at 0.5 C and a 91% capacity retention after 400 cycles. This work proposes a strategy to manipulate solvation structures by improving NaNO3 solubility via high donor-number solvents, offering a straightforward approach to designing advanced electrolytes for sodium-ion batteries.
- 17 August 2022
- Published by Elsevier in Electrochimica Acta
- Vol. 429, 141060
Improving electric field strength of interfacial electric double layer and cycle stability of Li-ion battery via LiCl additive
- 17 August 2022
- Published by Elsevier in Electrochimica Acta
- Vol. 429, 141060
Improving electric field strength of interfacial electric double layer and cycle stability of Li-ion battery via LiCl additive
- 5 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 4 (8) , 8003-8015
Boron and Phosphorus Dual-Doped Carbon Coating Improves Electrochemical Performances of LiFe0.8Mn0.2PO4 Cathode Materials
- 5 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 4 (8) , 8003-8015
Boron and Phosphorus Dual-Doped Carbon Coating Improves Electrochemical Performances of LiFe0.8Mn0.2PO4 Cathode Materials
- 1 July 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 344-349
AC-DC Matrix Converter with Positive and Negative Output Capacity in Unbalanced Grid
The study of AC-DC matrix converter under unbalanced power grid is mostly focused on the suppression of the two harmonic of output voltage. In this paper, the voltage type AC-DC matrix converter under unbalanced power network is studied, focusing on the control of the three-phase current in the grid side and the predictive unbalance control strategy with negative sequence voltage compensation is proposed. The strategy can suppress the current harmonics of the grid side, realize the unit power factor and the effect of grid side current sine and high balance under unbalanced power grid, and eliminate the grid side current distortion, in order to reduce the pollution to the power grid. In this strategy, new voltage feedforward quantity is get by the negative sequence voltage compensation and the number of regulators in the current loop in the dq frame is reduced, so that the controller parameter design is greatly simplified. And a de-re-couple SVM modulation strategy with voltage command signal basing on the positive and negative switching is proposed, so that it can meet the requirements of the AC-DC matrix converter with positive and negative output capacity under unbalanced network.
- 1 July 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 344-349
AC-DC Matrix Converter with Positive and Negative Output Capacity in Unbalanced Grid
The study of AC-DC matrix converter under unbalanced power grid is mostly focused on the suppression of the two harmonic of output voltage. In this paper, the voltage type AC-DC matrix converter under unbalanced power network is studied, focusing on the control of the three-phase current in the grid side and the predictive unbalance control strategy with negative sequence voltage compensation is proposed. The strategy can suppress the current harmonics of the grid side, realize the unit power factor and the effect of grid side current sine and high balance under unbalanced power grid, and eliminate the grid side current distortion, in order to reduce the pollution to the power grid. In this strategy, new voltage feedforward quantity is get by the negative sequence voltage compensation and the number of regulators in the current loop in the dq frame is reduced, so that the controller parameter design is greatly simplified. And a de-re-couple SVM modulation strategy with voltage command signal basing on the positive and negative switching is proposed, so that it can meet the requirements of the AC-DC matrix converter with positive and negative output capacity under unbalanced network.