Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Frédéric Sarry has a total of 68 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Reflector‐Free, Highly Confined Love‐Like SAWs Enabled by a Phononic Metasurface for Real‐Time Monitoring of Cell Dynamics

    by Jessica Monaldi, Julio A. Iglesias Martínez, Francis Kosior, Laurent Badie, Halima Alem, Frédéric Sarry, Mourad Oudich

    Surface acoustic wave (SAW) devices are widely used in sensing and biosensing but generally suffer from strong attenuation in liquid environments. Conventional approaches rely on reflectors to reduce these losses, yet these components remain difficult to optimize: limited device miniaturization and increased fabrication complexity. Here, we introduce an innovative design strategy that integrates a phononic metasurface with tailored electromechanical properties of the substrate to generate a type of shear‐horizontal (SH) surface resonance modes that exhibit strong lateral confinement and extremely low radiation into both the substrate bulk and the free surface, eliminating the need for reflectors. This approach enables highly tailorable surface acoustic resonances with distinctive enhanced dynamic strain‐energy confinement leading to significantly high‐quality factors, particularly in water‐loaded conditions. We show the fabrication and experimental validation of the proposed phononic metasurface‐based SAW resonator and showcase its biosensing capabilities through real‐time monitoring of cellular death.

  • Open Access

    Exploring Fluid Dynamics to Analyze Cellular Stress Induced by Surface Acoustic Waves in Biological Applications

    by D. S. Bidouba Sanvany, F. Kosior, D. Beyssen, A. Gigodot, E. Gaudion, F. Sarry

    Our study aims to investigate the impact of SAW on biological cells, including adherent (SaOs-2 osteoblasts) and circulating (THP-1 monocytes) cells, to assess the physical stresses on the latter, specifically acoustic radiation pressure and shear stresses, which are crucial in cell stimulation within biomedicine. We have presented the simulation for extracting shear stresses from circulating and adherent cells at resonant frequencies of 20 and 40 MHz, respectively. We utilized the direct simulation method to enhance liquid-level optimization. No one has previously presented this approach. Our model underwent validation by comparing simulation results with those obtained from the experiment, including wave amplitude, particle velocity temperature, and streaming shape. After validating the simulation model, we determined the shear stresses on the particles. An optimization study showed that the optimal level for adherent cells is 5 mm, whereas for circulating cells, it is 7 mm. We have also demonstrated that the heating is significantly above 20 dBm. The heating exceeds 1°C, which is harmful to biological cells.

  • Micropillared Surface to Enhance the Sensitivity of a Love-Wave Sensor

    by Jérémy Bonhomme, Mourad Oudich, Mohamed Lamine Fayçal Bellaredj, Jean-François Bryche, Pedro Alberto Segura Chavez, Denis Beyssen, Paul G. Charette, Frédéric Sarry

    Surface-acoustic-wave (SAW) sensors have undergone outstanding developments during the last decades. However, for biosensing applications, they struggle to compete with optical sensing technologies. In this work, we present a Love-wave-based sensing platform that leverages the use of the local resonances of micropillars fabricated on the surface of the guiding layer. We demonstrate numerically and experimentally that the Love-wave interaction with the micropillars produces sharp attenuation dips in the transmission spectrum. These dips are associated with the excitations of flexural and torsional resonance modes of the pillars. We utilize these modes to achieve higher detection sensitivity of temperature variation and mass loading using sugar and microbeads concentrations in aqueous solutions. Integrating a lattice of micropillars into SAW-based devices offers a strong potential for detecting low particles concentrations.


  • Open Access

    Biological Effects and Applications of Bulk and Surface Acoustic Waves on In Vitro Cultured Mammal Cells: New Insights

    by Agathe Figarol, Lucile Olive, Olivier Joubert, Luc Ferrari, Bertrand H. Rihn, Frédéric Sarry, Denis Beyssen

    Medical imaging has relied on ultrasound (US) as an exploratory method for decades. Nonetheless, in cell biology, the numerous US applications are mainly in the research and development phase. In this review, we report the main effects on human or mammal cells of US induced by bulk or surface acoustic waves (SAW). At low frequencies, bulk US can lead to cell death. Under specific intensities and exposure times, however, cell proliferation and migration can be enhanced through cytoskeleton fluidization (a reorganization of the actin filaments and microtubules). Cavitation phenomena, frequencies of resonance close to those of the biological compounds, and mechanical transfers of energy from the acoustic pressure could explain those biological outcomes. At higher frequencies, no cavitation is observed. However, USs of high frequency stimulate ionic channels and increase cell permeability and transfection potency. Surface acoustic waves are increasingly exploited in microfluidics, especially for precise cell manipulations and cell sorting. With applications in diagnosis, infection, cancer treatment, or wound healing, US has remarkable potential. More mechanotransduction studies would be beneficial to understand the distinct roles of temperature rise, acoustic streaming and mechanical and electrical stimuli in the field.


  • Open Access

    Development of a Love-Wave Biosensor Based on an Analytical Model

    by Frédéric Sarry, Jeremy Bonhomme, Mourad Oudich, Pedro Alberto Segura Chavez, Denis Beyssen, Omar Elmazria, Mohd Khairuddin Md Arshad, Paul G. Charette

    The present work deals with the development of a Love-wave biosensor for the diagnosis of the modification of cell viscosity. The relevant device performance such as insertion loss, attenuation, phase velocity, and sensitivity needs to be analysed as a function of the device structure and also regarding the effect of the liquid loading. In this study, we used an analytical model based on the equation of motions for a Love wave propagating in a three-layer structure. We show that the effect of the viscous coupling leads to insertion losses and a phase shift that impact the acoustic ratio. A comparison between experimental and theoretical results showed a good agreement between the behaviours as it was observed for the phase shift vs. the insertion loss with a limited difference in values (3.11/3.09—experimental/simulation for the sensitivity to the viscosity for different insertion losses) due to the assumptions made on the model used.


  • Open Access

    Love Wave Sensor with High Penetration Depth for Potential Application in Cell Monitoring

    by Pedro A. Segura Chávez, Jérémy Bonhomme, Mohamed Lamine Fayçal Bellaredj, Lucile Olive, Denis Beyssen, Mourad Oudich, Paul G. Charette, Frédéric Sarry

    Love wave (L-SAW) sensors have been used to probe cell monolayers, but their application to detect changes beyond the focal adhesion points on cell monolayers, as viscosity changes on the cytoskeleton, has not been explored. In this work we present for the first time a Love wave sensor with tuned penetration depth and sensitivity to potentially detect mechanical changes beyond focal adhesion points of cell monolayers. We designed and fabricated a Love wave sensor operating at 30 MHz with sensitivity to detect viscous changes between 0.89 and 3.3 cP. The Love wave sensor was modeled using an acoustic transmission line model, whereas the response of interdigital transducers (IDTs) was modeled with the Campbell’s cross-field circuit model. Our design uses a substrate with a high electromechanical coupling coefficient (LiNbO3 36Y-X), and an 8-µm polymeric guiding layer (SU-8). The design aims to overcome the high insertion losses of viscous liquid environments, and the loss of sensitivity due to the low frequency. The fabricated sensor was tested in a fluidic chamber glued directly to the SU-8 guiding layer. Our experiments with liquids of viscosity similar to those expected in cell monolayers showed a measurable sensor response. In addition, experimentation with SaOs-2 cells within a culture medium showed measurable responses. These results can be of interest for the development of novel cell-based biosensors, and novel characterization tools for cell monolayers.


  • Glycosylated biomarker sensors: advancements in prostate cancer diagnosis

    by Siti Fatimah Abd Rahman, Mohd Khairuddin Md Arshad, Subash C. B. Gopinath, Mohamad Faris Mohamad Fathil, Frédéric Sarry, Conlathan Ibau

    Early detection of prostate cancer using glycosylated biomarker sensors.


  • Theoretical study of a phononic structure for bio-sensing applications

    by J. Bonhomme, M. Oudich, P. A. Segura Chavez, L. Olive, D. Beyssen, P. G. Charette, F. Sarry

    In this work, we investigate the evolution of the properties of a pillar phononic crystal in order to simplify the fabrication process by reducing the thickness of the layer. The structure is constructed by stacking alternate layers of SiO2 and Tungsten. The reduction of the dimensions moves the band gap to the upper frequencies and it is possible to adjust its aperture with the ratio comparing the radius of the cylinder with the layers’ thickness. On a substrate, the pillars give resonant modes that can be excited by shear surface waves and gives a sharp peak in the transmission spectrum of the surface wave with a very high quality factor. We also study the theoretical mass sensitivity of the device and we propose a numerical method to determine the theoretical maximum sensitivity that could be obtain by the pillars system. This pillar based metasurface presents a very promising mass sensitivity and a possible way to increase the performance of SAW bio-sensors.


  • Love wave biosensor to diagnose modification of cell viscoelasticy

    by F. Sarry, P.A. Segura Chavez, J. Bonhomme, L. Olive, D. Beyssen, M. Oudich, P.G. Charette

    In this work we present the development of an integrated microfluidic platform addressing several challenges. The sensor array combines a dual Rayleigh wave and Love wave for the diagnosis of the modification of cell viscoelasticity. Based on simulations taking into equations of motion and Navier-Stokes equation for the viscous liquid region, we evaluate and correlate the Love surface acoustic wave sensing part in order to enhance the sensitivity. The results corroborate the idea that the whole measurement system must be considered to develop an integrated optimized analysis system.


  • Open Access

    Phononic Crystal Made of Multilayered Ridges on a Substrate for Rayleigh Waves Manipulation

    by Mourad Oudich, Bahram Djafari-Rouhani, Bernard Bonello, Yan Pennec, Frédéric Sarry

    We present a phononic crystal to achieve efficient manipulation of surface acoustic waves (SAW). The structure is made of finite phononic micro-ridges arranged periodically in a substrate surface. Each ridge is constructed by staking silicon and tungsten layers so that it behaves as one-dimensional phononic crystal which exhibits band gaps for elastic waves. The band gap allows the existence of resonance modes where the elastic energy is either confined within units in the free end of the ridge or the ones in contact with the substrate. We show that SAW interaction with localized modes in the free surface of the ridge gives rise to sharp attenuation in the SAW transmission, while the modes confined within the ridge/substrate interface cause broad band attenuations of SAW. Furthermore, we demonstrate that the coupling between the two kinds of modes within the band gap gives high SAW transmission amplitude in the form of Fano-like peaks with high quality factor. The structure could provide an interesting solution for accurate SAW control for sensing applications, for instance.