DWDi Wang

Di Wang

*This is an algorithmically generated author record based on publicly available information.

Di Wang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Global Buckling Investigation of the Flanged Cruciform H-shapes Columns (FCHCs)

    by Linfeng Lu, Di Wang, Zifan Dai, Tengfei Luo, Songlin Ding, Hanlin Hao

    In China, increasing the application ratio of hot-rolled H-shapes has become a severe problem that the government, academia, and engineering circles must vigorously address. Research on reasonable hot-rolled H-shapes built-up columns is one of the primary methods. After reviewing the various combination columns in the existing research, the paper proposes the new flanged cruciform H-shapes columns (FCHCs) made of three hot-rolled H-shapes. Using comprehensive imperfections given by the design standard, GB50017-2017, the paper analyzes the global buckling of FCHCs subjected to the axial compression load. The global buckling factor obtained is compared with the current national design code. Comparative analysis of seventy-two specimens of Q345 and Q460 steel found that the global buckling mode of FCHCs was flexural bending buckling around the axis of symmetry, and global torsional buckling and local buckling did not occur. Furthermore, the corresponding column curves in current design codes overestimate the dimensionless buckling strength of the novel FCHCs. Therefore, designers need to drop a class to select the global buckling factor within a specific range. Finally, new column global buckling curves are proposed based on a non-linear fitting of the numerical results according to the current national design codes.


  • Open Access

    A Proposal for a Simple Method for Determining the Concrete Slab Width of Composite Beam-to-Column Joints

    by Linfeng Lu, Di Wang, Kai Ding, Hongwei Yan, Hanlin Hao

    Extensive brittle failures in the weld zone of the beam bottom flange in composite joints of SMRFs were observed during the Northridge earthquake and the Kobe earthquake. One of the main reasons is the large tensile strain demand generated at the beam bottom flange zone under positive bending. The key to accurately understanding the mechanical properties of composite joints is the effective width of the slab. However, researchers have no consensus on the flange slab’s effective width for composite joints, even with the simplest solid concrete slab. Therefore, the best way to design the composite joint specimen is by following the current design specifications. However, each specification implements different ideas and approaches for specifying an effective slab width. This paper presents comparisons of the effective flange width provisions in China, the United States, Australia/New Zealand, and the European Union. The characteristics of each provision are briefly described and summarized. Numerical comparisons for positive and negative moment regions of continuous spans follow. Based on the commonalities and main differences among all these provisions, we propose a recommended equation for calculating the effective width of a solid concrete slab, reflecting the specification differences. The reliability of the recommended equation was verified with ABAQUS software analysis. The recommended equation can meet the fast and secure design requirements for composite joints in tests with concrete slabs.