DSDaniel R. Strongin

Daniel R. Strongin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Daniel R. Strongin has a total of 129 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Bi 2 Se 3 /Bi 0 Composite Nanoplates as a CO 2 Reduction Electrocatalyst for Formic Acid Production

    by Benjamin Roe, Matas Simukaitis, Liam Wenger, Yugang Sun, Daniel Strongin

    Bismuth metal and its oxides are common catalysts for electrochemical CO 2 reduction (CO 2 R) to HCOOH, although they tend to suffer from lower activity due to poor conductivity. Here we investigated a bismuth selenide catalyst which adopted a spiral‐nanoplate morphology. The catalyst had a mass activity of 31 mA mg −1 for HCOOH at ‐0.9 V RHE, double that of commercial Bi 2 Se 3 powder, nearly ten‐times that of commercial Bi (16 mA mg −1 and 3.8 mA mg −1 respectively), and competitive with other contemporary Bi‐based catalysts. It also possessed greater stability than these counterparts. The higher mass activity of spiral Bi 2 Se 3 occurred alongside a lower charge transfer resistance (78 Ω) than commercially available Bi 2 Se 3 or Bi (314 Ω and 247 Ω respectively). These characteristics of spiral Bi 2 Se 3 were attributed to the presence of a unique Bi 2 Se 3 /Bi 0 heterostructure formed from the depletion of Se from the near‐surface region of the material during electrocatalysis. The lower charge transfer resistance of the Bi 2 Se 3 /Bi 0 heterostructure, relative to Bi and commercial Bi 2 Se 3 , resulted in catalytic sites that were more active for the kinetically complex CO 2 R reaction.

  • Effects of Ir‐Incorporation and Nanostructuring in β‐MnO2 for an Enhanced Electrocatalytic Oxygen Evolution Reaction

    by Uddipana Kakati, Benjamin Roe, Shashiprabha P. Dunuweera, Jose F. Mendez‐Guerra, Daniel R. Strongin

    We investigated the electrocatalytic properties of Ir/β‐MnO2, with 4.2–5.6 atomic % (at %) iridium. The Ir/β‐MnO2 was synthesized by heating Ir/R‐MnO2—formed via a surfactant‐assisted (SA) method using KMnO4, IrCl3.H2O, and sodium dodecyl sulfate (SDS)—to 400 °C. The Ir/β‐MnO2 (SA) was nano‐sized based on scanning and transmission electron microscopy (SEM and TEM). Using linear sweep voltammetry (LSV), 5.6 at % Ir/β‐MnO2 (SA) exhibited an overpotential ( of 327±5 mV for the oxygen evolution reaction (OER), at 10 mA in 0.5 M H2SO4 electrolyte. At 10 mA the Ir/β‐MnO2 (SA) catalyzed the OER for 72 h at an of 534 mV. During this time there was a 12 % loss in Mn and 8 % loss in Ir from the structure. An IrO2 catalyst exhibited an initial η of 420±7 for the OER, but after 20 h of operation at 10 mA there was a steep rise in potential (>550 mV) and 12 % loss in Ir. The enhanced activity and stability of Ir/β‐MnO2 (SA) is attributed to the incorporation of Ir into the MnO2 lattice during synthesis and the formation of nano‐sized particles using the SA method.


  • Iridium Incorporation into MnO2 for an Enhanced Electrocatalytic Oxygen Evolution Reaction

    by Uddipana Kakati, Evert J. Elzinga, Zachary R. Mansley, Benjamin Roe, Farbod Alimohammadi, Gregory Schwenk, Jinliang Ning, Yimei Zhu, Hai‐Feng Ji, Jianwei Sun, et al.

    We have investigated the structure and activity of electrocatalysts for the oxygen evolution reaction (OER) that had low loadings of Ir incorporated into the 2D layered MnO2, (birnessite, nominally δ‐MnO2) and the 3D MnO2 (pyrolusite, β‐MnO2). The Ir‐incorporated β‐MnO2 (Ir/β‐MnO2) electrocatalysts were prepared for the first time via a thermally induced phase transition of δ‐MnO2 containing 16–22 wt% Ir. This phase transition of δ‐MnO2 to β‐MnO2 was facilitated by the presence of Ir in the structure, as both Ir in IrO2 and Mn in β‐MnO2 could adopt a thermodynamically favored rutile structure. Extended X‐ray absorption fine structure (EXAFS) of Ir/β‐MnO2 showed that the catalyst consisted of Ir substituted into the crystalline β‐MnO2 lattice. 22 wt% Ir/β‐MnO2 (60 ) exhibited an OER overpotential ( ) of 337 mV, lower than the for commercial IrO2. This was constant for 6 h, at 10 mA in 0.5 M H2SO4. EXAFS, high‐angle annular dark‐field scanning transmission electron microscopy (HAADF‐STEM) and X‐ray absorption near edge structure (XANES) showed that 22 wt% Ir/β‐MnO2 had a strained structure containing ∼41 % Mn3+, an OER active species, along with a modified Ir bond covalency consisting of both Ir−O−Ir and Ir−O−Mn.


  • Oxidative sorption of arsenite from water by iron: a mechanistic perspective

    by Puthiya Veetil Nidheesh, Govindaraj Divyapriya, Elizabeth B. Cerkez, Ashitha Gopinath, Tuhin Banerji, Daniel R. Strongin

    Removal of arsenite by oxidation and sorption via various iron particles (ZVI, bimetallic particles, iron (oxyhydr)oxides, bi- and tri-metal oxides, structural Fe(ii) hydroxides and ferrate), and their respective removal methodologies are discussed.


  • Open Access

    Layer by Layer Deposition of 1T′‐MoS 2 for the Hydrogen Evolution Reaction

    by Farbod Alimohammadi, Parisa Yasini, Tim Marshall, Nuwan H. Attanayake, Eric Borguet, Daniel R. Strongin

    The layer by layer (LbL) method has been used to assemble catalytic materials for the electrochemical hydrogen evolution reaction (HER). The electrocatalytic activity of LbL deposited 1T′‐MoS 2 (metallic phase) on a fluorine‐doped tin oxide substrate was investigated for the HER as a function of the number of deposition layers (mass loading). The morphology, thickness, and roughness of the deposited MoS 2 layers as a function of the number of deposition layers were investigated using atomic force microscopy and scanning electron microscopy. The average roughness of the surface increased with the number of deposition layers, indicating that the thickness of the deposited layered material became heterogeneous with increasing layer number. The primary conversion of the deposited 1T′‐MoS 2 to the semiconducting 2H‐MoS 2 phase via exposure to 532 nm wavelength light, confirmed by Raman spectroscopy and scanning tunneling spectroscopy, allowed a comparison of the HER activity of the two phases at a constant mass loading and surface area on the same substrate. For a given number of deposition layers (i. e., similar mass loading), 1T′‐MoS 2 exhibited a lower overpotential for the HER than the 2H‐MoS 2 (with a minority 1T′ component) phase. For example, at a sample thickness of 19.7±2.8 nm (20 LbL layers) the overpotentials for the HER for submonolayer amounts of 1T′‐MoS 2 and after exposure to 532 nm light were 0.54 and 0.61 V, respectively (at a current density of −2 mA/cm 2 ). Overall, the overpotential for HER associated with both MoS 2 phases decreased as the mass loading increased.


  • Electrocatalytic CO2 reduction on earth abundant 2D Mo2C and Ti3C2 MXenes

    by Nuwan H. Attanayake, Huta R. Banjade, Akila C. Thenuwara, Babak Anasori, Qimin Yan, Daniel R. Strongin

    The electrocatalytic reduction of CO2 to CO on the Mo2C and Ti3C2 MXenes. DFT calculations show that surface oxygen vacancies are reaction active sites.


  • Open Access

    Cover Feature: Ni‐ and Co‐Substituted Metallic MoS2 for the Alkaline Hydrogen Evolution Reaction (ChemElectroChem 17/2020)

    by Nuwan H. Attanayake, Lakshay Dheer, Akila C. Thenuwara, Sasitha C. Abeyweera, Coby Collins, Umesh V. Waghmare, Daniel R. Strongin


  • Ni‐ and Co‐Substituted Metallic MoS2 for the Alkaline Hydrogen Evolution Reaction

    by Nuwan H. Attanayake, Lakshay Dheer, Akila C. Thenuwara, Sasitha C. Abeyweera, Coby Collins, Umesh V. Waghmare, Daniel R. Strongin

    A metallic MoS2 (M−MoS2) catalyst containing either Ni or Co with excellent activity for the hydrogen evolution reaction (HER) under alkaline electrocatalytic conditions was investigated. To synthesize the 3d transition metal containing electrocatalysts, 1–20 at.% Ni or Co was substituted into the lattice of orthorhombic MoO3 and the doped metal oxide precursor was sulfided and converted to Ni/M−MoS2 or Co/M−MoS2. Raman spectroscopy and photoelectron spectroscopy were used to verify that the Ni or Co substituted MoS2 was the metallic‐like 1T′ phase of the metal dichalcogenide. The 10 at.% Ni/M−MoS2 (10 at.% Co/M−MoS2) electrochemical HER catalyst investigated under alkaline conditions exhibited a low onset potential of ∼−75 mV (∼−100 mV) and overpotential of −145 mV (−160 mV) at a current density of 10 mA/cm2. Pristine M−MoS2 exhibited both a higher onset potential of ∼−150 mV and a higher overpotential of −240 mV at 10 mA/cm2. First‐principles density functional theory analysis showed that substitution of 3d transition metals like Ni and Co in the metallic MoS2 structure notably stabilized the distorted polytype of 1T′−MoS2, lowering the free energy for H binding and H2O dissociation, both important steps in alkaline HER, giving rise to enhanced activity towards HER.


  • Open Access

    Electronic structure effects on catalytic water oxidation activity by layered manganese oxide phases

    by Michael Zdilla, Daniel R Strongin, John P Perdew, Eric Borguet, Michael L Klein, Haowei Peng, Ian G. McKendry, Akila Thenuwara, Richard C Remsing, Laszlo Frazer

  • Open Access

    Electronic structure effects on catalytic water oxidation activity by layered manganese oxide phases

    by Michael Zdilla, Daniel Strongin, John Perdew, Eric Borguet, Michael L Klein, Haowei Peng, Ian McKendry, Akila Thenuwara, Remsing Richard, Laszlo Frazer