Weiguo Gong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Weiguo Gong has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Yangbing Cao
Zijin School of Geology and Mining, Fuzhou University, Fuzhou 350108, China
3 shared publications Xiangxiang Zhang
Zijin School of Geology and Mining, Fuzhou University, Fuzhou 350108, China
2 shared publicationsZhenping Huang
Zijin School of Geology and Mining, Fuzhou University, Fuzhou 350108, China
2 shared publications- Binglei Li
Zijin School of Geology and Mining, Fuzhou University, Fuzhou, China
1 shared publication - Jianzhi Zhang
Zijin School of Geology and Mining, Fuzhou University, Fuzhou 350108, China
1 shared publication Junxi Chen
Zijin School of Geology and Mining, Fuzhou University, Fuzhou 350116, China
1 shared publication
Latest Publications
- Open Access
Experimental Study on the Influence of Hydromechanical Boundary Conditions on Shear-Flow Coupling Characteristics of Granite Joints
The instability of jointed rock mass is usually the shear process of the rock mass along discontinuities under the influence of groundwater flow. By conducting laboratory tests and numerical experiments on the shear-flow coupling of rock joints under constant normal stiffness (CNS) and constant normal stress (CNL) boundary conditions, the influence of normal boundary conditions and seepage pressure on the shear mechanical and flow characteristics of joints were investigated. The test results were as follows: The joint shear stiffness, peak, and residual shear strength under the CNS boundary condition were predominantly larger than those under the CNL boundary condition. Overall, these parameters were positively correlated with the initial normal stress . When MPa, the postpeak shear stress of the CNS boundary condition showed a sharp decrease, whereas that of the CNL boundary condition changed from a slowly decreasing type ( MPa, 6 MPa) to a sharply decreasing type at MPa. The peak dilation rate under the CNS boundary condition at all levels of normal stress was lower than that of CNL, and the strain softening in postpeak of the latter was more remarkable. In the process of joint shear, the hydraulic aperture displayed a four-stage variation law of “steady-sudden increase-slow increase-basically stable.” Moreover, the hydraulic aperture under the CNS boundary condition was always lower than that under the CNL boundary condition. The seepage pressure increased from 0.5 MPa to 1.5 MPa, and the average hydraulic aperture in the stable stage under normal stress at all levels increased from 0.146 mm to 0.187 mm. In addition, the average peak shear stress and average shear stiffness decreased by 0.9 MPa and 0.83 GPa/m, respectively. We also established a numerical model of a real rough three-dimensional joint, compiled a calculation program for the shear-flow process of a joint under CNS boundary conditions, and visualized the flow channel inside the joint. The seepage flow bypassed the area where the joints contacted each other, forming obvious flow channels. The flow rate increased at the intersection of the flow channels.
Open AccessExperimental Study on the Influence of Hydromechanical Boundary Conditions on Shear-Flow Coupling Characteristics of Granite Joints
The instability of jointed rock mass is usually the shear process of the rock mass along discontinuities under the influence of groundwater flow. By conducting laboratory tests and numerical experiments on the shear-flow coupling of rock joints under constant normal stiffness (CNS) and constant normal stress (CNL) boundary conditions, the influence of normal boundary conditions and seepage pressure on the shear mechanical and flow characteristics of joints were investigated. The test results were as follows: The joint shear stiffness, peak, and residual shear strength under the CNS boundary condition were predominantly larger than those under the CNL boundary condition. Overall, these parameters were positively correlated with the initial normal stress . When MPa, the postpeak shear stress of the CNS boundary condition showed a sharp decrease, whereas that of the CNL boundary condition changed from a slowly decreasing type ( MPa, 6 MPa) to a sharply decreasing type at MPa. The peak dilation rate under the CNS boundary condition at all levels of normal stress was lower than that of CNL, and the strain softening in postpeak of the latter was more remarkable. In the process of joint shear, the hydraulic aperture displayed a four-stage variation law of “steady-sudden increase-slow increase-basically stable.” Moreover, the hydraulic aperture under the CNS boundary condition was always lower than that under the CNL boundary condition. The seepage pressure increased from 0.5 MPa to 1.5 MPa, and the average hydraulic aperture in the stable stage under normal stress at all levels increased from 0.146 mm to 0.187 mm. In addition, the average peak shear stress and average shear stiffness decreased by 0.9 MPa and 0.83 GPa/m, respectively. We also established a numerical model of a real rough three-dimensional joint, compiled a calculation program for the shear-flow process of a joint under CNS boundary conditions, and visualized the flow channel inside the joint. The seepage flow bypassed the area where the joints contacted each other, forming obvious flow channels. The flow rate increased at the intersection of the flow channels.
- Open Access
Damage and Failure Characteristics of Surrounding Rock in Deep Circular Cavern under Cyclic Dynamic Load: A True Triaxial Experiment Investigation
For ensuring safety and efficiency during the construction of deep engineering, it is essential to explore the failure mode of the surrounding rock mass under dynamic disturbance and high geo-stress. We conducted true triaxial load tests for rock-like material with a preexisting circular hole, and monitored the acoustic emission (AE) signal during the whole test. The result demonstrates the evolution characteristics of damage and failure mode with different cyclic dynamic load amplitudes and intermediate principal stress. With the increase in cyclic dynamic load amplitude or the decrease in intermediate principal stress, the failure source mainly occurs at the two horizontal side walls of the surrounding rock where the failure patterns change from the slabbing to wall caving and, finally, to rockburst. The former failure mode can actually serve as an important precursor for the latter. Based on such mechanisms, the precursor can be indirectly detected in forms of AE signal released by microcracking. The research can provide a reliable guidance for the rock stability control and faithfully forecasting the larger-scale failure during the excavation of deep circular cavern.
Open AccessDamage and Failure Characteristics of Surrounding Rock in Deep Circular Cavern under Cyclic Dynamic Load: A True Triaxial Experiment Investigation
For ensuring safety and efficiency during the construction of deep engineering, it is essential to explore the failure mode of the surrounding rock mass under dynamic disturbance and high geo-stress. We conducted true triaxial load tests for rock-like material with a preexisting circular hole, and monitored the acoustic emission (AE) signal during the whole test. The result demonstrates the evolution characteristics of damage and failure mode with different cyclic dynamic load amplitudes and intermediate principal stress. With the increase in cyclic dynamic load amplitude or the decrease in intermediate principal stress, the failure source mainly occurs at the two horizontal side walls of the surrounding rock where the failure patterns change from the slabbing to wall caving and, finally, to rockburst. The former failure mode can actually serve as an important precursor for the latter. Based on such mechanisms, the precursor can be indirectly detected in forms of AE signal released by microcracking. The research can provide a reliable guidance for the rock stability control and faithfully forecasting the larger-scale failure during the excavation of deep circular cavern.
- Open Access
An Estimation Model for Hydraulic Conductivity of Low-Permeability and Unfilled Fractured Granite in Underground Water-Sealed Storage Caverns
The permeability of rock mass is closely related to the stability and safety of underground structure, especially in underground water-sealed storage caverns. With regard to the estimation approaches in predicting the hydraulic conductivity of fractured granite in water-sealed storage caverns, there are some limitations of parameter selection leading to poor applicability. Focusing on the contribution of the water conduction fractures (WCF) to the hydraulic conductivity, we attempted to propose a novel model, the CA model, for estimating its hydraulic conductivity based on the fracture orientation index and the normal stress index by analyzing the borehole wall imaging results and borehole water-pressure test results in the site of underground water-sealed storage caverns. The results indicated that the proposed model is suitable for low-permeability and unfilled fractured granite, exhibiting good effectiveness by clarifying the relation between geomechanical parameters and hydraulic behavior. Further, the parameters upon which the proposed model is based are representative and easy to obtain, which has certain guiding significance and reference value for analyzing the permeability characteristics of similar rock masses.
Open AccessAn Estimation Model for Hydraulic Conductivity of Low-Permeability and Unfilled Fractured Granite in Underground Water-Sealed Storage Caverns
The permeability of rock mass is closely related to the stability and safety of underground structure, especially in underground water-sealed storage caverns. With regard to the estimation approaches in predicting the hydraulic conductivity of fractured granite in water-sealed storage caverns, there are some limitations of parameter selection leading to poor applicability. Focusing on the contribution of the water conduction fractures (WCF) to the hydraulic conductivity, we attempted to propose a novel model, the CA model, for estimating its hydraulic conductivity based on the fracture orientation index and the normal stress index by analyzing the borehole wall imaging results and borehole water-pressure test results in the site of underground water-sealed storage caverns. The results indicated that the proposed model is suitable for low-permeability and unfilled fractured granite, exhibiting good effectiveness by clarifying the relation between geomechanical parameters and hydraulic behavior. Further, the parameters upon which the proposed model is based are representative and easy to obtain, which has certain guiding significance and reference value for analyzing the permeability characteristics of similar rock masses.