Sebastijan Robič
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sebastijan Robič has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Alisa Machner
Professorship for Mineral Construction Materials, TUM School of Engineering and Design, Technical University Munich, Munich, Germany
1 shared publication - Aljoša Šajna
Zavod Za gradbeništvo (ZAG) Slovenije, Slovenian National Building and Civil Engineering Institute
1 shared publication - Benoît Bary
CEA, DEN, DPC, SECR, Laboratoire d'Etude du Comportement des Bétons et des Argiles, F-91191 Gif-sur-Yvette, France
1 shared publication - Klaartje De Weerdt
Department of Structural Engineering, NTNU, Trondheim, Norway
1 shared publication - Lucija Hanžič
Laboratory for Concrete, Department of Materials, Slovenian National Building and Civil Engineering Institute (ZAG), Dimičeva ulica 12, SI-1000 Ljubljana, Slovenia
1 shared publication - Marie Helene Bjørndal
Institutt for Konstruksjonsteknikk, Norges Teknisk-Naturvitenskaplige Universitet, NTNU, Richard Birkelandsvei 1A, 7491 Trondheim, Norway
1 shared publication
Latest Publications
- Open Access
Experimental Carbonation Study for a Durability Assessment of Novel Cementitious Materials
Durability predictions of concrete structures are derived from experience-based requirements and descriptive exposure classes. To support durability predictions, a numerical model related to the carbonation resistance of concrete was developed. The model couples the rate of carbonation with the drying rate. This paper presents the accelerated carbonation and moisture transport experiments performed to calibrate and verify the numerical model. They were conducted on mortars with a water-cement ratio of either 0.6 or 0.5, incorporating either a novel cement CEM II/C (S-LL) (EnM group) or commercially available CEM II/A-S cement (RefM group). The carbonation rate was determined by visual assessment and thermogravimetric analysis (TGA). Moisture transport experiments, consisting of drying and resaturation, utilized the gravimetric method. Higher carbonation rates expressed in mm/day−0.5 were found in the EnM group than in the RefM group. However, the TGA showed that the initial portlandite (CH) content was lower in the EnM than in the RefM, which could explain the difference in carbonation rates. The resaturation experiments indicate an increase in the suction porosity in the carbonated specimens compared to the non-carbonated specimens. The study concludes that low clinker content causes lower resistance to carbonation, since less CH is available in the surface layers; thus, the carbonation front progresses more rapidly towards the core.
Open AccessExperimental Carbonation Study for a Durability Assessment of Novel Cementitious Materials
Durability predictions of concrete structures are derived from experience-based requirements and descriptive exposure classes. To support durability predictions, a numerical model related to the carbonation resistance of concrete was developed. The model couples the rate of carbonation with the drying rate. This paper presents the accelerated carbonation and moisture transport experiments performed to calibrate and verify the numerical model. They were conducted on mortars with a water-cement ratio of either 0.6 or 0.5, incorporating either a novel cement CEM II/C (S-LL) (EnM group) or commercially available CEM II/A-S cement (RefM group). The carbonation rate was determined by visual assessment and thermogravimetric analysis (TGA). Moisture transport experiments, consisting of drying and resaturation, utilized the gravimetric method. Higher carbonation rates expressed in mm/day−0.5 were found in the EnM group than in the RefM group. However, the TGA showed that the initial portlandite (CH) content was lower in the EnM than in the RefM, which could explain the difference in carbonation rates. The resaturation experiments indicate an increase in the suction porosity in the carbonated specimens compared to the non-carbonated specimens. The study concludes that low clinker content causes lower resistance to carbonation, since less CH is available in the surface layers; thus, the carbonation front progresses more rapidly towards the core.