SMSatoshi Matsuo

Satoshi Matsuo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Satoshi Matsuo has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Nickel–silicon interfacial adhesion strength measured by laser spallation

    by Xiao Yan, Jacob M. Diamond, Nathan J. Fritz, Satoshi Matsuo, Kazi F. Rabbi, Ishrat Zarin, Nenad Miljkovic, Paul V. Braun, Nancy R. Sottos

    Thin films of amorphous silicon (a-Si) coated on metals such as nickel (Ni) are one of the most promising anode architectures for high-energy-density lithium-ion (Li-ion) batteries. The performance and longevity of batteries with this type of electrode depend on the integrity of the Ni/a–Si interface. The integrity of the a-Si /Ni bonded interface during cycling is critical, but the experimental characterization of interfacial failure of this material system is highly challenging and there is a sparsity of interface strength data in the literature. Here, we describe a laser spallation (LS) technique to characterize the interfacial adhesion strength of Ni/a–Si multilayer films created by chemical vapor deposition (CVD). The LS technique enables the non-contact measurement of the tensile interfacial strength with high precision when compared to conventional methods for characterizing adhesion. Interferometric measurement combined with finite element analysis shows that the Ni/a–Si interface, created via the CVD of a-Si on Ni surfaces can withstand ≈46–72 MPa in tension before failure initiation. To ensure successful and precise characterization of interfacial adhesion strength using LS, we further develop a design criterion for multi-layer samples by analyzing the thin-film mechanics. Our study provides insights into the strength of the Ni/a–Si interface that governs the performance and durability of high-energy-density anodes and offers design guidelines for improving thin-film electrode integrity.


  • Single carbon fiber transverse electrical resistivity measurement via the van der Pauw method

    by Satoshi Matsuo, Nancy R. Sottos

    Although the electrical properties of carbon fibers and carbon fiber composites are critical to the design of composite materials, a direct measurement of the transverse electrical resistivity of a single carbon fiber has not yet been reported. Significant challenges arise in fabricating specimens and making electrical resistance measurements due to the geometry and small diameter of a single carbon fiber (about 4–7 μm). In this study, we report a specimen design and fabrication technique for measuring the transverse electrical resistance of an individual carbon fiber by the van der Pauw method. IM7 carbon fiber specimens are fabricated by a combination of photolithography and the focused ion beam. Specimen thickness, which is required for resistivity calculations, is measured by atomic force microscopy. We measure mean transverse electrical resistivity of (9.3 ± 0.3) × 10−5 Ω m, which is roughly six times greater than the reported longitudinal values. Our measurement technique can be applied to a range of conductive fibers. More accurate measurements of the electrical conduction in carbon fibers are critical for applications such as electromagnetic interference shielding, structural health monitoring, and lightning strike protection.