M. B. Schwedersky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
M. B. Schwedersky has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
J. C. Dutra
Federal University of Santa Catarina (UFSC), Mechanical Engineering Department, 88040-900 Florianópolis, SC, Brazil
1 shared publicationK. Willms
Welding and Joining Institute (ISF), RWTH Aachen University, Germany
1 shared publication- Régis Henrique Gonçalves Silva
Department of Mechanical Engineering, Federal University of Santa Catarina, Florianopolis, Brazil
1 shared publication U. Reisgen
Welding and Joining Institute (ISF), RWTH Aachen University, Germany
1 shared publication
Latest Publications
- 19 April 2016
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 21 (4) , 275-280
Two-dimensional arc stagnation pressure measurements for the double-electrode GTAW process
Double-electrode gas tungsten arc welding (GTAW) is a relatively new GTAW variant that has been studied and developed over recent years, with the aim being to achieve a robust high-speed and high-current process with subsequent productivity improvements. In this present study, two-dimensional arc stagnation pressure measurements were performed, allowing a broad visualisation of the arc pressure distribution at the area above the welding torch, with a 0.5 mm resolution. The influence of the distance between the electrodes was evaluated and the results were compared with the conventional GTAW process. It was found that this distance greatly modifies the resulting arc morphology and, consequently, the arc pressure distribution. The results showed that the double-electrode process has much lower pressure than the single-electrode GTAW, for example, using the minimal possible distance between the electrodes results in about half of the maximum pressure measured for the single electrode, which would enable the development of high productivity applications.
- 19 April 2016
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 21 (4) , 275-280
Two-dimensional arc stagnation pressure measurements for the double-electrode GTAW process
Double-electrode gas tungsten arc welding (GTAW) is a relatively new GTAW variant that has been studied and developed over recent years, with the aim being to achieve a robust high-speed and high-current process with subsequent productivity improvements. In this present study, two-dimensional arc stagnation pressure measurements were performed, allowing a broad visualisation of the arc pressure distribution at the area above the welding torch, with a 0.5 mm resolution. The influence of the distance between the electrodes was evaluated and the results were compared with the conventional GTAW process. It was found that this distance greatly modifies the resulting arc morphology and, consequently, the arc pressure distribution. The results showed that the double-electrode process has much lower pressure than the single-electrode GTAW, for example, using the minimal possible distance between the electrodes results in about half of the maximum pressure measured for the single electrode, which would enable the development of high productivity applications.