Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Xuetao Wang has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Weight Update in Ferroelectric Memristors with Identical and Nonidentical Pulses

    by Suzanne Lancaster, Maximilien Remillieux, Moritz Engl, Viktor Havel, Cláudia Silva, Xuetao Wang, Thomas Mikolajick, Stefan Slesazeck

    Ferroelectric tunnel junctions (FTJs) are a class of memristor which promise low-power, scalable, field-driven analog operation. In order to harness their full potential, operation with identical pulses is targeted. In this paper, several weight update schemes for FTJs are investigated, using either nonidentical or identical pulses, and with time delays between the pulses ranging from 1 μs to 10 s. Experimentally, a method for achieving nonlinear weight update with identical pulses at long programming delays is demonstrated by limiting the switching current via a series resistor. Simulations show that this concept can be expanded to achieve weight update in a 1T1C cell by limiting the switching current through a transistor operating in subthreshold or saturation mode. This leads to a maximum linearity in the weight update of 86% for a dynamic range (maximum switched polarization) of 30 μC/cm2. It is further demonstrated via simulation that engineering the device to achieve a narrower switching peak increases the linearity in scaled devices to >93% for the same range.


  • Ferroelectric Al0.85Sc0.15N and Hf0.5Zr0.5O2 Domain Switching Dynamics

    by Roberto Guido, Xuetao Wang, Bohan Xu, Ruben Alcala, Thomas Mikolajick, Uwe Schroeder, Patrick D. Lomenzo

    The capability to reliably program partial polarization states with nanosecond programming speed and femtojoule energies per bit in ferroelectrics makes them an ideal candidate to realize multibit memory elements for high-density crossbar arrays, which could enable neural network models with a large number of parameters at the edge. However, a thorough understanding of the domain switching dynamics involved in the polarization reversal is required to achieve full control of the multibit capability. Transient current integration measurements are adopted to investigate the domain dynamics in aluminum scandium nitride (Al0.85Sc0.15N) and hafnium zirconium oxide (Hf0.5Zr0.5O2). The switching dynamics are correlated to the crystal structure of the films. The contributions of domain nucleation and domain wall motion are decoupled by analyzing the rate of change of the time-dependent normalized switched polarization. Thermally activated creep domain wall motion characterizes the Al0.85Sc0.15N switching dynamics. The statistics of independently nucleating domains and the domain wall creep motion in Hf0.5Zr0.5O2 are associated with the spatially inhomogeneous distribution of local switching field due to polymorphism, absence of preferential crystallite orientation, as well as defects and charges that can be located at the grain boundaries. The c-axis texture, single-phase nature, and strong likelihood of less fabrication process-induced defects contribute to the homogeneity of the local switching field in Al0.85Sc0.15N. Nonetheless, defects generated and redistributed upon bipolar electric field switching cycling result in Al0.85Sc0.15N domain wall pinning. The wake-up effect in Hf0.5Zr0.5O2 is explained thorough the continuous addition of switchable regions associated with two independent distributions of characteristic switching times.


  • Influence of Biaxial Strain and Interfacial Layer Growth on Ferroelectric Wake-Up and Phase Transition Fields in ZrO2

    by Bohan Xu, Richard Ganser, Kristina M. Holsgrove, Xuetao Wang, Pramoda Vishnumurthy, Thomas Mikolajick, Uwe Schroeder, Alfred Kersch, Patrick D. Lomenzo

    Investigations on fluorite-structured ferroelectric HfO2/ZrO2 thin films are aiming to achieve high-performance films required for memory and computing technologies. These films exhibit excellent scalability and compatibility with the complementary metal-oxide semiconductor process used by semiconductor foundries, but stabilizing ferroelectric properties with a low operation voltage in the as-fabricated state of these films is a critical component for technology advancement. After removing the influence of interfacial layers, a linear correlation is observed between the biaxial strain and the electric field for transforming the nonferroelectric tetragonal to the ferroelectric orthorhombic phase in ZrO2 thin films. This observation is supported by applying the principle of energy conservation in combination with ab initio and molecular dynamics simulations. According to the simulations, a rarely reported Pnm21 orthorhombic phase may be stabilized by tuning biaxial strain in the ZrO2 films. This study demonstrates the significant influence of interfacial layers and biaxial strain on the phase transition fields and shows how strain engineering can be used to improve ferroelectric wake-up in ZrO2.


  • Open Access

    Modulation of Oxygen Content and Ferroelectricity in Sputtered Hafnia‐Zirconia by Engineering of Tungsten Oxide Bottom Electrodes

    by Xuetao Wang, Stefan Slesazeck, Thomas Mikolajick, Matthias Grube

    The well‐developed high‐k technologies ease the integration complexity for HfO2‐based ferroelectric (FE) devices in the complementary metal‐oxide semiconductor processes. Sputtered HfxZr(1‐x)O2 (HZO) FEs have proven their thermal compatibility in back‐end‐of‐line (BEOL) integration processes with high remanent polarization (Pr) and a high cycling endurance. With the help of a tungsten oxide (WOx) bottom electrode, the sputtered HZO's FE properties are further advanced in this work. WOx is used to tune the oxygen content in the HZO film, providing an FE performance with a maximum 2Pr of 46 µC cm−2 and an endurance of 108 cycles. Based on this, sputtered HZO can compete with the atomic layer deposited HZO in the BEOL processes. In addition, WOx bottom electrodes enhance the FE capacitor behavior in a broad processing window, which relaxes the manufacturing restrictions.


  • Open Access

    Assessment of Back‐End‐of‐Line Compatibility of Sputtered HfO2‐Based Ferroelectrics

    by Xuetao Wang, Thomas Mikolajick, Matthias Grube

    The thermal compatibility of fully sputtered, ferroelectric TiN/HfxZr(1−x)O2/TiN thin‐film capacitors with back‐end‐of‐line processing is investigated. The sputtering power, ZrO2 concentration, and annealing temperature affect the crystal structure and ferroelectric properties of HfxZr(1−x)O2 (HZO) in different ways, which is revealed by the grazing incidence X‐ray diffraction and electric characterization. Moderate sputtering power and ZrO2 content favor the orthorhombic phase and higher remanent polarization. In contrast, low and high power or low and high ZrO2 concentrations increase the monoclinic and tetragonal/cubic phase fractions, respectively. For the first time, it is shown that annealing at 400 °C for 1 h can result in fully crystalline HZO films deposited by physical vapor deposition. Even pure HfO2 deposited from a 3 in. target with a sputtering power of 50 W exhibits some ferroelectric response after annealing at 400 °C and wakeup cycling.


  • Open Access

    Influence of the Sputtering Technique and Thermal Annealing on YSZ Thin Films for Oxygen Sensing Applications

    by Emilio Paz Alpuche, Pascal Gröger, Xuetao Wang, Thomas Kroyer, Stefanos Fasoulas

    Yttria-stabilized zirconia (YSZ) thin films were deposited using direct current (reactive and metallic) and radio frequency magnetron sputtering. The effect of the deposition technique and annealing treatment on the microstructure and crystallinity of the thin films was assessed. Using the films produced in this work, oxygen gas sensors were built and their performance under vacuum conditions was evaluated. All the films exhibited a cubic crystalline structure after a post-deposition thermal treatment, regardless of the sputtering technique. When the annealing treatment surpassed 1000 °C, impurities were detected on the thin film surface. The oxygen gas sensors employing the reactive and oxide-sputtered YSZ thin films displayed a proportional increase in the sensor current as the oxygen partial pressure was increased in the evaluated pressure range (5 × 10−6 to 2 × 10−3 mbar). The sensors which employed the metallic-deposited YSZ films suffered from electronic conductivity at low partial pressures.